- 您現在的位置：買賣IC網 > PDF目錄11024 > LTC6605IDJC-7#PBF (Linear Technology)IC FILTER 7MHZ DUAL 22-DFN PDF資料下載
參數資料
| 型號： | LTC6605IDJC-7#PBF |
| 廠商： | Linear Technology |
| 文件頁數： | 15/20頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC FILTER 7MHZ DUAL 22-DFN |
| 標準包裝： | 61 |
| 濾波器類型： | 抗混迭 |
| 頻率 - 截止或中心： | 5MHz |
| 濾波器數： | 2 |
| 濾波器階數： | 2nd |
| 電源電壓： | 2.7 V ~ 5.25 V |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 22-WFDFN 裸露焊盤 |
| 供應商設備封裝： | 22-DFN（6x3）裸露焊盤 |
| 包裝： | 管件 |
LTC6605-7
4
66057f
AC ELECTRICAL CHARACTERISTICS The l denotes the specications which apply over the full operating
temperature range, otherwise specications are at TA = 25°C. V+ = 3V, V– = 0V, VINCM = VOCM = mid-supply, VBIAS = V+, unless
otherwise noted. Filter congured as in Figure 2, unless otherwise noted. VS is dened as (V+ – V–). VOUTCM is dened as (V+OUT +
V–OUT)/2. VINCM is dened as (V+IN + V–IN)/2. VOUTDIFF is dened as (V+OUT – V–OUT). VINDIFF is dened as (V+IN + V–IN).
Note 1: Stresses beyond those listed under Absolute Maximum Ratings
may cause permanent damage to the device. Exposure to any Absolute
Maximum Rating condition for extended periods may affect device
reliability and lifetime.
Note 2: All pins are protected by steering diodes to either supply. If any
pin is driven beyond the LTC6605-7’s supply voltage, the excess input
current (current in excess of what it takes to drive that pin to the supply
rail) should be limited to less than 10mA.
Note 3: A heat sink may be required to keep the junction temperature
below the Absolute Maximum Rating when the output is shorted
indenitely. Long-term application of output currents in excess of the
Absolute Maximum Ratings may impair the life of the device.
Note 4: Both the LTC6605C and the LTC6605I are guaranteed functional
over the operating temperature range –40°C to 85°C.
Note 5: The LTC6605C is guaranteed to meet specied performance
from 0°C to 70°C. The LTC6605C is designed, characterized and
expected to meet specied performance from –40°C to 85°C, but is
not tested or QA sampled at these temperatures. The LTC6605I is
guaranteed to meet specied performance from –40°C to 85°C.
Note 6: Output referred voltage offset is a function of gain. To determine
output referred voltage offset, or output voltage offset drift, multiply VOS
by the noise gain (1 + GAIN). See Figure 3.
Note 7: Input bias current is dened as the average of the currents
owing into the noninverting and inverting inputs of the internal amplier
and is calculated from measurements made at the pins of the IC. Input
offset current is dened as the difference of the currents owing into
the noninverting and inverting inputs of the internal amplier and is
calculated from measurements made at the pins of the IC.
SYMBOL
PARAMETER
CONDITIONS
MIN
TYP
MAX
UNITS
Gain
Filter Gain
ΔVIN = ±0.125V, DC
VINDIFF = 0.5VP-P, f = 3.5MHz
VINDIFF = 0.5VP-P, f = 5.25MHz
VINDIFF = 0.5VP-P, f = 7MHz
VINDIFF = 0.5VP-P, f = 14MHz
VINDIFF = 0.5VP-P, f = 35MHz
l
–0.25
–1.2
–2.55
–4.25
–11.95
–28
±0.05
–0.84
–2.08
–3.71
–11.3
–25.9
0.25
–0.5
–1.65
–3.2
–10.7
–25
dB
Phase
Filter Phase
ΔVIN = ±0.125V, DC
VINDIFF = 0.5VP-P, f = 3.5MHz
VINDIFF = 0.5VP-P, f = 5.25MHz
VINDIFF = 0.5VP-P, f = 7MHz
0
–43.4
–63.8
–81.9
Deg
ΔGain
Gain Match (Channel-to-Channel)
ΔVIN = ±0.125V, DC
VINDIFF = 0.5VP-P, f = 3.5MHz
VINDIFF = 0.5VP-P, f = 5.25MHz
VINDIFF = 0.5VP-P, f = 7MHz
l
–0.2
–0.3
–0.35
±0.05
0.2
0.3
0.35
dB
ΔPhase
Phase Match (Channel-to-Channel)
VINDIFF = 0.5VP-P, f = 3.5MHz
VINDIFF = 0.5VP-P, f = 5.25MHz
VINDIFF = 0.5VP-P, f = 7MHz
l
–1.0
–1.2
±0.2
1.0
1.2
Deg
4V/V Gain
Filter Gain in 4V/V Conguration
Inputs at ±IN1 Pins, ±IN4 Pins Floating
ΔVIN = ±0.125V, DC
l
11.85
12
12.25
dB
Channel Separation
VINDIFF = 1VP-P, f = 3.5MHz
–100
dB
fO TC
Filter Cut-Off Frequency Temperature
Coefcient
BIAS = V+
BIAS = Floating
–55
–180
ppm/°C
Noise
Integrated Output Noise
(BW = 10kHz to 14MHz)
61
μVRMS
Input Referred Noise Density (f = 1MHz) BIAS = V+
Figure 4, Gain = 1
Figure 4, Gain = 4
Figure 4, Gain = 5
21
5.2
4.2
nV/√Hz
en
Voltage Noise Density Referred to
Op Amp Inputs (f = 1MHz)
BIAS = V+
BIAS = Floating
2.1
2.6
nV/√Hz
in
Current Noise Density Referred to
Op Amp Inputs (f = 1MHz)
BIAS = V+
BIAS = Floating
3
2.1
pA/√Hz
HD2
2nd Harmonic Distortion
fIN = 3MHz; VIN = 2VP-P Single-Ended
BIAS = V+
BIAS = Floating, RLOAD = 400Ω
–96
–80
dBc
HD3
3rd Harmonic Distortion
fIN = 3MHz; VIN = 2VP-P Single-Ended
BIAS = V+
BIAS = Floating, RLOAD = 400Ω
–114
–95
dBc
相關PDF資料 |
PDF描述 |
|---|---|
| LTC6605IDJC-14#PBF | IC FILTER 14MHZ DUAL 22-DFN |
| LTC6605IDJC-10#PBF | IC FILTER 10MHZ DUAL 22-DFN |
| LTC1562CG | IC FILTER UNIVRSL RC QUAD 20SSOP |
| LTC1562CG-2 | IC FILTER UNIVRSL RC QUAD 20SSOP |
| LTC1562CN#PBF | IC FILTER UNIV RC QUAD LN 16DIP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC6605IDJC-7-TRPBF | 制造商:LINER 制造商全稱:Linear Technology 功能描述:Dual Matched 7MHz Filter with Low Noise, Low Distortion Differential Amplifi er |
| LTC660CN8 | 功能描述:IC REG DBL INV ADJ 0.1A 8DIP RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:2,500 系列:- 類型:升壓（升壓） 輸出類型:可調式 輸出數:1 輸出電壓:1.24 V ~ 30 V 輸入電壓:1.5 V ~ 12 V PWM 型:電流模式，混合 頻率 - 開關:600kHz 電流 - 輸出:500mA 同步整流器:無 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-SOIC（0.154"，3.90mm 寬） 包裝:帶卷 (TR) 供應商設備封裝:8-SOIC |
| LTC660CN8#PBF | 功能描述:IC REG DBL INV ADJ 0.1A 8DIP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:2,500 系列:- 類型:升壓（升壓） 輸出類型:可調式 輸出數:1 輸出電壓:1.24 V ~ 30 V 輸入電壓:1.5 V ~ 12 V PWM 型:電流模式，混合 頻率 - 開關:600kHz 電流 - 輸出:500mA 同步整流器:無 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-SOIC（0.154"，3.90mm 寬） 包裝:帶卷 (TR) 供應商設備封裝:8-SOIC |
| LTC660CS8 | 功能描述:IC REG DBL INV ADJ 0.1A 8SOIC RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:2,500 系列:- 類型:降壓（降壓） 輸出類型:固定 輸出數:1 輸出電壓:1.2V，1.5V，1.8V，2.5V 輸入電壓:2.7 V ~ 20 V PWM 型:- 頻率 - 開關:- 電流 - 輸出:50mA 同步整流器:是 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:10-TFSOP，10-MSOP（0.118"，3.00mm 寬）裸露焊盤 包裝:帶卷 (TR) 供應商設備封裝:10-MSOP 裸露焊盤 |
| LTC660CS8#PBF | 功能描述:IC REG DBL INV ADJ 0.1A 8SOIC RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:2,500 系列:- 類型:降壓（降壓） 輸出類型:固定 輸出數:1 輸出電壓:1.2V，1.5V，1.8V，2.5V 輸入電壓:2.7 V ~ 20 V PWM 型:- 頻率 - 開關:- 電流 - 輸出:50mA 同步整流器:是 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:10-TFSOP，10-MSOP（0.118"，3.00mm 寬）裸露焊盤 包裝:帶卷 (TR) 供應商設備封裝:10-MSOP 裸露焊盤 |
發布緊急采購，3分鐘左右您將得到回復。