- 您現在的位置：買賣IC網 > PDF目錄377778 > LTC4260ISW (LINEAR TECHNOLOGY CORP) Positive High Voltage Hot Swap Controller with I2C Compatible Monitoring PDF資料下載
參數資料
| 型號： | LTC4260ISW |
| 廠商： | LINEAR TECHNOLOGY CORP |
| 元件分類： | 電源管理 |
| 英文描述： | Positive High Voltage Hot Swap Controller with I2C Compatible Monitoring |
| 中文描述： | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO24 |
| 封裝： | 0.300 INCH, PLASTIC, SO-24 |
| 文件頁數： | 12/28頁 |
| 文件大?。?/td> | 266K |
| 代理商： | LTC4260ISW |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁當前第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁
LTC4260
12
4260f
APPLICATIOU
W
U
U
As the SOURCE voltage rises, so will the FB pin which is
monitoring it. If the voltage across the current sense
resistor R
S
gets too high, the inrush current will then be
limited by the internal current limit circuitry. Once the FB
pin crosses its 3.5V threshold, the GPIO pin, in its default
configuration, will cease to pull low and indicate that the
power is now good.
Turn-Off Sequence
The switch can be turned off by a variety of conditions. A
normal turn-off is initiated by the ON pin going low or a
serial bus turn-off command. Additionally, several fault
conditions will turn off the switch. These include an input
overvoltage (OV pin), input undervoltage (UV pin), over-
current circuit breaker (SENSE pin) or BD_PRST going
high. Writing a logic one into the UV, OV or overcurrent
fault bits will also turn off the switch if their autoretry bits
are set to false.
Normally the switch is turned off with a 1mA current
pulling down the GATE pin to ground. With the switch
turned off, the SOURCE voltage drops and when the FB pin
crosses below its threshold, GPIO pulls low to indicate
that the output power is no longer good.
If the V
DD
pin falls below 7.5V for greater than 5
μ
s or
INTV
CC
drops below 3.8V for greater than 1
μ
s, a fast
shutdown of the switch is initiated. The GATE pin is pulled
down with a 600mA current to the SOURCE pin.
Overcurrent Fault
The LTC4260 features an adjustable current limit with
foldback that protects against short circuits or excessive
load current. To protect against excessive power dissipa-
tion in the switch during active current limit, the available
current is reduced as a function of the output voltage
sensed by the FB pin. The device also features a variable
overcurrent response time. A graph in the Typical Perfor-
mance curves shows the delay from a voltage step at the
SENSE pin until the GATE voltage starts falling, as a
function of overdrive.
An overcurrent fault occurs when the current limit circuitry
has been engaged for longer than the time-out delay set by
the TIMER pin. Current limiting begins when the current
sense voltage between the V
DD
and SENSE pins reaches
20mV to 50mV (depending on the foldback). The GATE pin
is then brought down with a 600mA GATE-to-SOURCE
current. The voltage on the GATE is regulated in order to
limit the current sense voltage to less than 50mV. At this
point, a circuit breaker time delay starts by charging the
external timing capacitor from the TIMER pin with a 100
μ
A
pull-up current. If the TIMER pin reaches its 1.2V thresh-
old, the external switch turns off (with a 1mA current from
GATE to ground). The overcurrent present bit, C2, and the
overcurrent fault bit, D2, are set at this time.
The circuit breaker time delay is given by:
t
CB
= C
T
12 [ms/
μ
F]
After the switch is turned off, the TIMER pin begins
discharging the timing capacitor with a 2
μ
A pull-down
current. When the TIMER pin reaches its 0.2V threshold,
the overcurrent present bit, C2, is cleared, and the switch
will be allowed to turn on again if the overcurrent fault has
been cleared. However, if the overcurrent autoretry bit,
A2, has been set then the switch turns on again automati-
cally (without resetting the overcurrent fault). Use a mini-
mum value of 0.1nF for C
T
.
The waveform in Figure 3 shows how the output latches off
following a short circuit. The drop across the sense
resistor is held at 20mV as the timer ramps up.
Figure 2. Supply Turn-On
V
DD
+ 13V
V
DD
4260 F02
t
1
t
2
GATE
V
OUT
SLOPE = 18
μ
A/C1
相關PDF資料 |
PDF描述 |
|---|---|
| LTC4260IUH | Positive High Voltage Hot Swap Controller with I2C Compatible Monitoring |
| LTC4300A-1 | Hot Swappable 2-Wire Bus Buffers |
| LTC4300A-1CMS8 | Hot Swappable 2-Wire Bus Buffers |
| LTC4300A-1IMS8 | Hot Swappable 2-Wire Bus Buffers |
| LTC4300A-2 | 14/PG/CL/N FLNG |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC4260ISW#PBF | 功能描述:IC HOT SWAP CNTRL I2C 24-SOIC RoHS:是 類別:集成電路 (IC) >> PMIC - 熱交換 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:119 系列:- 類型:熱交換控制器 應用:通用型，PCI Express? 內部開關:無 電流限制:- 電源電壓:3.3V，12V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:80-TQFP 供應商設備封裝:80-TQFP（12x12） 包裝:托盤 產品目錄頁面:1423 (CN2011-ZH PDF) |
| LTC4260ISW#TRPBF | 功能描述:IC HOT SWAP CNTRL I2C 24-SOIC RoHS:是 類別:集成電路 (IC) >> PMIC - 熱交換 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:119 系列:- 類型:熱交換控制器 應用:通用型，PCI Express? 內部開關:無 電流限制:- 電源電壓:3.3V，12V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:80-TQFP 供應商設備封裝:80-TQFP（12x12） 包裝:托盤 產品目錄頁面:1423 (CN2011-ZH PDF) |
| LTC4260IUH | 制造商:Linear Technology 功能描述:Hot Swap Controller 1-CH 80V 32-Pin QFN EP |
| LTC4260IUH#PBF | 功能描述:IC HOT SWAP CNTRL I2C 32-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 熱交換 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:119 系列:- 類型:熱交換控制器 應用:通用型，PCI Express? 內部開關:無 電流限制:- 電源電壓:3.3V，12V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:80-TQFP 供應商設備封裝:80-TQFP（12x12） 包裝:托盤 產品目錄頁面:1423 (CN2011-ZH PDF) |
| LTC4260IUH#TRPBF | 功能描述:IC HOT SWAP CNTRL I2C 32-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 熱交換 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:119 系列:- 類型:熱交換控制器 應用:通用型，PCI Express? 內部開關:無 電流限制:- 電源電壓:3.3V，12V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:80-TQFP 供應商設備封裝:80-TQFP（12x12） 包裝:托盤 產品目錄頁面:1423 (CN2011-ZH PDF) |
發布緊急采購，3分鐘左右您將得到回復。