- 您現在的位置：買賣IC網 > PDF目錄383312 > MAX1200ACMH (MAXIM INTEGRATED PRODUCTS INC) RB Series - Econoline Unregulated DC-DC Converters; Input Voltage (Vdc): 24V; Output Voltage (Vdc): 05V; Power: 1W; Low Cost 1W Converter; Power Sharing on Dual Output Version; Industry Standard Pinout; 1kVDC & 2kVDC Isolation Options; Optional Continuous Short Circuit Protected; UL94V-0 Package Material; Efficiency to 85% PDF資料下載
參數資料
| 型號： | MAX1200ACMH |
| 廠商： | MAXIM INTEGRATED PRODUCTS INC |
| 元件分類： | ADC |
| 英文描述： | RB Series - Econoline Unregulated DC-DC Converters; Input Voltage (Vdc): 24V; Output Voltage (Vdc): 05V; Power: 1W; Low Cost 1W Converter; Power Sharing on Dual Output Version; Industry Standard Pinout; 1kVDC & 2kVDC Isolation Options; Optional Continuous Short Circuit Protected; UL94V-0 Package Material; Efficiency to 85% |
| 中文描述： | 1-CH 16-BIT PROPRIETARY METHOD ADC, PARALLEL ACCESS, PQFP44 |
| 封裝： | M0-108AA-2, MQFP-44 |
| 文件頁數： | 10/16頁 |
| 文件大小： | 204K |
| 代理商： | MAX1200ACMH |
M
+5V S ingle-S upply, 1Msps, 16-Bit
S elf-Calibrating ADC
10
______________________________________________________________________________________
Analog S ignal Conditioning
For single-ended inputs, the negative analog input pin
(INN) is connected to the common-mode voltage pin
(CM) and the positive analog input pin (INP) is connect-
ed to the input.
To take full advantage of the ADC’s superior AC perform-
ance up to the Nyquist frequency, drive the chip with
differential signals. In communication systems the sig-
nals may inherently be available in differential mode;
however medical and/or other applications may only
provide single-ended inputs. In this case, convert the
single-ended signals into differential ones by using the
circuit recommended in Figure 5. Use low-noise, wide-
band amplifiers, such as the MAX4108, to maintain the
signal purity over the full-power bandwidth of the
MAX1200 input.
Lowpass or bandpass signals may be required to
improve the signal-to-noise and distortion of the incom-
ing signal. For low-frequency signals (<100kHz), active
filters may be used. For higher frequencies, passive fil-
ters are more convenient.
S ingle-Ended to Differential
Conversion Using T ransformers
An alternative single-ended to differential-ended con-
version method is a balun transformer such as the
CTX03-13675 from Coiltronics. An important benefit of
these transformers is their ability to level-shift single-
ended signals referred to ground on the primary side to
optimum common-mode voltages on the secondary
side. At frequencies below 20kHz the transformer core
begins to saturate, causing odd-order harmonics.
Cloc k S ourc e Requirements
Pipelined ADCs typically need a 50% duty cycle clock.
To avoid this constraint, the MAX1200 provides a
divide-by-two circuit to relax this requirement. The
clock generator should be chosen commensurate with
the frequency range, amplitude, and slew rate of the
signal source. If the slew rate of the input signal is
small, the jitter requirement on the clock is relaxed.
However, if the slew rate is high, the clock jitter needs
to be kept at a minimum. For a full-scale amplitude
input sine wave, the maximum possible signal-to-noise
ratio (SNR) due completely to clock jitter is given by:
For example, if f
IN
is 500kHz and
σ
J ITTER
is 10ps RMS,
then the SNR limit due to jitter is about 90dB. Generating
such a clock source requires a low-noise comparator and
a low-phase-noise signal generator. The clock circuit
shown in Figure 6 is a possible solution.
SNR
1
2
MAX
IN
f
J ITTER
=
π
σ
MAX4108
INP
INN
CM
V-
V+
IN
CM
V+
V-
MAX4108
Figure 5. A simple circuit generates differential signals from a
single-ended input referred to analog ground. The common-
mode voltage at INP and INN is the same as CM.
MAX961
CLK
V+
V+
0.1
μ
F
0.1
μ
F
0.1
μ
F
1k
1k
CLK_IN
5k
Figure 6. Clock Generation Circuit Using Low-Noise Comparator
相關PDF資料 |
PDF描述 |
|---|---|
| MAX1200BEMH | CANMS3120E20-41PF0 |
| MAX1201 | Scan Test Devices With 18-Bit Bus Transceivers 56-TSSOP -40 to 85 |
| MAX1201CMH | +5v sINGLE-sUPPLY, 2.2mSPS, 14-bIT sELF-cALIBRATING adc |
| MAX1201EMH | Scan Test Devices With 18-Bit Bus Transceivers 56-TSSOP -40 to 85 |
| MAX1202 | Scan Test Devices With 18-Bit Bus Transceivers 56-SSOP -40 to 85 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MAX1200ACMH-T | 功能描述:模數轉換器 - ADC RoHS:否 制造商:Texas Instruments 通道數量:2 結構:Sigma-Delta 轉換速率:125 SPs to 8 KSPs 分辨率:24 bit 輸入類型:Differential 信噪比:107 dB 接口類型:SPI 工作電源電壓:1.7 V to 3.6 V, 2.7 V to 5.25 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-32 |
| MAX1200BCMH | 制造商:Rochester Electronics LLC 功能描述: 制造商:Maxim Integrated Products 功能描述: |
| MAX1200EVKIT-MQFP | 功能描述:數據轉換 IC 開發工具 Evaluation Kit for the MAX1200 MAX1201 MAX1205 RoHS:否 制造商:Texas Instruments 產品:Demonstration Kits 類型:ADC 工具用于評估:ADS130E08 接口類型:SPI 工作電源電壓:- 6 V to + 6 V |
| MAX1201 | 制造商:Technical Pro 功能描述:Passive Two Way Molded ABS 12" PA/DJ Speaker - 1000W Max 制造商:TECHNICAL PRO 功能描述:DWO PA/DJ PROFESSIONAL SPEAKERTWO WAY 12 INCH 1000W MAX |
| MAX1202ACAP | 功能描述:模數轉換器 - ADC Integrated Circuits (ICs) RoHS:否 制造商:Texas Instruments 通道數量:2 結構:Sigma-Delta 轉換速率:125 SPs to 8 KSPs 分辨率:24 bit 輸入類型:Differential 信噪比:107 dB 接口類型:SPI 工作電源電壓:1.7 V to 3.6 V, 2.7 V to 5.25 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-32 |
發布緊急采購，3分鐘左右您將得到回復。