參數資料
型號: M38C29MC-XXXHP
元件分類: 微控制器/微處理器
英文描述: 8-BIT, MROM, 4 MHz, MICROCONTROLLER, PQFP64
封裝: 10 X 10 MM, 0.50 MM PITCH, PLASTIC, LQFP-64
文件頁數: 28/91頁
文件大小: 1867K
代理商: M38C29MC-XXXHP
33
38C2 Group
SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER
MITSUBISHI MICROCOMPUTERS
PRELIMINAR
Y
Notice:
This
is not
a final
specification.
Some
parametric
limits
are
subject
to change.
[Transmit Buffer Register/Receive Buffer Reg-
ister (TB/RB)]
The transmit buffer register and the receive buffer register are lo-
cated at the same address. The transmit buffer is write-only and the
receive buffer is read-only. If a character bit length is 7 bits, the MSB
of data stored in the receive buffer is “0”.
[Serial I/O Status Register (SIO1STS, SIO2STS)]
The read-only serial I/O status register consists of seven flags (bits 0
to 6) which indicate the operating status of the serial I/O function and
various errors.
Three of the flags (bits 4 to 6) are valid only in UART mode.
The receive buffer full flag (bit 1) is cleared to “0” when the receive
buffer register is read.
If there is an error, it is detected at the same time that data is trans-
ferred from the receive shift register to the receive buffer register,
and the receive buffer full flag is set. A write to the serial I/O status
register clears all the error flags OE, PE, FE, and SE (bit 3 to bit 6,
respectively). Writing “0” to the serial I/O enable bit SIOE (bit 7 of the
serial I/O control register) also clears all the status flags, including
the error flags.
All bits of the serial I/O status register are initialized to “0” at reset,
but if the transmit enable bit (bit 4) of the serial I/O control register
has been set to “1”, the transmit shift completion flag (bit 2) and the
transmit buffer empty flag (bit 0) become “1”.
[Serial I/O Control Register (SIO1CON, SIO2CON)]
The serial I/O control register consists of eight control bits for the
serial I/O function.
[UART Control Register (UART1CON, UART2CON)]
The UART control register consists of four control bits (bits 0 to 3)
which are valid when asynchronous serial I/O is selected and set the
data format of an data transfer and one bit (bit 4) which is always
valid and sets the output structure of the P55/TXD1 [P32/TxD2] pin.
[Baud Rate Generator (BRG1, BRG2)]
The baud rate generator determines the baud rate for serial transfer.
The baud rate generator divides the frequency of the count source
by 1/(n + 1), where n is the value written to the baud rate generator.
相關PDF資料
PDF描述
M38C24M6-XXXFP 8-BIT, MROM, 4 MHz, MICROCONTROLLER, PQFP64
M38C24M4-XXXHP 8-BIT, MROM, 4 MHz, MICROCONTROLLER, PQFP64
M38C24M4-XXXFP 8-BIT, MROM, 4 MHz, MICROCONTROLLER, PQFP64
M38C29MC-XXXFP 8-BIT, MROM, 4 MHz, MICROCONTROLLER, PQFP64
M38C29MC-XXXFP 8-BIT, MROM, 4 MHz, MICROCONTROLLER, PQFP64
相關代理商/技術參數
參數描述
M38C29RLFS 功能描述:EMULATOR MCU FOR A-VERSION 38C2 RoHS:否 類別:編程器,開發系統 >> 內電路編程器、仿真器以及調試器 系列:- 產品變化通告:Development Systems Discontinuation 19/Jul/2010 標準包裝:1 系列:* 類型:* 適用于相關產品:* 所含物品:*
M38C29T-64FPD 功能描述:DEV 100-PIN RFS/MCU TO 64-PIN 0. RoHS:否 類別:編程器,開發系統 >> 配件 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program RoHS指令信息:IButton RoHS Compliance Plan 標準包裝:1 系列:- 附件類型:USB 至 1-Wire? RJ11 適配器 適用于相關產品:1-Wire? 設備 產品目錄頁面:1429 (CN2011-ZH PDF)
M38C29T-64LCA 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:Converter from 100-pin RFS Type Emulator MCU to 64-pin 0.8mm-pitch QFP (for 38C1, 38C2, 38K0 and 38K2 Group of 38000 Series)
M38C29T-ADF 功能描述:DEV TEMPORARY TARGET BOARD FOR M RoHS:否 類別:編程器,開發系統 >> 配件 系列:- 標準包裝:1 系列:- 附件類型:適配器板 適用于相關產品:RCB230,RCB231,RCB212 配用:26790D-ND - RCB BREAKOUT BOARD RS232 CABLE
M38C2XMX 制造商:MITSUBISHI 制造商全稱:Mitsubishi Electric Semiconductor 功能描述:SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER