- 您現在的位置：買賣IC網 > PDF目錄98003 > LX1571IDMT (MICROSEMI CORP-ANALOG MIXED SIGNAL GROUP) 1 A SWITCHING CONTROLLER, PDSO8 PDF資料下載
參數資料
| 型號： | LX1571IDMT |
| 廠商： | MICROSEMI CORP-ANALOG MIXED SIGNAL GROUP |
| 元件分類： | 穩壓器 |
| 英文描述： | 1 A SWITCHING CONTROLLER, PDSO8 |
| 封裝： | PLASTIC, SOIC-8 |
| 文件頁數： | 10/12頁 |
| 文件大小： | 257K |
| 代理商： | LX1571IDMT |
PHASE MODULATED AC SYNCHRONOUS SECONDARY-SIDE CONTROLLER
LX1570/1571
PRODUCT DA T ABOOK 1996/1997
7
Copyright 1997
Rev. 0.9.3
1/97
P RELIMINAR Y D AT A S HEET
IC DESCRIPTION
STEADY-STATE OPERATION
Steady-state operation is best described by referring to the main
block diagram and the typical application circuit shown in Fig-
ure 2. The output drive turns the external power MOSFET on
and current ramps up in the inductor. Inductor current is sensed
with an external resistor (or in the case of LX1571 with a current
transformer) and is compared to the threshold at the inverting
input of the current sense (C.S.) comparator. This threshold is
set by the voltage feedback loop, which is controlled by the
error amplifier. Exceeding this threshold resets the PWM latch
and turns the MOSFET off. The Output drive goes low, turning
the C
T charging curr ent off and the discharging current on, caus-
ing the C
T voltage to ramp down. When this voltage goes below
1.5V, it sets the PWM latch and turns the output drive back on
prior to the next rising edge of the transformer voltage, and the
cycle repeats.
The Steady-State Operation Timing Diagram - Normal Mode
(Figure 4A) shows typical waveforms in the steady-state condi-
tion. Notice that when the current sense signal turns the MOSFET
off, it also synchronizes the output drive to the transformer volt-
age (see discussion under heading Timing Section). In addition,
the energy transfer occurs only when both transformer voltage
and OUT DRV pin are "HI" at the same time, establishing the
effective on-time of the converter. This shows that the regula-
tion of this converter is achieved by modulating the trailing edge
of the output drive with respect to the leading edge of the AC
voltage, while maintaining a fixed output drive duty cycle. In
other words, the converter duty cycle seen by L1 is controlled by
varying the phase between the AC voltage and the output driver
signal (phase modulation). Maximum converter duty cycle is
achieved when both signals are in phase, as shown in Figure 4B.
The LX1570/71 output drive always maintains a fixed duty cycle
(
≈54%), since both charge and discharge currents are almost equal
as shown in Figures 4A and 4B.
Error Amp
2.5V
C.S. Comp
R
S
Q
PWM Latch
7
6
5 GND
V
CC
OUT DRV
R
Internal
Bias
2.5V
REF
1V
5V
2.5V
4
3
2
1
S.S.
V
FB
COMP
C.S.
8
C
T
Timing / Duty Cycle
Control
CHG
CONTROL
LATCH
SET CONTROL
DISCH
CONTROL
FIGURE 3 — STEADY-STATE OPERATION BLOCK DIAGRAM
相關PDF資料 |
PDF描述 |
|---|---|
| LX1570IDMT | 1 A SWITCHING CONTROLLER, PDSO8 |
| LX1676-CLQT | 1.5 A SWITCHING CONTROLLER, 1100 kHz SWITCHING FREQ-MAX, PQCC38 |
| LX1677-CPW | 1.5 A SWITCHING CONTROLLER, 1100 kHz SWITCHING FREQ-MAX, PDSO38 |
| LX1677-CPWT | 1.5 A SWITCHING CONTROLLER, 1100 kHz SWITCHING FREQ-MAX, PDSO38 |
| LX1677-CLQT | 1.5 A SWITCHING CONTROLLER, 1100 kHz SWITCHING FREQ-MAX, PQCC38 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LX1571IM | 功能描述:IC REG CTRLR ISO PWM CM 8-DIP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:4,000 系列:- PWM 型:電壓模式 輸出數:1 頻率 - 最大:1.5MHz 占空比:66.7% 電源電壓:4.75 V ~ 5.25 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 85°C 封裝/外殼:40-VFQFN 裸露焊盤 包裝:帶卷 (TR) |
| LX1571MY | 功能描述:IC REG CTRLR ISO PWM CM 8-DIP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:4,000 系列:- PWM 型:電壓模式 輸出數:1 頻率 - 最大:1.5MHz 占空比:66.7% 電源電壓:4.75 V ~ 5.25 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 85°C 封裝/外殼:40-VFQFN 裸露焊盤 包裝:帶卷 (TR) |
| LX15RQ-75884 | 制造商:Banner Engineering 功能描述:LX15RQ-75884 LO Output |
| LX160VB10RM12X20LL | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:LXA/LX Series |
| LX160VB22RM16X25LL | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:LXA/LX Series |
發布緊急采購，3分鐘左右您將得到回復。