- 您現在的位置：買賣IC網 > PDF目錄45000 > LTM8052IV#PBF (LINEAR TECHNOLOGY CORP) SWITCHING REGULATOR, 1000 kHz SWITCHING FREQ-MAX, PBGA81 PDF資料下載
參數資料
| 型號： | LTM8052IV#PBF |
| 廠商： | LINEAR TECHNOLOGY CORP |
| 元件分類： | 穩壓器 |
| 英文描述： | SWITCHING REGULATOR, 1000 kHz SWITCHING FREQ-MAX, PBGA81 |
| 封裝： | 15 X 11.25 MM, 2.82 MM HEIGHT, ROHS COMPLIANT, MO-222, LGA-81 |
| 文件頁數： | 8/28頁 |
| 文件大?。?/td> | 350K |
| 代理商： | LTM8052IV#PBF |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁當前第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁
LTM8052
16
8052f
applicaTions inForMaTion
Figure 3. Voltage Regulation and Overvoltage Protection
Feedback Connections
Voltage Regulation and Output Overvoltage Protection
The LTM8052 uses the ADJ pin to regulate the output
voltage and to provide a high speed overvoltage lockout
to avoid high voltage conditions. If the output voltage
exceeds 125% of the regulated voltage level (1.5V at the
ADJ pin), the LTM8052 terminates switching and shuts
down switching for a brief time before restarting. The
regulated output voltage must be greater than 1.19V and
is set by the equation:
VOUT =1.19V 1+
10k
RADJ
where RADJ is shown in Figure 3.
Figure 4. UVLO Configuration
functionality in the specified operating range. This means
that internal temperatures will exceed the 125°C absolute
maximum rating when the overtemperature protection is
active, possibly impairing the device’s reliability.
UVLO and Shutdown
TheLTM8052hasaninternalUVLOthatterminatesswitch-
ing, resets all logic, and discharges the soft-start capacitor
when the input voltage is below 6V. The LTM8052 also has
a precision RUN function that enables switching when the
voltage at the RUN pin rises to 1.68V and shuts down the
LTM8052 when the RUN pin voltage falls to 1.55V. There
is also an internal current source that provides 5.5μA of
pull-down current to program additional UVLO hysteresis.
For RUN rising, the current source is sinking 5.5A until
RUN = 1.68V, after which the current source turns off.
For RUN falling, the current source is off until the RUN =
1.55V, after which it sinks 5.5A. The following equations
determine the voltage divider resistors for programming
the falling UVLO voltage and rising enable voltage (VENA)
as configured in Figure 4.
R1
=
1.55V R2
UVLO–1.55V
R2
=
VENA –1.084UVLO
5.5A
The RUN pin has an absolute maximum voltage of 6V.
To accommodate the largest range of applications, there
is an internal Zener diode that clamps this pin, so that it
can be pulled up to a voltage higher than 6V through a
resistor that limits the current to less than 100A. For
applications where the supply range is greater than 4:1,
size R2 greater than 375k.
LTM8052
VOUT
RADJ
8052 F03
ADJ
LTM8052
VIN
R2
VIN
R1
8052 F04
RUN
In situations where the output of the LTM8052 is required
to sink current (that is, the load is driving current into the
LTM8052 output), the μModule regulator will maintain
voltage regulation as long as the negative current limit is
not exceeded. If the current limit is exceeded, the output
voltage may begin to rise. If the output voltage rises more
than 125% of the target regulation voltage, the output
overvoltage protection will engage, and the LTM8052 will
stop switching. In this situation, the load will be free to
pull up the LTM8052 output. If the voltage exceeds the
LTM8052 input, an internal power diode will clamp the
output to a diode drop above the input.
Thermal Shutdown
If the part is too hot, the LTM8052 engages its thermal
shutdown, terminates switching and discharges the soft-
startcapacitor.Whentheparthascooled,thepartautomati-
cally restarts. This thermal shutdown is set to engage at
temperaturesabovethe125°Cabsolutemaximuminternal
operating rating to ensure that it does not interfere with
相關PDF資料 |
PDF描述 |
|---|---|
| LTM8062EV#PBF | BATTERY CHARGE CONTROLLER, 1150 kHz SWITCHING FREQ-MAX, PBGA77 |
| LTM8062AEV#PBF | BATTERY CHARGE CONTROLLER, 1150 kHz SWITCHING FREQ-MAX, PBGA77 |
| LTM9005CV-AA#PBF | SPECIALTY ANALOG CIRCUIT, PBGA204 |
| LTM9005CV-AB#PBF | SPECIALTY ANALOG CIRCUIT, PBGA204 |
| LTM9005IV-AB#PBF | SPECIALTY ANALOG CIRCUIT, PBGA204 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTM8061 | 制造商:LINER 制造商全稱:Linear Technology 功能描述:32V, 2A μModule Li-Ion/ Polymer Battery Charger |
| LTM8061EV-4.1#PBF | 功能描述:IC BATTERY CHARGER 4.1V 77-LGA RoHS:是 類別:集成電路 (IC) >> PMIC - 電池管理 系列:µModule® 其它有關文件:STC3100 View All Specifications 特色產品:STC3100 - Battery Monitor IC 標準包裝:4,000 系列:- 功能:燃料，電量檢測計/監控器 電池化學:鋰離子（Li-Ion） 電源電壓:2.7 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-TSSOP，8-MSOP（0.118"，3.00mm 寬） 供應商設備封裝:8-MiniSO 包裝:帶卷 (TR) 其它名稱:497-10526-2 |
| LTM8061EV-4.1PBF | 制造商:LINER 制造商全稱:Linear Technology 功能描述:32V, 2A μModule Li-Ion/ Polymer Battery Charger |
| LTM8061EV-4.2#PBF | 功能描述:IC BATTERY CHARGER 4.2V 77-LGA RoHS:是 類別:集成電路 (IC) >> PMIC - 電池管理 系列:µModule® 其它有關文件:STC3100 View All Specifications 特色產品:STC3100 - Battery Monitor IC 標準包裝:4,000 系列:- 功能:燃料，電量檢測計/監控器 電池化學:鋰離子（Li-Ion） 電源電壓:2.7 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-TSSOP，8-MSOP（0.118"，3.00mm 寬） 供應商設備封裝:8-MiniSO 包裝:帶卷 (TR) 其它名稱:497-10526-2 |
| LTM8061EV-4.2PBF | 制造商:LINER 制造商全稱:Linear Technology 功能描述:32V, 2A μModule Li-Ion/ Polymer Battery Charger |
發布緊急采購，3分鐘左右您將得到回復。