參數資料
型號: M37221EFSP
元件分類: 微控制器/微處理器
英文描述: 8-BIT, OTPROM, 8 MHz, MICROCONTROLLER, PDIP42
封裝: 0.600 INCH, 1.778 MM PITCH, SHRINK, PLASTIC, DIP-42
文件頁數: 50/63頁
文件大?。?/td> 1371K
代理商: M37221EFSP
M37221EF-XXXSP,M37221EFSP
MITSUBISHI MICROCOMPUTERS
SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER for VOLTAGE SYNTHESIZER
with ON-SCREEN DISPLAY CONTROLLER
54
Interrupt request
Interrupt disable
flag I
Reset
SQ
R
STP instruction
SQ
R
WIT
instruction
S
Q
R
STP
instruction
Reset
Internal clock
1/2
1/8
Timer 3
Timer 4
XOUT
XIN
T34M0
T34M2
Selection gate :
Connected to black
colored side at reset.
T34M : Timer 34 mode
register
CLOCK GENERATING CIRCUIT
The built-in clock generating circuit is shown in Figure 62. When the
STP instruction is executed, the internal clock
stops at “H” level.
At the same time, timers 3 and 4 are connected in hardware and
“FF16” is set in the timer 3, “0716” is set in the timer 4. Select f(XIN)/16
as the timer 3 count source (set bit 0 of the timer 34 mode register to
“0” before the execution of the STP instruction). And besides, set the
timer 3 and timer 4 interrupt enable bits to disabled (“0”) before ex-
ecution of the STP instruction). The oscillator restarts when external
interrupt is accepted, however, the internal clock
keeps its “H” level
until timer 4 overflows. Because this allows time for oscillation stabi-
lizing when a ceramic resonator or a quartz-crystal oscillator is used.
When the WIT instruction is executed, the internal clock
stops in
the “H” level but the oscillator continues running. This wait state is
released when an interrupt is accepted (Note). Since the oscillator
does not stop, the next instruction can be executed at once.
When returning from the stop or the wait state, to accept an interrupt,
set the corresponding interrupt enable bit to “1” before executing the
STP or the WIT instructions.
Note: In the wait mode, the following interrupts are invalid.
(1) VSYNC interrupt
(2) CRT interrupt
(3) f(XIN)/4096 interrupt
(4) Timer 1 interrupt using f(XIN)/4096 as count source
(5) Timer 2 interrupt using P24/TIM2 pin input as count source
(6) Timer 3 interrupt using P23/TIM3 pin input as count source
(7) Timer 4 interrupt using f(XIN)/2 as count source
(8) Multi-master I2C-BUS interface interrupt
The circuit example using a ceramic resonator (or a quartz-crystal
oscillator) is shown in Figure 60. Use the circuit constants in accor-
dance with the resonator manufacture’s recommended values. The
circuit example with external clock input is shown in Figure 61. Input
the clock to the XIN pin, and open the XOUT pin.
Fig. 62. Clock generating circuit block diagram
Fig. 61. External clock input circuit example
Fig. 60. Ceramic resonator circuit example
XIN
XOU T
C IN
M 37221EF-XXXSP
C OU T
20
19
XIN
M37221EF-XXXSP
19
Vcc
Vss
External oscillation circuit
相關PDF資料
PDF描述
M37221M6-XXXFP 8-BIT, MROM, 8.1 MHz, MICROCONTROLLER, PDSO42
M37221M6-XXXSP 8-BIT, MROM, 8.1 MHz, MICROCONTROLLER, PDIP42
M37221M6H-XXXFP 8-BIT, MROM, 8.1 MHz, MICROCONTROLLER, PDSO42
M37221EASP 8-BIT, OTPROM, 8.1 MHz, MICROCONTROLLER, PDIP42
M37221M4H-XXXSP 8-BIT, MROM, 8.1 MHz, MICROCONTROLLER, PDIP42
相關代理商/技術參數
參數描述
M37221FP 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER for VOLTAGE SYNTHESIZER with ON-SCREEN DISPLAY CONTROLLER
M37221M4H 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER for VOLTAGE SYNTHESIZER with ON-SCREEN DISPLAY CONTROLLER
M37221M4H-XXXFP 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER for VOLTAGE SYNTHESIZER with ON-SCREEN DISPLAY CONTROLLER
M37221M4H-XXXSP 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER for VOLTAGE SYNTHESIZER with ON-SCREEN DISPLAY CONTROLLER
M37221M6 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER for VOLTAGE SYNTHESIZER with ON-SCREEN DISPLAY CONTROLLER