- 您現在的位置：買賣IC網 > PDF目錄2085 > MAX1083AEUE+ (Maxim Integrated Products)IC ADC 10BIT 300KSPS 16-TSSOP PDF資料下載
參數資料
| 型號： | MAX1083AEUE+ |
| 廠商： | Maxim Integrated Products |
| 文件頁數： | 7/23頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC ADC 10BIT 300KSPS 16-TSSOP |
| 產品培訓模塊： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 標準包裝： | 96 |
| 位數： | 10 |
| 采樣率（每秒）： | 300k |
| 數據接口： | MICROWIRE?，QSPI?，串行，SPI? |
| 轉換器數目： | 1 |
| 功率耗散（最大）： | 533mW |
| 電壓電源： | 單電源 |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 16-TSSOP（0.173"，4.40mm 寬） |
| 供應商設備封裝： | 16-TSSOP |
| 包裝： | 管件 |
| 輸入數目和類型： | 4 個單端，單極；4 個單端，雙極；2 個差分，單極；2 個差分，雙極 |
第1頁第2頁第3頁第4頁第5頁第6頁當前第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁
MAX1082/MAX1083
300ksps/400ksps, Single-Supply, 4-Channel,
Serial 10-Bit ADCs with Internal Reference
15
Maxim Integrated
Software Power-Down
Software power-down is activated using bits PD1 and
PD0 of the control byte. When software power-down is
asserted, the ADC completes the conversion in
progress and powers down into the specified low-qui-
escent-current state (2A, 0.9mA, or 1.3mA).
The first logic 1 on DIN is interpreted as a start bit and
puts the MAX1082/MAX1083 into its full-power mode.
Following the start bit, the data input word or control
byte also determines the next power-down state. For
example, if the DIN word contains PD1 = 0 and PD0 = 1, a
0.9mA power-down resumes after one conversion.
Table 4 details the four power modes with the corre-
sponding supply current and operating sections.
Hardware Power-Down
Pulling SHDN low places the converter in hardware
power-down. Unlike software power-down mode, the
conversion is not completed; it stops coincidentally with
SHDN being brought low. When returning to normal
operation—from SHDN, with an external reference—the
MAX1082/MAX1083 can be considered fully powered
up within 2s of actively pulling SHDN high. When
using the internal reference, the conversion should be
initiated only when the reference has settled; its recov-
ery time is dependent on the external bypass capaci-
tors and the time between conversions.
Power-Down Sequencing
The MAX1082/MAX1083 auto power-down modes can
save considerable power when operating at less than
maximum sample rates. Figures 9 and 10 show the
average supply current as a function of the sampling
rate. The following sections discuss the various power-
down sequences. Other combinations of clock rates
and power-down modes may attain the lowest power
consumption in other applications.
Using Full Power-Down Mode
Full power-down mode (FULLPD) achieves the lowest
power consumption, up to 1000 conversions per chan-
nel per second. Figure 9a shows the MAX1083’s power
consumption for one- or four-channel conversions utiliz-
ing full power-down mode (PD1 = PD0 = 0), with the
internal reference and conversion controlled at the
maximum clock speed. A 0.01F bypass capacitor at
REFADJ forms an RC filter with the internal 17k
refer-
ence resistor, with a 170s time constant. To achieve
full 10-bit accuracy, seven time constants or 1.2ms are
required after power-up if the bypass capacitor is fully
discharged between conversions. Waiting this 1.2ms
duration in fast power-down (FASTPD) or reduced-
power (REDP) mode instead of in full power-up can fur-
ther reduce power consumption. This is achieved by
using the sequence shown in Figure 11a.
Figure 9b shows the MAX1083’s power consumption for
one- or four-channel conversions utilizing FULLPD
400ns
(CLK = 6.4MHz)
IDLE
CS
SCLK
DIN
SSTRB
DOUT
A/D STATE
tACQ
IDLE
CONVERSION
RB3
RB2
RB1
SEL
2
1
START
4
8
9
1216
2024
SEL
1
SEL
0
UNI/
BIP
SGL/
DIF
PD2 PD2
B9 B8
B7
B6 B5
B4
B3
B2
B1 B0
S1
S0
Figure 5. Single-Conversion Timing
相關PDF資料 |
PDF描述 |
|---|---|
| MAX1088ETA+T | IC ADC 10BIT 150KSPS 8-TDFN |
| MAX1090AEEI+ | IC ADC 10BIT 400KSPS 28-QSOP |
| MAX1106EUB+T | IC ADC 8BIT LP 10-UMAX |
| MAX1108EUB+TG07 | IC ADC 8BIT SPI/SRL 50K 10UMAX |
| MAX110AEWE+ | IC ADC 14BIT 2CH 16-SOIC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MAX1083AEUE+ | 功能描述:模數轉換器 - ADC 300/400ksps Sgl-Sply 4Ch Serial 10Bit RoHS:否 制造商:Texas Instruments 通道數量:2 結構:Sigma-Delta 轉換速率:125 SPs to 8 KSPs 分辨率:24 bit 輸入類型:Differential 信噪比:107 dB 接口類型:SPI 工作電源電壓:1.7 V to 3.6 V, 2.7 V to 5.25 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-32 |
| MAX1083AEUE+T | 功能描述:模數轉換器 - ADC 300/400ksps Sgl-Sply 4Ch Serial 10Bit RoHS:否 制造商:Texas Instruments 通道數量:2 結構:Sigma-Delta 轉換速率:125 SPs to 8 KSPs 分辨率:24 bit 輸入類型:Differential 信噪比:107 dB 接口類型:SPI 工作電源電壓:1.7 V to 3.6 V, 2.7 V to 5.25 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-32 |
| MAX1083AEUE-T | 功能描述:模數轉換器 - ADC RoHS:否 制造商:Texas Instruments 通道數量:2 結構:Sigma-Delta 轉換速率:125 SPs to 8 KSPs 分辨率:24 bit 輸入類型:Differential 信噪比:107 dB 接口類型:SPI 工作電源電壓:1.7 V to 3.6 V, 2.7 V to 5.25 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-32 |
| MAX1083BCUE | 功能描述:模數轉換器 - ADC RoHS:否 制造商:Texas Instruments 通道數量:2 結構:Sigma-Delta 轉換速率:125 SPs to 8 KSPs 分辨率:24 bit 輸入類型:Differential 信噪比:107 dB 接口類型:SPI 工作電源電壓:1.7 V to 3.6 V, 2.7 V to 5.25 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-32 |
| MAX1083BCUE+ | 功能描述:模數轉換器 - ADC 300/400ksps Sgl-Sply 4Ch Serial 10Bit RoHS:否 制造商:Texas Instruments 通道數量:2 結構:Sigma-Delta 轉換速率:125 SPs to 8 KSPs 分辨率:24 bit 輸入類型:Differential 信噪比:107 dB 接口類型:SPI 工作電源電壓:1.7 V to 3.6 V, 2.7 V to 5.25 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-32 |
發布緊急采購，3分鐘左右您將得到回復。