- 您現在的位置：買賣IC網 > PDF目錄4425 > M1A3PE1500-PQG208 (Microsemi SoC)IC FPGA 1KB FLASH 1.5M 208-PQFP PDF資料下載
參數資料
| 型號： | M1A3PE1500-PQG208 |
| 廠商： | Microsemi SoC |
| 文件頁數： | 64/162頁 |
| 文件大小： | 0K |
| 描述： | IC FPGA 1KB FLASH 1.5M 208-PQFP |
| 標準包裝： | 24 |
| 系列： | ProASIC3E |
| RAM 位總計： | 276480 |
| 輸入/輸出數： | 147 |
| 門數： | 1500000 |
| 電源電壓： | 1.425 V ~ 1.575 V |
| 安裝類型： | 表面貼裝 |
| 工作溫度： | 0°C ~ 70°C |
| 封裝/外殼： | 208-BFQFP |
| 供應商設備封裝： | 208-PQFP（28x28） |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁當前第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁第145頁第146頁第147頁第148頁第149頁第150頁第151頁第152頁第153頁第154頁第155頁第156頁第157頁第158頁第159頁第160頁第161頁第162頁
Datasheet Information
5-6
Revision 13
v2.1
(continued)
The words "ambient temperature" were added to the temperature range in the
"Temperature Grade Offerings", "Speed Grade and Temperature Grade Matrix",
and "Speed Grade and Temperature Grade Matrix" sections.
iii, iv, iv
The "Clock Conditioning Circuit (CCC) and PLL" section was updated.
i
The caption "Main (chip)" in Figure 2-9 Overview of Automotive ProASIC3
VersaNet Global Network was changed to "Chip (main)."
2-9
The TJ parameter in Table 3-2 Recommended Operating Conditions was
changed to TA, ambient temperature, and table notes 4–6 were added.
3-2
The "PLL Macro" section was updated to add information on the VCO and PLL
outputs during power-up.
2-15
v2.0
(April 2007)
In the "Temperature Grade Offerings" section, Ambient was deleted.
iii
Ambient was deleted from "Temperature Grade Offerings".
iii
Ambient was deleted from the "Speed Grade and Temperature Grade Matrix".
iv
The "PLL Macro" section was updated to include power-up information.
2-15
Table 2-13 ProASIC3E CCC/PLL Specification was updated.
2-30
Figure 2-19 Peak-to-Peak Jitter Definition is new.
2-18
The "SRAM and FIFO" section was updated with operation and timing
requirement information.
2-21
The "RESET" section was updated with read and write information.
2-25
The "RESET" section was updated with read and write information.
2-25
The "Introduction" in the "Advanced I/Os" section was updated to include
information on input and output buffers being disabled.
2-28
In the Table 2-15 Levels of Hot-Swap Support, the ProASIC3 compliance
descriptions were updated for levels 3 and 4.
2-34
Table 2-45 I/O Hot-Swap and 5 V Input Tolerance Capabilities in ProASIC3E
Devices was updated.
2-64
Notes 3, 4, and 5 were added to Table 2-17 Comparison Table for 5 V–
Compliant Receiver Scheme. 5 x 52.72 was changed to 52.7 and the Maximum
current was updated from 4 x 52.7 to 5 x 52.7.
2-40
The "VCCPLF PLL Supply Voltage" section was updated.
2-50
The "VPUMP Programming Supply Voltage" section was updated.
2-50
The "GL Globals" section was updated to include information about direct input
into quadrant clocks.
2-51
VJTAG was deleted from the "TCK Test Clock" section.
2-51
In Table 2-22 Recommended Tie-Off Values for the TCK and TRST Pins, TSK
was changed to TCK in note 2. Note 3 was also updated.
2-51
Ambient was deleted from Table 3-2 Recommended Operating Conditions.
VPUMP programming mode was changed from "3.0 to 3.6" to "3.15 to 3.45".
3-2
Note 3 is new in Table 3-4 Overshoot and Undershoot Limits (as measured on
quiet I/Os).
3-2
In EQ 3-2, 150 was changed to 110 and the result changed to 5.88.
3-5
Revision
Changes
Page
相關PDF資料 |
PDF描述 |
|---|---|
| ASC35DRAI | CONN EDGECARD 70POS .100 R/A DIP |
| ACB35DHBR | CONN EDGECARD 70POS R/A .050 DIP |
| ASC36DRYI-S734 | CONN EDGECARD 72POS DIP .100 SLD |
| ACC50DRTI | CONN EDGECARD 100PS .100 DIP SLD |
| ASC36DRAN | CONN EDGECARD 72POS .100 R/A DIP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| M1A3PE1500-PQG208I | 功能描述:IC FPGA 1KB FLASH 1.5M 208-PQFP RoHS:是 類別:集成電路 (IC) >> 嵌入式 - FPGA（現場可編程門陣列） 系列:ProASIC3E 產品培訓模塊:Three Reasons to Use FPGA's in Industrial Designs Cyclone IV FPGA Family Overview 特色產品:Cyclone? IV FPGAs 標準包裝:60 系列:CYCLONE® IV GX LAB/CLB數:9360 邏輯元件/單元數:149760 RAM 位總計:6635520 輸入/輸出數:270 門數:- 電源電壓:1.16 V ~ 1.24 V 安裝類型:表面貼裝 工作溫度:0°C ~ 85°C 封裝/外殼:484-BGA 供應商設備封裝:484-FBGA（23x23） |
| M1A3PE1500-PQG896 | 制造商:ACTEL 制造商全稱:Actel Corporation 功能描述:ProASIC3E Flash Family FPGAs |
| M1A3PE1500-PQG896ES | 制造商:ACTEL 制造商全稱:Actel Corporation 功能描述:ProASIC3E Flash Family FPGAs |
| M1A3PE1500-PQG896I | 制造商:ACTEL 制造商全稱:Actel Corporation 功能描述:ProASIC3E Flash Family FPGAs |
| M1A3PE1500-PQG896PP | 制造商:ACTEL 制造商全稱:Actel Corporation 功能描述:ProASIC3E Flash Family FPGAs |
發布緊急采購，3分鐘左右您將得到回復。