- 您現在的位置：買賣IC網 > PDF目錄45040 > M38049FFHP 8-BIT, FLASH, 16.8 MHz, MICROCONTROLLER, PQFP64 PDF資料下載
參數資料
| 型號： | M38049FFHP |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | 8-BIT, FLASH, 16.8 MHz, MICROCONTROLLER, PQFP64 |
| 封裝： | 10 X 10 MM, 0.50 MM PITCH, PLASTIC, LQFP-64 |
| 文件頁數： | 128/136頁 |
| 文件大?。?/td> | 2007K |
| 代理商： | M38049FFHP |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁當前第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁
91
3803/3804 Group
SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER
MITSUBISHI MICROCOMPUTERS
FLASH MEMORY MODE
The 3803/3804 group has the flash memory mode in addition to
the normal operation mode (microcomputer mode). The user can
use this mode to perform read, program, and erase operations for
the internal flash memory.
The 3803/3804 group has three modes the user can choose: the
parallel input/output and serial input/output mode, where the flash
memory is handled by using the external programmer, and the
CPU reprogramming mode, where the flash memory is handled by
the central processing unit (CPU). The following explains these
modes.
(1) Flash memory mode 1 (parallel I/O mode)
The parallel I/O mode can be selected by connecting wires as
shown in Figures 86, 87 and supplying power to the VCC and VPP
pins. In this mode, the M38039FF/M38049FF operates as an
equivalent of MITSUBISHI’s CMOS flash memory M5M28F101.
However, because the M38039FF/M38049FF’s internal memory
has a capacity of 60 Kbytes, programming is available for ad-
dresses 0100016 to 0FFFF16, and make sure that the data in
addresses 0000016 to 00FFF16 and addresses 1000016 to
1FFFF16 are FF16. Note also that the M38039FF/M38049FF does
not contain a facility to read out a device identification code by ap-
plying a high voltage to address input (A9). Be careful not to
erratically set program conditions when using a general-purpose
PROM programmer.
Table 16 shows the pin assignments when operating in the paral-
lel input/output mode.
Table 16 Pin assignments of M38039FF/M38049FF when
operating in the parallel input/output mode
VCC
VPP
VSS
Address input
Data I/O
__
CE
___
OE
___
WE
M38039FF/M38049FF
VCC
CNVSS
VSS
Ports P0, P1, P31
Port P2
P36
P37
P33
M5M28F101
VCC
VPP
VSS
A0–A16
D0–D7
__
CE
__
OE
___
WE
Functional Outline (parallel input/output mode)
In the parallel input/output mode, the 3803/3804 group allow the
user to choose an operation mode between the read-only mode
and the read/write mode (software command control mode) de-
pending on the voltage applied to the VPP pin. When VPP = VPPL,
the read-only mode is selected, and the user can choose one of
three states (e.g., read, output disable, or standby) depending on
___ ___
___
inputs to the CE, OE, and WE pins. When VPP = VPPH, the read/
write mode is selected, and the user can choose one of four states
(e.g., read, output disable, standby, or write) depending on inputs
__
___
to the CE, OE, and WE pins. Table 17 shows assignment states of
control input and each state.
q Read
__
The microcomputer enters the read state by driving the CE, and
__
___
OE pins low and the WE pin high; and the contents of memory
corresponding to the address to be input to address input pins
(A0–A16) are output to the data input/output pins (D0–D7).
q Output disable
The microcomputer enters the output disable state by driving the
__
___
__
CE pin low and the WE and OE pins high; and the data input/out-
put pins enter the floating state.
q Standby
__
The microcomputer enters the standby state by driving the CE pin
high. the 3803/3804 group is placed in a power-down state con-
suming only a minimum supply current. At this time, the data input/
output pins enter the floating state.
q Write
The microcomputer enters the write state by driving the VPP pin
___
__
high (VPP = VPPH) and then the WE pin low when the CE pin is
__
low and the OE pin is high. In this state, software commands can
be input from the data input/output pins, and the user can choose
program or erase operation depending on the contents of this soft-
ware command.
Pin
Mode
Read
Output disable
Standby
Read
Output disable
Standby
Write
Read-only
Read/Write
__
CE
VIL
VIH
VIL
VIH
VIL
VIH
×
VIL
VIH
×
VIH
Table 17 Assignment states of control input and each state
__
OE
___
WE
VIH
×
VIH
×
VIL
VPPL
VPPH
VPP
Output
Floating
Output
Floating
Input
Data I/O
Note:
× can be VIL or VIH.
State
相關PDF資料 |
PDF描述 |
|---|---|
| M38039MF-XXXHP | 8-BIT, MROM, 16.8 MHz, MICROCONTROLLER, PQFP64 |
| M38037M6H-XXXHP | 8-BIT, MROM, 8.4 MHz, MICROCONTROLLER, PQFP64 |
| M38037M8H-XXXSP | 8-BIT, MROM, 8.4 MHz, MICROCONTROLLER, PDIP64 |
| M38039FFHKP | 8-BIT, FLASH, 8.4 MHz, MICROCONTROLLER, PQFP64 |
| M38039MCH-XXXKP | 8-BIT, MROM, 8.4 MHz, MICROCONTROLLER, PQFP64 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| M38049FFLHP#U0 | 制造商:Renesas Electronics Corporation 功能描述: |
| M38049RLSS | 功能描述:DEV EMULATOR CHIP RAM 2KB 64SDIP RoHS:否 類別:編程器，開發系統 >> 內電路編程器、仿真器以及調試器 系列:- 產品變化通告:Development Systems Discontinuation 19/Jul/2010 標準包裝:1 系列:* 類型:* 適用于相關產品:* 所含物品:* |
| M3806 | 功能描述:電纜固定件和配件 LTSCG 625 BLACK RoHS:否 制造商:Heyco 類型:Cable Grips, Liquid Tight 材料:Nylon 顏色:Black 安裝方法:Cable 最大光束直徑:11.4 mm 抗拉強度: |
| M3806 BK001 | 制造商:Alpha Wire Company 功能描述:CBL 8COND 18AWG BLK 1000' |
| M3806 BK002 | 制造商:Alpha Wire Company 功能描述:CBL 8COND 18AWG BLK 500' |
發布緊急采購，3分鐘左右您將得到回復。