- 您現在的位置：買賣IC網 > PDF目錄44993 > LTC3810EG (LINEAR TECHNOLOGY CORP) SWITCHING CONTROLLER, PDSO28 PDF資料下載
參數資料
| 型號： | LTC3810EG |
| 廠商： | LINEAR TECHNOLOGY CORP |
| 元件分類： | 穩壓器 |
| 英文描述： | SWITCHING CONTROLLER, PDSO28 |
| 封裝： | 5.30 MM, PLASTIC, SSOP-28 |
| 文件頁數： | 36/36頁 |
| 文件大?。?/td> | 495K |
| 代理商： | LTC3810EG |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁當前第36頁
LTC3810
9
3810fb
ION (Pin 1): On-Time Current Input. Tie a resistor from VIN
to this pin to set the one-shot timer current and thereby
set the switching frequency.
VON (Pin 4): On-Time Voltage Input. Voltage trip point for
the on-time comparator. Tying this pin to the output voltage
or an external resistive divider from the output makes the
on-time proportional to VOUT. The comparator defaults to
0.7V when the pin is grounded and defaults to 2.4V when
the pin is connected to INTVCC. Tie this pin to INTVCC in
high VOUT applications to use a lower RON value.
VRNG (Pin 5): Sense Voltage Limit Set. The voltage at this
pin sets the nominal sense voltage at maximum output
current and can be set from 0.5V to 2V by a resistive
divider from INTVCC. The nominal sense voltage defaults
to 95mV when this pin is tied to ground, and 215mV when
tied to INTVCC.
PGOOD (Pin 6): Power Good Output. Open-drain logic
output that is pulled to ground when the output voltage
is not between ±10% of the regulation point. The output
voltage must be out of regulation for at least 120μs before
the power good output is pulled to ground.
MODE/SYNC (Pin 7): Pulse Skip Mode Enable/Sync Pin.
This multifunction pin provides pulse skip mode enable/
disable control and an external clock input to the phase
detector. Pulling this pin below 0.8V or to an external
logic-level synchronization signal disables pulse skip mode
operation and forces continuous operation. Pulling this
pin above 0.8V enables pulse skip mode operation. For a
clock input, the phase-locked loop will force the rising top
gate signal to be synchronized with the rising edge of the
clock signal.This pin can also be connected to a feedback
resistor divider from a secondary winding on the inductor
to regulate a second output voltage.
ITH (Pin 8): Error Amplier Compensation Point and Cur-
rent Control Threshold. The current comparator threshold
increases with control voltage. The voltage ranges from
0V to 2.6V with 1.2V corresponding to zero sense voltage
(zero current).
VFB(Pin9):FeedbackInput.ConnectVFBthrougharesistor
divider network to VOUT to set the output voltage.
PLL/LPF (Pin 10): The phase-locked loop’s lowpass lter
is tied to this pin. The voltage at this pin defaults to 1.2V
when the IC is not synchronized with an external clock at
the MODE/SYNC pin.
SS/TRACK (Pin 11): Soft-Start/Tracking Input. For soft-
start, a capacitor to ground at this pin sets the ramp rate of
the output voltage (approximately 0.6s/μF). For coincident
or ratiometric tracking, connect this pin to a resistive divider
between the voltage to be tracked and ground.
SGND (Pin 12): Signal Ground. All small-signal compo-
nents should connect to this ground and eventually connect
to PGND at one point.
SHDN (Pin 13): Shutdown Pin. Pulling this pin below 1.5V
will shut down the LTC3810, turn off both of the external
MOSFET switches and reduce the quiescent supply cur-
rent to 240μA.
UVIN (Pin 14): UVLO Input. This pin is input to the internal
UVLO and is compared to an internal 0.8V reference. An
external resistor divider is connected to this pin and the
input supply to program the undervoltage lockout voltage.
When UVIN is less than 0.8V, the LTC3810 is shut down.
NDRV (Pin 15): Drive Output for External Pass Device of
the Linear Regulator for INTVCC. Connect to the gate of
an external NMOS pass device and a pull-up resistor to
the input voltage VIN.
EXTVCC (Pin 16): External Driver Supply Voltage. When
this voltage exceeds 6.7V, an internal switch connects
this pin to INTVCC through an LDO and turns off the exter-
nal MOSFET connected to NDRV, so that controller and
gate drive are drawn from EXTVCC.
INTVCC (Pin 17): Main Supply Pin. All internal circuits
except the output drivers are powered from this pin.
INTVCC should be bypassed to ground (Pin 10) with at
least a 0.1μF capacitor in close proximity to the LTC3810.
DRVCC (Pin 18): Driver Supply Pin. DRVCC supplies power
to the BG output driver. This pin is normally connected to
INTVCC. DRVCC should be bypassed to BGRTN (Pin 20)
with a low ESR (X5R or better) 1μF capacitor in close
proximity to the LTC3810.
PIN FUNCTIONS
相關PDF資料 |
PDF描述 |
|---|---|
| LTC3812EFE-5 | 1 A SWITCHING CONTROLLER, PDSO16 |
| LTC3812IFE-5#TR | 1 A SWITCHING CONTROLLER, PDSO16 |
| LTC3812EFE-5#TR | 1 A SWITCHING CONTROLLER, PDSO16 |
| LTC3812IFE-5 | 1 A SWITCHING CONTROLLER, PDSO16 |
| LTC3831IGN | SWITCHING CONTROLLER, 500 kHz SWITCHING FREQ-MAX, PDSO16 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC3810EG#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 28-SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 特色產品:LM3753/54 Scalable 2-Phase Synchronous Buck Controllers 標準包裝:1 系列:PowerWise® PWM 型:電壓模式 輸出數:1 頻率 - 最大:1MHz 占空比:81% 電源電壓:4.5 V ~ 18 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-5°C ~ 125°C 封裝/外殼:32-WFQFN 裸露焊盤 包裝:Digi-Reel® 產品目錄頁面:1303 (CN2011-ZH PDF) 其它名稱:LM3754SQDKR |
| LTC3810EG#TRPBF | 功能描述:IC REG CTRLR BUCK PWM CM 28-SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:96% 電源電壓:4 V ~ 36 V 降壓:無 升壓:是 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:24-WQFN 裸露焊盤 包裝:帶卷 (TR) |
| LTC3810EUH-5#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 32-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:4,500 系列:PowerWise® PWM 型:控制器 輸出數:1 頻率 - 最大:1MHz 占空比:95% 電源電壓:2.8 V ~ 5.5 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:6-WDFN 裸露焊盤 包裝:帶卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名稱:LM1771SSDX |
| LTC3810EUH-5#TRPBF | 功能描述:IC REG CTRLR BUCK PWM CM 32-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:96% 電源電壓:4 V ~ 36 V 降壓:無 升壓:是 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:24-WQFN 裸露焊盤 包裝:帶卷 (TR) |
| LTC3810HUH-5#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 32-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:4,500 系列:PowerWise® PWM 型:控制器 輸出數:1 頻率 - 最大:1MHz 占空比:95% 電源電壓:2.8 V ~ 5.5 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:6-WDFN 裸露焊盤 包裝:帶卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名稱:LM1771SSDX |
發布緊急采購，3分鐘左右您將得到回復。