- 您現在的位置：買賣IC網 > PDF目錄45050 > M41T93RQA6F (STMICROELECTRONICS) 1 TIMER(S), REAL TIME CLOCK, PQCC16 PDF資料下載
參數資料
| 型號： | M41T93RQA6F |
| 廠商： | STMICROELECTRONICS |
| 元件分類： | 時鐘/數據恢復及定時提取 |
| 英文描述： | 1 TIMER(S), REAL TIME CLOCK, PQCC16 |
| 封裝： | 4 X 4 MM, ROHS COMPLIANT, QFN-16 |
| 文件頁數： | 22/49頁 |
| 文件大?。?/td> | 719K |
| 代理商： | M41T93RQA6F |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁當前第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁
M41T93
Clock operation
Doc ID 12615 Rev 5
3.8.1
TI/TP
●
TI/TP = 0
IRQ/FT/OUT is active when TF is logic '1' (subject to the status of the timer interrupt
enable bit (TIE).
●
TI/TP = 1
IRQ/FT/OUT pulses active according to Table 8 (subject to the status of the TIE bit).
Note:
If an alarm condition, watchdog time-out, oscillator failure, or OUT = 0 cause IRQ/FT/OUT to
be asserted low, then IRQ/FT/OUT will remain asserted even if TI/TP is set to '1.' When in
pulse mode (TI/TP = 1), clearing the TF bit will not stop the pulses on IRQ/FT/OUT. The
output pulses will only stop if TE, TIE, or TI/TP are reset to '0.'
3.8.2
TF
At the end of a timer countdown, TF is set to logic '1.' If both timer and alarm interrupts are
required in the application, the source of the interrupt can be determined by reading the flag
bits. The timer will auto-reload and continue to count down regardless of the state of TF bit
(or TI/TP bit). The TF bit is cleared by reading the flags register.
3.8.3
TIE
In level mode (TI/TP = 0), when TF is asserted, the interrupt is asserted (if TIE = 1). To clear
the interrupt, the TF bit or the TIE bit must be reset.
3.8.4
TE
●
TE = 0
When the timer register (10h) is set to ‘0,’ the timer is disabled.
●
TE = 1
The timer is enabled. TE is reset (disabled) on power-down. When re-enabled, the
counter will begin from the same value as when it was disabled.
Table 8.
Interrupt operation (bit TI/TP = 1)
Source clock (Hz)
IRQ(1) period(s)
1.
TF and IRQ/FT/OUT become active simultaneously.
n(2) = 1
2.
n = loaded countdown timer value. The timer is stopped when n = 0.
n > 1
4096
1/8192
1/4096
64
1/128
1/64
1
1/64
1/60
1/64
相關PDF資料 |
PDF描述 |
|---|---|
| M41T93SQA6F | 1 TIMER(S), REAL TIME CLOCK, PQCC16 |
| M43C505-XXX-DIT | 4-BIT, MROM, 2 MHz, MICROCONTROLLER, UUC |
| M43C505-XXX-Q44 | 4-BIT, MROM, 2 MHz, MICROCONTROLLER, PQCC44 |
| M44C090-XXX-FL16 | 8-BIT, MROM, 16 MHz, MICROCONTROLLER, PDSO16 |
| M44C090-XXX-DIT | 4-BIT, MROM, 4 MHz, MICROCONTROLLER, UUC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| M41T93RQA6F-CUT TAPE | 制造商:ST 功能描述:M41T93 Series 5.5 V Serial SPI Bus RTC With Battery Switchover -QFN-16 |
| M41T93SMY6E | 功能描述:實時時鐘 Serial SPI bus RTC RoHS:否 制造商:Microchip Technology 功能:Clock, Calendar. Alarm RTC 總線接口:I2C 日期格式:DW:DM:M:Y 時間格式:HH:MM:SS RTC 存儲容量:64 B 電源電壓-最大:5.5 V 電源電壓-最小:1.8 V 最大工作溫度:+ 85 C 最小工作溫度: 安裝風格:Through Hole 封裝 / 箱體:PDIP-8 封裝:Tube |
| M41T93SMY6F | 功能描述:實時時鐘 Serial SPI bus RTC RoHS:否 制造商:Microchip Technology 功能:Clock, Calendar. Alarm RTC 總線接口:I2C 日期格式:DW:DM:M:Y 時間格式:HH:MM:SS RTC 存儲容量:64 B 電源電壓-最大:5.5 V 電源電壓-最小:1.8 V 最大工作溫度:+ 85 C 最小工作溫度: 安裝風格:Through Hole 封裝 / 箱體:PDIP-8 封裝:Tube |
| M41T93SQA6E | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:Serial SPI bus RTC with battery switchover |
| M41T93SQA6F | 功能描述:實時時鐘 Serial SPI bus RTC RoHS:否 制造商:Microchip Technology 功能:Clock, Calendar. Alarm RTC 總線接口:I2C 日期格式:DW:DM:M:Y 時間格式:HH:MM:SS RTC 存儲容量:64 B 電源電壓-最大:5.5 V 電源電壓-最小:1.8 V 最大工作溫度:+ 85 C 最小工作溫度: 安裝風格:Through Hole 封裝 / 箱體:PDIP-8 封裝:Tube |
發布緊急采購，3分鐘左右您將得到回復。