- 您現在的位置：買賣IC網 > PDF目錄2007 > LTC6909HMS#TRPBF (Linear Technology)IC OSC SILICON 6.67MHZ 16-MSOP PDF資料下載
參數資料
| 型號： | LTC6909HMS#TRPBF |
| 廠商： | Linear Technology |
| 文件頁數： | 4/22頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC OSC SILICON 6.67MHZ 16-MSOP |
| 標準包裝： | 2,500 |
| 類型： | 振蕩器 - 硅 |
| 頻率： | 12.5kHz ~ 6.67MHz |
| 電源電壓： | 2.7 V ~ 5.5 V |
| 電流 - 電源： | 2.4mA |
| 工作溫度： | -40°C ~ 125°C |
| 封裝/外殼： | 16-TFSOP（0.118"，3.00mm 寬） |
| 包裝： | 帶卷 (TR) |
| 供應商設備封裝： | 16-MSOP |
| 安裝類型： | 表面貼裝 |
LTC6909
12
6909fa
SELECTING THE FREqUENCY-SETTING RESISTOR
The LTC6909 has a master oscillator frequency range
spanning 100kHz to 20MHz depending on the RSET resis-
tor value. However, accuracy may suffer if the oscillator
is operated at a master oscillator frequency greater than
10MHz with a supply voltage lower than 4V. With a linear
correspondence between the master oscillator period and
the RSET resistance, a simple equation relates resistance
with frequency.
RSET =10k 20MHz/fMASTER
RSETMIN = 10k (5V supply), 20k (2.7V supply),
RSETMAX = 2M
Any RSET resistor tolerance will shift the output frequency
by the same amount.
ALTERNATIVE METHODS OF SETTING THE OUTPUT
FREqUENCY OF THE LTC6909
The oscillator may be programmed by any method that
sources a current into the SET pin. The circuit in Figure 4
setstheoscillatorfrequencyusingaprogrammablecurrent
source and in the expression for fOUT, the resistor RSET is
replacedbytheratioof1.1V/ICONTROL.Asalreadyexplained
in the Operation section, the voltage difference between
V+ and SET is approximately 1.1V ±5%, therefore, the
Figure 4 circuit is less accurate than if a resistor controls
the output frequency.
Figure 4. Current Controlled Oscillator
Figure 5 shows the LTC6909 configured as a VCO. A volt-
age source is connected in series with an external 10k
resistor. The master oscillator frequency, fMASTER, will
vary with VCONTROL, that is the voltage source connected
between V+ and the SET pin. Again, this circuit decouples
Figure 5. Voltage Controlled Oscillator
the relationship between the input current and the volt-
age between V+ and SET; the frequency accuracy will be
degraded. The oscillator frequency, however, will increase
monotonically with decreasing VCONTROL.
SETTING THE MODULATION RATE OF THE LTC6909
The modulation rate of the LTC6909 is equal to fOUT/N,
where N is the modulation rate divider setting, which is
determinedbythestateoftheMODpin.TheMODpinshould
be tied to ground for the N = 16 setting. Floating the MOD
pin selects N = 32. The MOD pin should be tied to V+ for
the N = 64 setting. To disable the SSFM, connect one of
the active outputs to the MOD pin. An AC detector circuit
shuts down the modulation circuitry if a frequency that is
close to the output frequency is detected at the MOD pin.
When the MOD pin is floated, for the fOUT/32 modulation
rate, it must be bypassed by at least a 1nF capacitor
to GND. Any AC signal coupling to the MOD pin could
potentiallybedetectedandstopthefrequencymodulation.
DRIVING LOGIC CIRCUITS
The outputs of the LTC6909 are suitable for driving gen-
eral digital logic circuits. However, the form of frequency
spreading used in the LTC6909 may not be suitable for
many logic designs. Many logic designs have fairly tight
timing and cycle-to-cycle jitter requirements. These sys-
temsoftenbenefitfromaspreadspectrumclockingsystem
where the frequency is slowly and linearly modulated by a
triangularwaveform,notapseudorandomwaveform.This
typeoffrequencyspreadingmaintainsaminimaldifference
in the timing from one clock edge to the next adjacent
clock edge (cycle-to-cycle jitter). The LTC6909 uses a
pseudorandom modulating signal where the frequency
CBYP
ICONTROL
fMASTER = 10k (20MHz/1.13V) ICONTROL(A)
V+A
V+
GND
SET
6909 F04
CBYP
VCONTROL
fOUT = 10k 20MHz/RSET(1 – VCONTROL/1.13V)
V+A
V+
GND
SET
6909 F05
RSET
+–
ApplicAtions inForMAtion
相關PDF資料 |
PDF描述 |
|---|---|
| LTC6990MPS6#TRPBF | IC VCO CONFIG GAIN/VOLT TSOT23-6 |
| LTC6991MPS6#TRPBF | IC OSCILLATOR RESET LF TSOT23-6 |
| LTC6992MPS6-4#TRPBF | IC OSC PWM VOLT CTLR TSOT23-6 |
| LTC6994CDCB-2#TRPBF | IC DELAY LINE 6-DFN |
| LTC7541ABN#PBF | IC CMOS D/A CONV 12BIT 18-DIP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC6909IMS#PBF | 功能描述:IC OSC SILICON 6.67MHZ 16-MSOP RoHS:是 類別:集成電路 (IC) >> 時鐘/計時 - 可編程計時器和振蕩器 系列:- 標準包裝:3,000 系列:- 類型:振蕩器 - 晶體 計數:- 頻率:- 電源電壓:2.3 V ~ 5.5 V 電流 - 電源:1.07mA 工作溫度:-30°C ~ 80°C 封裝/外殼:SOT-665 包裝:帶卷 (TR) 供應商設備封裝:SS迷你型-5D 安裝類型:表面貼裝 其它名稱:AN8955SSMTXLTR |
| LTC6909IMS#TRPBF | 功能描述:IC OSC SILICON 6.67MHZ 16-MSOP RoHS:是 類別:集成電路 (IC) >> 時鐘/計時 - 可編程計時器和振蕩器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:45 系列:- 類型:溫度 - 補償晶體振蕩器（TCXO） 計數:- 頻率:25MHz 電源電壓:3.135 V ~ 3.465 V 電流 - 電源:1.5mA 工作溫度:-40°C ~ 85°C 封裝/外殼:16-SOIC（0.295"，7.50mm 寬） 包裝:管件 供應商設備封裝:16-SOIC W 安裝類型:表面貼裝 |
| LTC6909IMS-PBF | 制造商:LINER 制造商全稱:Linear Technology 功能描述:1 to 8 Output, Multiphase Silicon Oscillator with Spread Spectrum Modulation |
| LTC6909IMS-TRPBF | 制造商:LINER 制造商全稱:Linear Technology 功能描述:1 to 8 Output, Multiphase Silicon Oscillator with Spread Spectrum Modulation |
| LTC690C | 制造商:LINER 制造商全稱:Linear Technology 功能描述:Microprocessor Supervisory Circuits |
發布緊急采購，3分鐘左右您將得到回復。