- 您現在的位置：買賣IC網 > PDF目錄30771 > LTC3862IFE#PBF (LINEAR TECHNOLOGY CORP) DUAL SWITCHING CONTROLLER, 500 kHz SWITCHING FREQ-MAX, PDSO24 PDF資料下載
參數資料
| 型號： | LTC3862IFE#PBF |
| 廠商： | LINEAR TECHNOLOGY CORP |
| 元件分類： | 穩壓器 |
| 英文描述： | DUAL SWITCHING CONTROLLER, 500 kHz SWITCHING FREQ-MAX, PDSO24 |
| 封裝： | 4.40 MM, LEAD FREE, PLASTIC, TSSOP-24 |
| 文件頁數： | 29/40頁 |
| 文件大?。?/td> | 613K |
| 代理商： | LTC3862IFE#PBF |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁當前第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁
LTC3862
35
3862fb
APPLICATIONS INFORMATION
10. The output resistor divider should be located as
close as possible to the IC, with the bottom resistor
connected between FB and SGND. The PCB trace
connecting the top resistor to the upper terminal of
the output capacitor should avoid any high frequency
switching nodes.
11. Since the inductor acts like a current source in a
peak current mode control topology, its placement
on the board is less critical than the high di/dt com-
ponents.
12. The SENSE+ and SENSE– PCB traces should be routed
parallel to one another with minimum spacing in be-
tween all the way to the sense resistor. These traces
should avoid any high frequency switching nodes in
the layout. These PCB traces should also be Kelvin-
connected to the interior of the sense resistor pads,
in order to avoid sensing errors due to parasitic PCB
resistance IR drops.
13. If an external RC lter is used between the sense
resistor and the SENSE+ and SENSE– pins, these lter
components should be placed as close as possible to
the SENSE+ and SENSE– pins of the IC. Ensure that
the SENSE– line is connected to the ground only at the
point where the current sense resistor is grounded.
14. Keep the MOSFET drain nodes (SW1, SW2) away
from sensitive small-signal nodes, especially from
the opposite channel’s current-sensing signals. The
SW nodes can have slew rates in excess of 1V/ns
relative to ground and should therefore be kept on
the “output side” of the LTC3862.
15. Check the stress on the power MOSFETs by indepen-
dently measuring the drain-to-source voltages directly
across the devices terminals. Beware of inductive
ringing that could exceed the maximum voltage rating
of the MOSFET. If this ringing cannot be avoided and
exceeds the maximum rating of the device, choose
a higher voltage rated MOSFET or consider using a
snubber.
16. When synchronizing the LTC3862 to an external clock,
use a low impedance source such as a logic gate to
drive the SYNC pin and keep the lead as short as
possible.
相關PDF資料 |
PDF描述 |
|---|---|
| LTC3862HFE#PBF | DUAL SWITCHING CONTROLLER, 500 kHz SWITCHING FREQ-MAX, PDSO24 |
| LTC3862EGN#TRPBF | DUAL SWITCHING CONTROLLER, 500 kHz SWITCHING FREQ-MAX, PDSO24 |
| LTC3862IUH#PBF | DUAL SWITCHING CONTROLLER, 500 kHz SWITCHING FREQ-MAX, QCC24 |
| LTC3862EGN#PBF | DUAL SWITCHING CONTROLLER, 500 kHz SWITCHING FREQ-MAX, PDSO24 |
| LTC3862EUH#TRPBF | DUAL SWITCHING CONTROLLER, 500 kHz SWITCHING FREQ-MAX, QCC24 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC3862IGN#PBF | 功能描述:IC REG CTRLR BST PWM CM 24-SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 特色產品:LM3753/54 Scalable 2-Phase Synchronous Buck Controllers 標準包裝:1 系列:PowerWise® PWM 型:電壓模式 輸出數:1 頻率 - 最大:1MHz 占空比:81% 電源電壓:4.5 V ~ 18 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-5°C ~ 125°C 封裝/外殼:32-WFQFN 裸露焊盤 包裝:Digi-Reel® 產品目錄頁面:1303 (CN2011-ZH PDF) 其它名稱:LM3754SQDKR |
| LTC3862IGN#TRPBF | 功能描述:IC REG CTRLR BST PWM CM 24-SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:96% 電源電壓:4 V ~ 36 V 降壓:無 升壓:是 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:24-WQFN 裸露焊盤 包裝:帶卷 (TR) |
| LTC3862IGN-1#PBF | 功能描述:IC REG CTRLR BST PWM CM 24-SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:96% 電源電壓:4 V ~ 36 V 降壓:無 升壓:是 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:24-WQFN 裸露焊盤 包裝:帶卷 (TR) |
| LTC3862IGN-1#TRPBF | 功能描述:IC REG CTRLR BST PWM CM 24-SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:4,500 系列:PowerWise® PWM 型:控制器 輸出數:1 頻率 - 最大:1MHz 占空比:95% 電源電壓:2.8 V ~ 5.5 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:6-WDFN 裸露焊盤 包裝:帶卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名稱:LM1771SSDX |
| LTC3862IGN-2#PBF | 功能描述:IC REG CTRLR BST PWM CM 24-SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:96% 電源電壓:4 V ~ 36 V 降壓:無 升壓:是 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:24-WQFN 裸露焊盤 包裝:帶卷 (TR) |
發布緊急采購，3分鐘左右您將得到回復。