參數資料
型號: M34556M8-XXXFP
元件分類: 微控制器/微處理器
英文描述: 4-BIT, MROM, 6 MHz, MICROCONTROLLER, PDSO42
封裝: 0.450 INCH, 0.80 MM PITCH, PLASTIC, SSOP-42
文件頁數: 114/147頁
文件大?。?/td> 1087K
代理商: M34556M8-XXXFP
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁當前第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁第145頁第146頁第147頁
Rev.3.02
Dec 22, 2006
page 67 of 142
REJ03B0025-0302
4556 Group
POF and POF2 instructions
When the POF or POF2 instruction is executed continuously af-
ter the EPOF instruction, system enters the power down state.
Note that system cannot enter the power down state when ex-
ecuting only the POF or POF2 instruction.
Be sure to disable interrupts by executing the DI instruction be-
fore executing the EPOF instruction and the POF or POF2
instruction continuously.
Power-on reset
When the built-in power-on reset circuit is used, set the time for
the supply voltage to rise from 0 V to the minimum voltage of rec-
ommended operating conditions to 100
s or less.
If the rising time exceeds 100
s, connect a capacitor between
the RESET pin and VSS at the shortest distance, and input “L”
level to RESET pin until the value of supply voltage reaches the
minimum operating voltage.
Voltage drop detection circuit (only in H version)
The voltage drop detection circuit detection voltage of this prod-
uct is set up lower than the minimum value of the supply voltage
of the recommended operating conditions.
When the supply voltage of a microcomputer falls below to the
minimum value of recommended operating conditions and re-
goes up (ex. battery exchange of an application product),
depending on the capacity value of the bypass capacitor added
to the power supply pin, the following case may cause program
failure (Figure 67);
supply voltage does not fall below to VRST-, and
its voltage re-goes up with no reset.
In such a case, please design a system which supply voltage is
once reduced below to VRST- and re-goes up after that.
19
20
21
Clock control
Execute the CRCK instruction in the initial setting routine of pro-
gram (executing it in address 0 in page 0 is recommended).
The oscillation circuit by the CRCK instruction can be selected
only once.
On-chip oscillator
The clock frequency of the on-chip oscillator depends on the sup-
ply voltage and the operation temperature range.
Be careful that variable frequencies when designing application
products.
Also, the oscillation stabilize wait time after system is released
from reset is generated by the on-chip oscillator clock. When
considering the oscillation stabilize wait time after system is re-
leased from reset, be careful that the variable frequency of the
on-chip oscillator clock.
External clock
When the external signal clock is used as the source oscillation
(f(XIN)), note that the power down mode (POF and POF2 instruc-
tions) cannot be used.
Difference between Mask ROM version and One Time PROM version
Mask ROM version and One Time PROM version have some dif-
ference of the following characteristics within the limits of an
electrical property by difference of a manufacture process, built-
in ROM, and a layout pattern.
a characteristic value
a margin of operation
the amount of noise-proof
noise radiation, etc.,
Accordingly, be careful of them when swithcing.
26
Note on Power Source Voltage
When the power source voltage value of a microcomputer is less
than the value which is indicated as the recommended operating
conditions, the microcomputer does not operate normally and
may perform unstable operation.
In a system where the power source voltage drops slowly when
the power source voltage drops or the power supply is turned off,
reset a microcomputer when the supply voltage is less than the
recommended operating conditions and design a system not to
cause errors to the system by this unstable operation.
23
24
25
VDD
Recommended
operatng condition
min.value
No reset
Program failure may occur.
VRST
+
VRST
VDD
Recommended
operatng condition
min.value
VRST
+
VRST
→ Normal operation
Reset
Fig. 67 VDD and VRST–
22
相關PDF資料
PDF描述
M34556M8H-XXXFP 4-BIT, MROM, 6 MHz, MICROCONTROLLER, PDSO42
M34556M4H-XXXFP 4-BIT, MROM, 6 MHz, MICROCONTROLLER, PDSO42
M34559G6FP 4-BIT, MROM, 6 MHz, MICROCONTROLLER, PQFP52
M34559G6-XXXFP 4-BIT, MROM, 6 MHz, MICROCONTROLLER, PQFP52
M34570EDFP 4-BIT, OTPROM, 2 MHz, MICROCONTROLLER, PDSO36
相關代理商/技術參數
參數描述
M34556MXH-XXXFP 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SINGLE-CHIP 4-BIT CMOS MICROCOMPUTER
M34556MX-XXXFP 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SINGLE-CHIP 4-BIT CMOS MICROCOMPUTER
M34559G6 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SINGLE-CHIP 4-BIT CMOS MICROCOMPUTER
M34559G6FP 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SINGLE-CHIP 4-BIT CMOS MICROCOMPUTER
M34559G6-XXXFP 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SINGLE-CHIP 4-BIT CMOS MICROCOMPUTER