- 您現在的位置：買賣IC網 > PDF目錄377797 > LXM1611-01 (MICROSEMI CORP-ANALOG MIXED SIGNAL GROUP) DIGIT DIMMING CCFL INVERTER MODULE PDF資料下載
參數資料
| 型號： | LXM1611-01 |
| 廠商： | MICROSEMI CORP-ANALOG MIXED SIGNAL GROUP |
| 元件分類： | 模擬信號調理 |
| 英文描述： | DIGIT DIMMING CCFL INVERTER MODULE |
| 中文描述： | SPECIALTY ANALOG CIRCUIT, DMA10 |
| 文件頁數： | 5/5頁 |
| 文件大?。?/td> | 168K |
| 代理商： | LXM1611-01 |
D
IGITAL
D
IMMING
CCFL I
NVERTER
M
ODULE
LXM1611-01
P R O D U C T D A T A B O O K 1 9 9 6 / 1 9 9 7
5
Copyright 1999
Rev. 0.4 8/99
P
R E L I M I N A R Y
D
A T A
S
H E E T
P
A T E N T
P
E N D I N G
RangeMAX
TM
PRELIMINARY DATA - Information contained in this document is pre-production data, and is proprietary to LinFinity. It may
H O W R A N G E M A X W O R K S
(continued)
HIGHLIGHTS
I
On-board brightness control circuit includes a DC voltage
to pulse width converter that minimizes system design work
and system noise susceptibility. This provides a familiar
and convenient interface while reducing the potential for
externally induced noise which can cause lamp flicker.
An on-board oscillator operates the inverter BURST rate
above 95Hz, well beyond standard 50/60Hz video refresh
rates where the eye can perceive pulsing light.
RangeMAX inverter modules are designed to operate with
the burst frequency synchronized to the video frame rate.
This provides operation with no visible display disturbances
caused by beat frequencies between the lamps and video
frame rates.
I
I
I
In applications with no access to a vertical sync, the in-
verter burst frequency can be allowed to "free run" at 95Hz.
In this non-synchronous mode, minor display disturbances
can be found under certain video conditions. This perfor-
mance may be acceptable for many applications, but syn-
chronization must be used when no disturbance can be
tolerated.
Separate inputs are provided for negative and positive ver-
tical sync pulses so external inversion is not needed.
Separate feedback loops for lamp current and open circuit
voltage regulation insure reliable strike under all operat-
ing conditions, automatic over-voltage prevention with bro-
ken or failed lamps, and accurate lamp current regulation.
I
I
RangeMAX
and
Direct Drive
are trademarks of Linfinity Microelectronics Inc.
T Y P I C A L A P P L I C AT I O N
I
The brightness control may be a simple 10k
potentiometer or a voltage output DAC. A PWM signal
from a micro-controller may also be used with a suitable
filter such as shown in Figure 5A.
I
If synchronization to the video framerate is desired,
connect the vertical sync pulse from the system video
controller to the appropriate V
input. If the pulse
is negative going (
positive going (
), connect it to V
If no video synchronization is desired, leave both V
SYNC(-)
and V
floating.
I
If you need to turn the inverter ON/OFF remotely,
connect a 3V or 5V logic signal to the SLEEP input. If
remote ON/OFF is not needed, connect the SLEEP input
to V
or any other voltage greater than 2.2V
.
I
Connect V
HI
to high voltage wire from the lamp.
Connect V
to the low voltage wire (wire with thinner
insulation). Never connect V
to circuit ground as
this will defeat lamp current regulation. If both lamp
wires have heavy high voltage insulation, connect the
longest wire to V
LO
.
), connect it to V
SYNC(-)
. If
FIGURE 5
— Potentiometer Brightness Control
FIGURE 5A
— PWM Brightness Control
LXM1611-01
BRITE
V
HI
V
IN
SLEEP
GND
CCFL
TUBE
9-18V
DC
10k
5V
0V
V
LO
2.5V
DC
V
SYNC(+)
V
SYNC(-)
V
SYNC(-)
V
SYNC(+)
RangeMAX INVERTERS
Also available in Dual
Output
LXM1621-01
and
Quad Output
LXM1641-01
versions for multiple lamp
applications.
4.99k
4.99k*
4.7μF
PWM Signal
from System
LXM1611-01
BRITE
0 P.W. 100% of period
100μs
P.W.
*
Use 4.99k for 5V PWM amplitude, 15k for 3.3V PWM
amplitude, and omit for 2.5V PWM amplitude.
相關PDF資料 |
PDF描述 |
|---|---|
| LXM1612-05-01 | 3.5MM EURO HEADER RA BLK 6CKT |
| LXM1612-05-02 | 5V Highly-Integrated, Digital Dimming CCFL Inverter Module |
| LXM1612-05-03 | 5V Highly-Integrated, Digital Dimming CCFL Inverter Module |
| LXM1612-05-XX | 5V Highly-Integrated, Digital Dimming CCFL Inverter Module |
| LXM1612-12-01 | 12V Highly-Integrated, Digital Dimming CCFL Inverter Module |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LXM1612-05-01 | 功能描述:MOD CCFL INVERTER DIGITAL DIM 5V RoHS:否 類別:光電元件 >> 反相器 系列:LXM1612-05-xx 標準包裝:100 系列:- 輸入電壓:6.0V 輸出:900V 類型:用于 CCFL 和 UV 燈的逆變器 尺寸/尺寸:2.34" L x 0.35" W x 0.35" H（59.5mm x 9mm x 8.9mm） 安裝類型:底座安裝 |
| LXM1612-05-01B | 制造商:Microsemi Corporation 功能描述:LXM1612-05-01B - Tape and Reel |
| LXM1612-05-02 | 功能描述:MOD INVERTER CCFL DIGITAL SGL 5V RoHS:否 類別:光電元件 >> 反相器 系列:LXM1612-05-xx 標準包裝:100 系列:- 輸入電壓:6.0V 輸出:900V 類型:用于 CCFL 和 UV 燈的逆變器 尺寸/尺寸:2.34" L x 0.35" W x 0.35" H（59.5mm x 9mm x 8.9mm） 安裝類型:底座安裝 |
| LXM1612-05-03 | 功能描述:MOD INVERTER CCFL DIGITAL SGL 5V RoHS:否 類別:光電元件 >> 反相器 系列:LXM1612-05-xx 標準包裝:100 系列:- 輸入電壓:6.0V 輸出:900V 類型:用于 CCFL 和 UV 燈的逆變器 尺寸/尺寸:2.34" L x 0.35" W x 0.35" H（59.5mm x 9mm x 8.9mm） 安裝類型:底座安裝 |
| LXM1612-05-XX | 制造商:MICROSEMI 制造商全稱:Microsemi Corporation 功能描述:5V Highly-Integrated, Digital Dimming CCFL Inverter Module |
發布緊急采購，3分鐘左右您將得到回復。