- 您現在的位置：買賣IC網 > PDF目錄3504 > LTC6915CDE#TR (Linear Technology)IC PGA DIGITAL PREC 0DRFT 12DFN PDF資料下載
參數資料
| 型號： | LTC6915CDE#TR |
| 廠商： | Linear Technology |
| 文件頁數： | 7/18頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC PGA DIGITAL PREC 0DRFT 12DFN |
| 標準包裝： | 2,500 |
| 放大器類型： | 儀表 |
| 電路數： | 1 |
| 輸出類型： | 滿擺幅 |
| 轉換速率： | 0.2 V/µs |
| 增益帶寬積： | 200kHz |
| 電流 - 輸入偏壓： | 4nA |
| 電壓 - 輸入偏移： | 5µV |
| 電流 - 電源： | 1.73mA |
| 電壓 - 電源，單路/雙路(±)： | 2.7 V ~ 11 V，±1.35 V ~ 5.5 V |
| 工作溫度： | 0°C ~ 70°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 12-WFDFN 裸露焊盤 |
| 供應商設備封裝： | 12-DFN-EP（4x3） |
| 包裝： | 帶卷 (TR) |
第1頁第2頁第3頁第4頁第5頁第6頁當前第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁
LTC6915
15
6915fb
operaTion
Settling Time
The sampling rate is 3kHz and the input sampling period
duringwhichCSischargedtotheinputdifferentialvoltage,
VIN, is approximately 150s. First assume that on each
input sampling period, CS is charged fully to VIN. Since
CS = CH (= 1000pF), a change in the input will settle to
N bits of accuracy at the op amp noninverting input after
N clock cycles or 333s(N). The settling time at the OUT
pin is also affected by the internal op amp. Since the gain
bandwidth of the internal op amp is typically 200kHz, the
settling time is dominated by the switched-capacitor front
end for gains below 100 (see the Low Gain Settling Time
vs Settling Accuracy and the Settling Time vs Gain graphs
in the Typical Performance Characteristics section). In ad-
dition, the worst case settling time after a device-enable
(activelowonPin1ofaGNpackage)isequaltothesettling
due to the gain plus the input settling time (333s N).
For example, if an LTC6915 is enabled with a logic high on
Pin 1 then, the maximum settling time to 10 bits of ac-
curacy (0.1%) and a gain equal to 100 is 8.33ms ([333s
1024] + 5ms).
Input Current
Whenever the differential input VIN changes, CH must be
charged up to the new input voltage via CS. This results
in an input charging current during each input sampling
period. Eventually, CH and CS will reach VIN and ideally,
the input current would go to zero for DC inputs.
In reality, there are additional parasitic capacitors which
disturb the charge on CS every cycle even if VIN is a DC
voltage. For example, the parasitic bottom plate capacitor
on CS must be charged from the voltage on the REF pin to
the voltage on the IN– pin every cycle. The resulting input
charging current decays exponentially during each input
sampling period with a time constant equal to RSCS. If the
voltage disturbance due to these currents settles before
the end of the sampling period, there will be no errors due
to source resistance or the source resistance mismatch
between IN+ and IN–. With RS less than 10k, no DC errors
occur due to input current mismatch.
In the Typical Performance Characteristics section of this
data sheet, there are curves showing the additional error
from non-zero source resistance in the inputs. If there
are no large capacitors across the inputs, the amplifier is
less sensitive to source resistance and source resistance
mismatch. When large capacitors are placed across the
inputs, the input charging currents are placed across
the inputs. The input charging currents described above
result in larger DC errors, especially with source resistor
mismatches.
Power Supply Bypassing
In a dual supply operation, connect a 0.1F bypass ca-
pacitor from each power supply pin (V+ and V–) to an
analog round plance surrounding an LTC6915. The bypass
capacitor trace to the supply pins must be less than
0.2inches(anX7RorX5Rcapacitortypeisrecommended).
Insinglesupplyoperation,connecttheV–pintotheanalog
ground plane and bypass the V+ pin.
Shutdown Modes
The IC has two shutdown modes, hardware shutdown and
software shutdown. When SHDN is tied to V+, the IC is in
hardware shutdown mode. During this shutdown mode,
the gain setting digital interface (serial or parallel) and the
main op amp are both disabled, thus the PGA dissipates
very small supply current (see the Electrical Characteristic
table). When SHDN is floating, an internal current source
will pull it down to V–. The digital interface is turned on to
read the gain setting codes. The IC is in normal amplifica-
tion mode as long as the gain control code is other than
0000. If the gain control code is 0000, the IC operates in
software shutdown mode, i.e., the main op amp is turned
offsothatthePGAdissipateslesspower.TheDFNpackage
does not have hardware shutdown.
Setting the Voltage at the REF Pin
The current coming out of the REF pin may affect the
reference voltage at the REF pin (VREF). If VREF is set by
a resistive divider then the VREF voltage is a function of
the VOUT voltage (see Figure 5). In order to minimize the
VREF variations, the total resistance of R1 plus R2 should
be much less than 32k (5k or less) or use a voltage refer-
ence to set VREF.
Figure 5
–
+
REF
IREF =
VOUT – VREF
32k
VOUT
V+
V–
R1
R2
LTC6915
R = 32k
6915 F05
V
R
V
k
V
R
RR
k
REF
OUT
=+
+
+
12
32
–
(
)
VREF
0.1F
OUT
相關PDF資料 |
PDF描述 |
|---|---|
| LTC2051HVHMS8 | IC OP-AMP ZERO-DRIFT DUAL 8-MSOP |
| TLE-148-01-G-DV | CONN RCPT 2MM 96POS DUAL SMD |
| TSW-148-08-G-S-RA | CONN HEADER 48PS .100 SGL R/A AU |
| TLE-149-01-G-DV | CONN RCPT 2MM 98POS DUAL SMD |
| LTC2051HVIMS8 | IC OPAMP ZERO-DRIFT DUAL 8-MSOP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC6915CGN | 功能描述:IC PGA DIGITAL PREC 0DRFT 16SSOP RoHS:否 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:100 系列:- 放大器類型:通用 電路數:1 輸出類型:- 轉換速率:0.2 V/µs 增益帶寬積:- -3db帶寬:- 電流 - 輸入偏壓:100pA 電壓 - 輸入偏移:30µV 電流 - 電源:380µA 電流 - 輸出 / 通道:- 電壓 - 電源，單路/雙路(±):±2 V ~ 18 V 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:8-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:8-SO 包裝:管件 |
| LTC6915CGN#PBF | 功能描述:IC PGA DIGITAL PREC 0DRFT 16SSOP RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:100 系列:- 放大器類型:通用 電路數:1 輸出類型:- 轉換速率:0.2 V/µs 增益帶寬積:- -3db帶寬:- 電流 - 輸入偏壓:100pA 電壓 - 輸入偏移:30µV 電流 - 電源:380µA 電流 - 輸出 / 通道:- 電壓 - 電源，單路/雙路(±):±2 V ~ 18 V 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:8-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:8-SO 包裝:管件 |
| LTC6915CGN#PBF | 制造商:Linear Technology 功能描述:INSTR-AMPLIFIER 200KHZ 125DB 制造商:Linear Technology 功能描述:INSTR-AMPLIFIER 200KHZ 125DB SSOP-16 制造商:Linear Technology 功能描述:INSTR-AMPLIFIER, 200KHZ, 125DB, SSOP-16 |
| LTC6915CGN#TR | 功能描述:IC PGA DIGITAL PREC 0DRFT 16SSOP RoHS:否 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:100 系列:- 放大器類型:通用 電路數:1 輸出類型:- 轉換速率:0.2 V/µs 增益帶寬積:- -3db帶寬:- 電流 - 輸入偏壓:100pA 電壓 - 輸入偏移:30µV 電流 - 電源:380µA 電流 - 輸出 / 通道:- 電壓 - 電源，單路/雙路(±):±2 V ~ 18 V 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:8-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:8-SO 包裝:管件 |
| LTC6915CGN#TRPBF | 功能描述:IC PGA DIGITAL PREC 0DRFT 16SSOP RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:100 系列:- 放大器類型:通用 電路數:1 輸出類型:- 轉換速率:0.2 V/µs 增益帶寬積:- -3db帶寬:- 電流 - 輸入偏壓:100pA 電壓 - 輸入偏移:30µV 電流 - 電源:380µA 電流 - 輸出 / 通道:- 電壓 - 電源，單路/雙路(±):±2 V ~ 18 V 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:8-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:8-SO 包裝:管件 |
發布緊急采購，3分鐘左右您將得到回復。