- 您現在的位置：買賣IC網 > PDF目錄358968 > LZ2354BJ (Sharp Corporation) 1/3-type CCD Area Sensors with 410 k Pixels PDF資料下載
參數資料
| 型號： | LZ2354BJ |
| 廠商： | Sharp Corporation |
| 英文描述： | 1/3-type CCD Area Sensors with 410 k Pixels |
| 中文描述： | 1/3-type傳感器與防治荒漠化面積410萬像素 |
| 文件頁數： | 4/12頁 |
| 文件大?。?/td> | 97K |
| 代理商： | LZ2354BJ |
4
LZ2353B/LZ2354BJ
CHARACTERISTICS FOR LZ2353B
(Drive method : Field accumulation)
(T
A
= +25 C, Operating conditions : The typical values specified in "
RECOMMENDED OPERATING CONDITIONS
".
Color temperature of light source : 3 200 K, IR cut-off filter (CM-500, 1 mmt) is used.)
PARAMETER
SYMBOL
Standard output voltage
Photo response non-uniformity
Saturation output voltage
Dark output voltage
Dark signal non-uniformity
Sensitivity
Smear ratio
Image lag
Blooming suppression ratio
Output transistor drain current
Output impedance
V
NOISE
Dark noise
MIN.
TYP.
150
MAX.
UNIT
mV
%
mV
mV
mV
mV
dB
%
NOTE
2
3
4
1, 5
1, 6
7
8
9
10
V
O
PRNU
V
SAT
V
DARK
DSNU
R
SMR
AI
ABL
I
OD
R
O
10
700
0.5
0.5
350
–84
3.0
2.0
260
–76
1.0
1 000
4.0
350
0.2
8.0
mA
$
mV
Vector breakup
Line crawling
Luminance flicker
NOTES :
V
OFD
should be adjusted to the minimum voltage such
that ABL satisfy the specification, or to the value
displayed on the device.
1. T
A
= +60 C
2. The average output voltage under uniform illumination.
The standard exposure conditions are defined as when
Vo is 150 mV.
3. The image area is divided into 10 x 10 segments under
the standard exposure conditions. Each segment's
voltage is the average output voltage of all pixels within
the segment. PRNU is defined by (Vmax – Vmin)/Vo,
where Vmax and Vmin are the maximum and minimum
values of each segment's voltage respectively.
4. The image area is divided into 10 x 10 segments. Each
segment's voltage is the average output voltage of all
pixels within the segment. V
SAT
is the minimum
segment's voltage under 10 times exposure of the
standard exposure conditions.
5. The average output voltage under non-exposure
conditions.
6. The image area is divided into 10 x 10 segments under
non-exposure conditions. DSNU is defined by (Vdmax –
Vdmin), where Vdmax and Vdmin are the maximum and
minimum values of each segment's voltage respectively.
7. The average output voltage when a 1 000 lux light
source with a 90% reflector is imaged by a lens of F4,
f50 mm.
5.0
1.5
2.0
, %
%
%
13
14
15
8. The sensor is exposed only in the central area of V/10
square with a lens at F4, where V is the vertical image
size. SMR is defined by the ratio of the output voltage
detected during the vertical blanking period to the
maximum output voltage in the V/10 square.
9. The sensor is exposed at the exposure level
corresponding to the standard conditions. AI is defined
by the ratio of the output voltage measured at the 1st
field during the non-exposure period to the standard
output voltage.
10. The sensor is exposed only in the central area of V/10
square, where V is the vertical image size. ABL is
defined by the ratio of the exposure at the standard
conditions to the exposure at a point where blooming is
observed.
11. The RMS value of the dark noise (after CDS). (100 kHz
to 4.2 MHz, SC trap on.)
12. The difference of the average output voltage between
the effective area and the OB area under non-exposure
conditions.
13. Observed with a vector scope when the color bar chart
is imaged under the standard exposure conditions.
14. The difference between the average output voltage of the
(Mg + Ye), (G + Cy) line and that of the (Mg + Cy), (G +
Ye) line under the standard exposure conditions.
15. The difference between the average output voltage of
the odd field and that of the even field under the
standard exposure conditions.
1, 12
mV
1.0
OB difference in level
11
0.3
相關PDF資料 |
PDF描述 |
|---|---|
| LZ2363B | 1/3-type CCD Area Sensors with 470 k Pixels |
| LZ23BP2 | RECTIFIER FAST-RECOVERY SINGLE 1.5A 600V 50A-ifsm 1.7V-vf 75ns 5uA-ir DO-15 5K/REEL-13 |
| LZ23H3V1 | SOCKET, D, FILTERED, 330PF, 44WAY; Connector type:D Sub, High-Density; Gender:Socket; Ways, No. of:44; Termination method:Solder; Material, contact:Copper Alloy; Plating, contact:Bright Tin; Series:FHTB; Material:Steel; Current RoHS Compliant: Yes |
| LZ2413 | 1/4-type Color CCD Area Sensors with 270 k Pixels |
| LZ2413H | 1/4-type Color CCD Area Sensors with 270 k Pixels |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LZ2354J | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Area CCD Image Array |
| LZ23-6 | 制造商:ebm-papst Inc 功能描述:FAN GUARD METAL 92MM 制造商:ebm-papst Inc 功能描述:FAN GUARD, METAL, 92MM 制造商:ebm-papst Inc 功能描述:FAN GUARD, METAL, 92MM, For Use With:AC 3200 J Series Fans, Fan Size:92mm x 92mm, Fixing Centres:82.5mm, Guard Material:Steel, SVHC:No SVHC (20-Jun-2013) |
| LZ2363 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Area CCD Image Array |
| LZ2363B | 制造商:SHARP 制造商全稱:Sharp Electrionic Components 功能描述:1/3-type CCD Area Sensors with 470 k Pixels |
| LZ2364BJ | 制造商:SHARP 制造商全稱:Sharp Electrionic Components 功能描述:1/3-type CCD Area Sensors with 470 k Pixels |
發布緊急采購，3分鐘左右您將得到回復。