參數資料
型號: LZ24BP
廠商: Sharp Corporation
英文描述: 1/4-type Progressive-scan Color CCD Area Sensor with 350 k Pixels
中文描述: 1/4-type逐行掃描,350萬像素彩色CCD區(qū)域傳感器
文件頁數: 4/10頁
文件大?。?/td> 87K
代理商: LZ24BP
4
LZ24BP
CHARACTERISTICS
(1/30 s progressive scan readout mode)
(T
A
= +25 C, Operating conditions : The typical values specified in "
RECOMMENDED OPERATING CONDITIONS
".
Color temperature of light source : 3 200 K, IR cut-off filter (CM-500, 1 mmt) is used.)
PARAMETER
SYMBOL
Standard output voltage
Photo response non-uniformity
Saturation output voltage
Dark output voltage
Dark signal non-uniformity
Sensitivity (green channel)
Smear ratio
Image lag
Blooming suppression ratio
Output transistor drain current
NOTES :
Within the recommended operating conditions of V
OD
,
V
OFD
of the internal output satisfies with ABL larger than
300 times exposure of the standard exposure conditions,
and V
SAT
larger than 450 mV.
1. T
A
= +60 C
2. The average output voltage of G signal under uniform
illumination. The standard exposure conditions are
defined as when Vo is 150 mV.
3. The image area is divided into 10 x 10 segments under
the standard exposure conditions. Each segment's
voltage is the average output voltage of all pixels within
the segment. PRNU is defined by (Vmax – Vmin)/Vo,
where Vmax and Vmin are the maximum and minimum
values of each segment's voltage respectively.
4. The image area is divided into 10 x 10 segments. Each
segment's voltage is the average output voltage of all
pixels within the segment. V
SAT
is the minimum
segment's voltage under 10 times exposure of the
standard exposure conditions.
5. The average output voltage under non-exposure
conditions.
6. The image area is divided into 10 x 10 segments under
non-exposure conditions. DSNU is defined by (Vdmax –
Vdmin), where Vdmax and Vdmin are the maximum and
minimum values of each segment's voltage respectively.
MIN.
TYP.
150
MAX.
UNIT
mV
%
mV
mV
mV
mV
dB
%
NOTE
2
3
4
1, 5
1, 6
7
8
9
10
V
O
PRNU
V
SAT
V
DARK
DSNU
R
SMR
AI
ABL
I
OD
10
450
0.5
0.5
230
–94
3.0
2.0
165
–86
1.0
300
4.0
8.0
mA
7. The average output voltage of G signal when a 1 000
lux light source with a 90% reflector is imaged by a lens
of F4, f50 mm.
8. The sensor is exposed only in the central area of V/10
square with a lens at F4, where V is the vertical image
size. SMR is defined by the ratio of the output voltage
detected during the vertical blanking period to the
maximum output voltage in the V/10 square.
9. The sensor is exposed at the exposure level
corresponding to the standard conditions. AI is defined
by the ratio of the output voltage measured at the 1st
field during the non-exposure period to the standard
output voltage.
10. The sensor is exposed only in the central area of V/10
square, where V is the vertical image size. ABL is
defined by the ratio of the exposure at the standard
conditions to the exposure at a point where blooming is
observed.
相關PDF資料
PDF描述
LZ34B10 1/4-type Color CMOS Image Sensor with 350 k Pixels
LZ34C10 1/4-type Color CMOS Image Sensor with 110 k Pixels
LZ85194 IrDA Control Peripheral Engine(IrDA 控制外圍處理器)
LZ8519X IrDA Control Peripheral Engine (PE)
LZ85202 IrDA Control Host Controller with USB Interface(帶USB接口的IrDA控制主控制器)
相關代理商/技術參數
參數描述
LZ-24-C 功能描述:通用繼電器 POWER RoHS:否 制造商:Omron Electronics 觸點形式:1 Form A (SPST-NO) 觸點電流額定值:150 A 線圈電壓:24 VDC 線圈電阻:144 Ohms 線圈電流:167 mA 切換電壓:400 V 安裝風格:Chassis 觸點材料:
LZ-24E 功能描述:通用繼電器 POWER RoHS:否 制造商:Omron Electronics 觸點形式:1 Form A (SPST-NO) 觸點電流額定值:150 A 線圈電壓:24 VDC 線圈電阻:144 Ohms 線圈電流:167 mA 切換電壓:400 V 安裝風格:Chassis 觸點材料:
LZ-24E-HV 功能描述:通用繼電器 POWER RoHS:否 制造商:Omron Electronics 觸點形式:1 Form A (SPST-NO) 觸點電流額定值:150 A 線圈電壓:24 VDC 線圈電阻:144 Ohms 線圈電流:167 mA 切換電壓:400 V 安裝風格:Chassis 觸點材料:
LZ-24E-K 功能描述:通用繼電器 POWER RoHS:否 制造商:Omron Electronics 觸點形式:1 Form A (SPST-NO) 觸點電流額定值:150 A 線圈電壓:24 VDC 線圈電阻:144 Ohms 線圈電流:167 mA 切換電壓:400 V 安裝風格:Chassis 觸點材料:
LZ-24E-K-HV 功能描述:通用繼電器 POWER RoHS:否 制造商:Omron Electronics 觸點形式:1 Form A (SPST-NO) 觸點電流額定值:150 A 線圈電壓:24 VDC 線圈電阻:144 Ohms 線圈電流:167 mA 切換電壓:400 V 安裝風格:Chassis 觸點材料: