參數資料
型號： LTC3856IFE#PBF
廠商： LINEAR TECHNOLOGY CORP
元件分類： 穩壓器
英文描述： SWITCHING CONTROLLER, PDSO38
封裝： 4.4 MM, LEAD FREE, PLASTIC, TSSOP-38
文件頁數： 40/40頁
文件大?。?/td> 2222K
代理商： LTC3856IFE#PBF
LTC3856
3856f
pin FuncTions
FREQ (Pin 1/Pin 29): Frequency Setting Pin. A resistor
to ground sets the operating frequency of the controller.
This pin can also be driven with a DC voltage to vary the
frequency of the internal oscillator.
RUN (Pin 2/Pin 30): Run Control Input. A voltage above
1.22V on this pin turns on the IC. There is a 1A pull-up
current for this pin. Once the RUN pin rises above 1.22V,
an additional 4.5A pull-up current is added to the pin.
SENSE1+, SENSE2+ (Pins 3, 13/Pins 31, 7): Current
Sense Comparator Inputs. The (+) inputs to the current
comparators are normally connected to DCR sensing
networks or current sensing resistors.
SENSE1–, SENSE2– (Pins 4, 14/Pins 32, 8): Current
Sense Comparator Inputs. The (–) inputs to the current
comparators are connected to the outputs.
NC (Pins 5, 25, 34) TSSOP Package: No Connections.
TK/SS (Pin 6/Pin 1): Output Voltage Tracking and Soft-
Start Input. When one particular IC is configured to be the
master of two ICs, a capacitor to ground at this pin sets
the ramp rate for the master IC’s output voltage. When the
IC is configured to be the slave of two ICs, the VFB voltage
of the master IC is reproduced by a resistor divider and
applied to this pin. An internal soft-start current of 1.25A
is charging this pin.
VFB (Pin 7/Pin 2): Error Amplifier Feedback Input. This
pin receives the remotely sensed feedback voltage from
an external resistive divider.
ITH (Pin 8/Pin 3): Current Control Threshold and Error
Amplifier Compensation Point. Each associated channels’
current comparator tripping threshold increases with ITH
control voltage.
SGND(Pin9/Pin33):SignalGroundandPowerGround.All
small-signal components and compensation components
should connect to this ground, which in turn connects to
PGND at one point.
AVP (Pin 10/Pin 4): Active Voltage Positioning Load Slope
Programming Pin. A resistor between this pin and the
DIFFP pin sets the load slope.
ITEMP (Pin 11/Pin 5): Input to the Temperature Sensing
Circuit. Connect this pin to an external NTC (negative
(TSSOP/QFN)
temperature coefficient) resistor placed near the heat
source on the PCB board (e.g., inductors) changes the
controller’s current limit with temperature.
PHASMD(Pin12/Pin6):ConnectthispintoSGND,INTVCC,
or float this pin to select the phase of CLKOUT to be 60°,
120° and 90°, respectively.
DIFFP (Pin 15/Pin 9): Positive Input of Remote Sensing
Differential Amplifier. Connect this directly to the remote
load voltage.
DIFFN (Pin 16/Pin 10): Negative Input of Remote Sens-
ing Differential Amplifier. Connect this pin to the negative
terminal of output load capacitors.
DIFFOUT (Pin 17/Pin 11): Output of Remote Sensing
Differential Amplifier. Connect this pin to VFB through a
resistive divider.
ISET (Pin 18/Pin 12): Stage Shedding Mode Comparator
and Burst Mode Comparator Programming Pin. A resistor
to ground programs the threshold of the Stage Shedding
mode comparator or Burst Mode comparator threshold
and current limit.
ILIM (Pin 19/Pin 13): Current Comparator Sense Volt-
age Range Input. This pin is to be programmed to
SGND, FLOAT or INTVCC to set the maximum current
sense threshold to one of three different levels for both
comparators.
MODE (Pin 20/Pin 14): Forced Continuous Mode,
Burst Mode Operation or Stage Shedding Mode Selec-
tion Pin. Connect this pin to SGND to force IC in
continuous mode of operation. Connect to INTVCC to
enable Stage Shedding mode operation. Leaving the pin
floating enables Burst Mode operation.
PGOOD (Pin 21/Pin 15): Power Good Indicator Output.
Open-drain logic out that is pulled to ground when the
output exceeds the ±10% regulation window, after the
internal 20s power-bad mask timer expires.
EXTVCC (Pin 28/Pin 20): External Power Input to an
Internal Switch Connected to INTVCC. This switch closes
and supplies the IC power, bypassing the internal low
dropout regulator, whenever EXTVCC is higher than 4.7V.
Do not exceed 6V on this pin and ensure VIN > VEXTVCC
at all times.
相關PDF資料
PDF描述
LTC3856EFE#PBF SWITCHING CONTROLLER, PDSO38
LTC3856IUH#TRPBF SWITCHING CONTROLLER, PQCC38
LTC3856EFE#TRPBF SWITCHING CONTROLLER, PDSO38
LTC3860IUH#PBF DUAL SWITCHING CONTROLLER, 1250 kHz SWITCHING FREQ-MAX, PQCC32
LTC3862HUH#TRPBF DUAL SWITCHING CONTROLLER, 500 kHz SWITCHING FREQ-MAX, QCC24
相關代理商/技術參數
參數描述
LTC3856IUH#PBF 功能描述:IC REG CTRLR BUCK PWM CM 32WFQFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:PolyPhase® 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:96% 電源電壓:4 V ~ 36 V 降壓:無 升壓:是 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:24-WQFN 裸露焊盤 包裝:帶卷 (TR)
LTC3856IUH#TRPBF 功能描述:IC REG CTRLR BUCK PWM CM 38-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:PolyPhase® 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:96% 電源電壓:4 V ~ 36 V 降壓:無 升壓:是 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:24-WQFN 裸露焊盤 包裝:帶卷 (TR)
LTC3857EGN-1#PBF 功能描述:IC REG CTRLR BUCK PWM CM 28-SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:PolyPhase® 特色產品:LM3753/54 Scalable 2-Phase Synchronous Buck Controllers 標準包裝:1 系列:PowerWise® PWM 型:電壓模式 輸出數:1 頻率 - 最大:1MHz 占空比:81% 電源電壓:4.5 V ~ 18 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-5°C ~ 125°C 封裝/外殼:32-WFQFN 裸露焊盤 包裝:Digi-Reel® 產品目錄頁面:1303 (CN2011-ZH PDF) 其它名稱:LM3754SQDKR
LTC3857EGN-1#TRPBF 功能描述:IC REG CTRLR BUCK PWM CM 28-SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:PolyPhase® 標準包裝:4,500 系列:PowerWise® PWM 型:控制器 輸出數:1 頻率 - 最大:1MHz 占空比:95% 電源電壓:2.8 V ~ 5.5 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:6-WDFN 裸露焊盤 包裝:帶卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名稱:LM1771SSDX
LTC3857EUH#PBF 功能描述:IC REG CTRLR BUCK PWM CM 32-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:PolyPhase® 特色產品:LM3753/54 Scalable 2-Phase Synchronous Buck Controllers 標準包裝:1 系列:PowerWise® PWM 型:電壓模式 輸出數:1 頻率 - 最大:1MHz 占空比:81% 電源電壓:4.5 V ~ 18 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-5°C ~ 125°C 封裝/外殼:32-WFQFN 裸露焊盤 包裝:Digi-Reel® 產品目錄頁面:1303 (CN2011-ZH PDF) 其它名稱:LM3754SQDKR
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*