- 您現在的位置：買賣IC網 > PDF目錄224115 > LTC4050EMS-4.2#PBF (LINEAR TECHNOLOGY CORP) Lithium-Ion Linear Battery Charger Controller with Thermistor Interface; Package: MSOP; No of Pins: 10; Temperature Range: -40°C to +125°C PDF資料下載
參數資料
| 型號： | LTC4050EMS-4.2#PBF |
| 廠商： | LINEAR TECHNOLOGY CORP |
| 元件分類： | 電源管理 |
| 英文描述： | Lithium-Ion Linear Battery Charger Controller with Thermistor Interface; Package: MSOP; No of Pins: 10; Temperature Range: -40°C to +125°C |
| 中文描述： | 2-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO10 |
| 封裝： | PLASTIC, MSOP-10 |
| 文件頁數： | 10/12頁 |
| 文件大小： | 182K |
| 代理商： | LTC4050EMS-4.2#PBF |
7
LTC4050
4050f
at the CHRG pin and connect a weak current source to
ground, indicating that the battery is nearly fully charged
(C/10 occurs at approximately 94% charge).
An external capacitor on the TIMER pin sets the total
charge time. After a time-out occurs, the charge cycle is
terminated and the CHRG pin is forced high impedance. To
restart the charge cycle, remove the input voltage and
reapply it, or momentarily float the PROG pin.
Replacing the battery when charging will cause the timer
to be reset if the cell voltage of the new battery is below
3.88V (for 4.1V cells) or 3.98V (for 4.2V cells). If the
voltage is above 3.88V(for 4.1V cells) or 3.98V (for 4.2V
cells) the timer will continue for the remaining charge
time. In the case when a time out has occurred, a new
battery with a cell voltage of less than 3.88V or 3.98V can
be inserted and charged automatically with the full pro-
grammed charge time.
For batteries like lithium-ion that require accurate final
float voltage, the internal 2.47V reference, voltage ampli-
fier and the resistor divider provide regulation with
±1%
(max) accuracy.
The charger can be shut down by floating the PROG pin.
An internal current source will pull it high and clamp at
3.5V.
When the input voltage is not present, the charger goes
into a sleep mode, dropping ICC to 5A. This greatly
reduces the current drain on the battery and increases the
standby time.
OPERATIO
U
The LTC4050 is a linear battery charger controller. The
charge current is programmed by the combination of a
program resistor (RPROG) from the PROG pin to ground
and a sense resistor (RSENSE) between the VCC and SENSE
pins. RPROG sets a program current through an internal
trimmed 800
resistor setting up a voltage drop from VCC
to the input of the current amplifier (CA). The current
amplifier servos the gate of the external P-channel MOSFET
to force the same voltage drop across RSENSE which sets
the charge current. When the voltage at the BAT pin
approaches the preset float voltage, the voltage amplifier
(VA) will start sinking current which reduces the voltage
drop across RSENSE, thus reducing the charge current.
A charge cycle begins when the voltage at VCC pin rises
above the UVLO level, a program resistor is connected
from the PROG pin to ground, and the NTC thermistor
temperature is between 0
°C and 50°C. At the beginning of
the charge cycle, if the battery voltage is below 2.49V, the
charger goes into trickle charge mode. The trickle charge
current is 10% of the full-scale current. If the cell voltage
stays low for one quarter of the total charge time, the
charge sequence will terminate.
The charger goes into the fast charge constant-current
mode after the voltage on the BAT pin rises above 2.49V.
In constant-current mode, the charge current is set by the
combination of RSENSE and RPROG.
When the battery approaches the final float voltage, the
charge current will begin to decrease. When the current
drops to 10% of the full-scale charge current, an internal
comparator will turn off the pull-down N-channel MOSFET
相關PDF資料 |
PDF描述 |
|---|---|
| LTC4052EMS8E-4.2#PBF | Lithium-Ion Battery Pulse Charger with Overcurrent Protection; Package: MSOP; No of Pins: 8; Temperature Range: -40°C to +125°C |
| LTC4052EMS8E-4.2#TRPBF | Lithium-Ion Battery Pulse Charger with Overcurrent Protection; Package: MSOP; No of Pins: 8; Temperature Range: -40°C to +125°C |
| LTC4053EDD-4.2#PBF | USB Compatible Lithium-Ion Battery Charger with Thermal Regulation; Package: DFN; No of Pins: 10; Temperature Range: -40°C to +125°C |
| LTC4053EMSE-4.2#PBF | USB Compatible Lithium-Ion Battery Charger with Thermal Regulation; Package: MSOP; No of Pins: 10; Temperature Range: -40°C to +125°C |
| LTC4053EMSE-4.2#TRPBF | USB Compatible Lithium-Ion Battery Charger with Thermal Regulation; Package: MSOP; No of Pins: 10; Temperature Range: -40°C to +125°C |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC4052 | 制造商:LINER 制造商全稱:Linear Technology 功能描述:150mA Standalone Linear Li-Ion Battery Charger in ThinSOT |
| LTC4052-4.2 | 制造商:LINER 制造商全稱:Linear Technology 功能描述:Lithium-Ion Battery Pulse Charger with Overcurrent Protection |
| LTC4052-42 | 制造商:LINEAR 制造商全稱:LINEAR 功能描述:Lithium-Ion Battery Pulse Charger with Overcurrent Protection |
| LTC4052EMS8E-4.2 | 功能描述:IC CHARGER PULSE LI-ION 8-MSOP RoHS:否 類別:集成電路 (IC) >> PMIC - 電池管理 系列:- 標準包裝:61 系列:- 功能:電源管理 電池化學:鋰離子（Li-Ion）、鋰聚合物（Li-Pol） 電源電壓:4.35 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:22-WFDFN 裸露焊盤 供應商設備封裝:22-DFN（6x3）裸露焊盤 包裝:管件 |
| LTC4052EMS8E-4.2#PBF | 功能描述:IC CHARGER PULSE LI-ION 8-MSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 電池管理 系列:- 其它有關文件:STC3100 View All Specifications 特色產品:STC3100 - Battery Monitor IC 標準包裝:4,000 系列:- 功能:燃料，電量檢測計/監控器 電池化學:鋰離子（Li-Ion） 電源電壓:2.7 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-TSSOP，8-MSOP（0.118"，3.00mm 寬） 供應商設備封裝:8-MiniSO 包裝:帶卷 (TR) 其它名稱:497-10526-2 |
發布緊急采購，3分鐘左右您將得到回復。