- 您現在的位置：買賣IC網 > PDF目錄98004 > M30100M6-XXXFP 16-BIT, MROM, 16 MHz, MICROCONTROLLER, PQFP32 PDF資料下載
參數資料
| 型號： | M30100M6-XXXFP |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | 16-BIT, MROM, 16 MHz, MICROCONTROLLER, PQFP32 |
| 封裝： | 7 X 7 MM, 0.80 MM PITCH, PLASTIC, LQFP-32 |
| 文件頁數： | 90/163頁 |
| 文件大小： | 1678K |
| 代理商： | M30100M6-XXXFP |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁當前第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁第145頁第146頁第147頁第148頁第149頁第150頁第151頁第152頁第153頁第154頁第155頁第156頁第157頁第158頁第159頁第160頁第161頁第162頁第163頁
Oscillation Stop Detection
Under
development
Tentative Specifications REV.E
Specifications in this manual are tentative and subject to change.
Mitsubishi microcomputers
M30100/M30102 Group
SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER
32
Oscillation stop detection bit (CM20)
You can start the oscillation stop detection by setting this bit to "1" and CM21=1 (oscillation stop detection
interrupt enabled). The detection is not executed when this bit is set to "0" or in reset status. Be sure to set
this bit to "0" before setting for the stop-mode. Set this bit again to "1" after release from stop-mode. Set
this bit to "0" also before setting the main clock stop bit (bit 5 at 000616) to "1".
Do not set this bit to "1" if the frequency of XIN is lower than 2 MHz.
An oscillation stop is detected if CM02=“1” (peripheral function clock has been set for stop in wait mode)
and the mode is shifted to wait.
Oscillation stop detection interrupt enable bit (CM21)
When CM20=1 and CM21=1, an oscillation stop detection interrupt is generated if an abnormal stop of
XIN is detected. The ring oscillator starts operation instead of the XIN clock which stopped abnormally.
The operation goes further with the main clock supplied from the ring oscillator. For the oscillation stop
detection interrupt, judgment on the interrupt condition is necessary, because this interrupt shares the
vector table with watchdog timer interrupt. Figure 1.10.3 shows flow of the judgment with oscillation stop
detection interrupt processing program.
Main clock switch bit (CM22)
When setting this bit to "1", the ring oscillator is selected as main clock. At this time, the ring oscillator
starts simultaneously if it has been stopped (CM14=1). This bit is cleared only when CM23 is "0" (when
XIN is oscillating).
If an oscillation stop is detected while both CM20 and CM21 are “1”, this bit automatically switches to “1”.
When this bit is set to “1”, the ring oscillation stop bit (bit 4 of address 000716) is automatically set to “0”.
Clock monitor bit (CM23)
You can see the operation status of the XIN clock. When this bit is "0", XIN is operating correctly. You can
check the oscillation status of XIN when an oscillation stop detection interrupt is generated or after reset.
When oscillation stop detection is invalid (CM20=“0”), the clock monitor bit is “0”.
相關PDF資料 |
PDF描述 |
|---|---|
| M30100M6T-XXXFP | 16-BIT, MROM, 16 MHz, MICROCONTROLLER, PQFP32 |
| M30218MC-AXXXFP | 16-BIT, MROM, 10 MHz, MICROCONTROLLER, PQFP100 |
| M30218FCFP | 16-BIT, FLASH, 10 MHz, MICROCONTROLLER, PQFP100 |
| M30245MC-XXXGP | 16-BIT, MROM, 16 MHz, MICROCONTROLLER, PQFP100 |
| M30245MC-XXXGP | 16-BIT, MROM, 16 MHz, MICROCONTROLLER, PQFP100 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| M30100T3-RPD-E | 制造商:Renesas Electronics Corporation 功能描述:DEV EMULATOR POD M16C/10 SERIES - Bulk |
| M30100T-PTC | 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:Converter for Connecting 32-pin 0.8mm-pitch QFP for M30100T-PRB (for M16C/10 Group M30100) |
| M30-1010046 | 功能描述:集管和線殼 1.25MM FEMALE CRIMP TIN PK OF 105 RoHS:否 產品種類:1.0MM Rectangular Connectors 產品類型:Headers - Pin Strip 系列:DF50 觸點類型:Pin (Male) 節距:1 mm 位置/觸點數量:16 排數:1 安裝風格:SMD/SMT 安裝角:Right 端接類型:Solder 外殼材料:Liquid Crystal Polymer (LCP) 觸點材料:Brass 觸點電鍍:Gold 制造商:Hirose Connector |
| M3010102636207.32LLZZ | 制造商:3M Electronic Products Division 功能描述:QUOTE # V05-0068 |
| M30102 | 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER |
發布緊急采購，3分鐘左右您將得到回復。