- 您現在的位置：買賣IC網 > PDF目錄98003 > LTC3805HMSE-5#TRPBF (LINEAR TECHNOLOGY CORP) SWITCHING CONTROLLER, 700 kHz SWITCHING FREQ-MAX, PDSO10 PDF資料下載
參數資料
| 型號： | LTC3805HMSE-5#TRPBF |
| 廠商： | LINEAR TECHNOLOGY CORP |
| 元件分類： | 穩壓器 |
| 英文描述： | SWITCHING CONTROLLER, 700 kHz SWITCHING FREQ-MAX, PDSO10 |
| 封裝： | LEAD FREE, PLASTIC, MSOP-10 |
| 文件頁數： | 7/20頁 |
| 文件大小： | 265K |
| 代理商： | LTC3805HMSE-5#TRPBF |
第1頁第2頁第3頁第4頁第5頁第6頁當前第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁
LTC3805-5
38055fd
applications inForMation
overcurrent trip only to prevent damage. To implement
this strategy use a value of ROC smaller than ROC(CRIT).
Thisalsoreducessensitivitytoovercurrenttripscausedby
transient operation. In the limit, set ROC = 0 and connect
the OC pin directly to RSENSE. This causes an overcurrent
trip near minimum duty cycle or around 6%.
In some cases it may be desirable to increase the trip
threshold even further. In this strategy, the converter is
allowed to operate all the way down to minimum duty
cycle at which point the cycle-by-cycle current limit of
the ISENSE pin is lost and switch current goes up propor-
tionally to the output current. Figures 6 and 7 show two
ways to do this. Figure 6 is for relatively low currents with
relatively large values of RSENSE. Using this circuit the
overcurrent trip threshold is increased from 100mV to:
VOC =
RSENSE1 +RSENSE2
RSENSE1
100mV
where it is assumed that the values of RSENSE1 and
RSENSE2 are so small that the IOC = 10A threshold adjust-
ment current produces a negligible change in VOC.
For larger currents, values of the current sense resistors
must be very small and the circuit of Figure 6 becomes
impractical.ThecircuitofFigure7canbesubstitutedandthe
current sense threshold is increased from 100mV to:
VOC =
R1
+R2
R1
100mV
where the values of R1 and R2 should be kept below 10
W
to prevent the IOC = 10A threshold adjustment current
from producing a shift in VOC.
External Soft-Start Fault Timeout
The external soft-start is programmed by a capacitor CSS
from the SSFLT pin to GND. At the initiation of soft-start
the voltage on the SSFLT pin is quickly charged to 0.7V
at which point GATE begins switching. From that point,
a 6A current charges the voltage on the SSFLT pin until
the voltage reaches about 2.25V at which point soft-start
is over and the converter enters closed-loop regulation.
The soft-start time tSS(EXT) as a function of the soft-start
capacitor CSS is therefore:
tSS(EXT) =CSS
2.25
0.7V
6A
After soft-start is complete, the voltage on the SSFLT pin
continues to charge to about a final value of 4.75V. Note
that choosing a value of CSS less than 5.8nF has no effect
since it would attempt to program an external soft-start
time tSS(EXT) less than the mandatory minimum internal
soft-start time tSS(IN) = 1.8ms.
If there is an overcurrent fault detected on the OC pin, the
LTC3805-5 enters a shutdown mode while a 2A current
discharges the voltage on the SSFLT pin from 4.75V to
about 0.7V. The fault timeout tFTO(EXT) is therefore:
tFTO(EXT) =CSS
4.75V
0.7V
2A
At this point, the LTC3805-5 attempts a restart.
In the event of a persistent fault, such as a short-circuit
on the converter output, the converter enters a “hiccup”
mode where it continues to try and restart at repetition
rate determined by CSS. If the fault is eventually removed
the converter successfully restarts.
Figure 6. Circuit to Increase the Overcurrent
Threshold for Small Switch Currents
Figure 7. Circuit to Increase the Overcurrent
Threshold for Large Switch Currents
LTC3805-5
OC
GATE
ISENSE
RSENSE1
RSENSE2
RSLOPE
GND
38055 F06
IOC = 10A
ISLOPE
LTC3805-5
OC
GATE
ISENSE
R1
R2
RSLOPE
GND
38055 F07
RSENSE
IOC = 10A
ISLOPE
相關PDF資料 |
PDF描述 |
|---|---|
| LTC3805MPMSE-5#PBF | SWITCHING REGULATOR, 700 kHz SWITCHING FREQ-MAX, PDSO10 |
| LTC3827IG-1 | 3 A DUAL SWITCHING CONTROLLER, 650 kHz SWITCHING FREQ-MAX, PDSO28 |
| LTC3827IG-1#TR | 3 A DUAL SWITCHING CONTROLLER, 650 kHz SWITCHING FREQ-MAX, PDSO28 |
| LTC3853IUJ#TR | 0.15 A DUAL SWITCHING CONTROLLER, 830 kHz SWITCHING FREQ-MAX, PQCC40 |
| LTC3853EUJ#TR | 0.15 A DUAL SWITCHING CONTROLLER, 830 kHz SWITCHING FREQ-MAX, PQCC40 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC3805IDD#PBF | 功能描述:IC REG CTRLR BST FLYBK PWM 10DFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:96% 電源電壓:4 V ~ 36 V 降壓:無 升壓:是 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:24-WQFN 裸露焊盤 包裝:帶卷 (TR) |
| LTC3805IDD#TRPBF | 功能描述:IC REG CTRLR BST FLYBK PWM 10DFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:96% 電源電壓:4 V ~ 36 V 降壓:無 升壓:是 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:24-WQFN 裸露焊盤 包裝:帶卷 (TR) |
| LTC3805IDD-5#PBF | 功能描述:IC REG CTRLR BST FLYBK PWM 10DFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:96% 電源電壓:4 V ~ 36 V 降壓:無 升壓:是 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:24-WQFN 裸露焊盤 包裝:帶卷 (TR) |
| LTC3805IDD-5#TRPBF | 功能描述:IC REG CTRLR BST FLYBK PWM 10DFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:96% 電源電壓:4 V ~ 36 V 降壓:無 升壓:是 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:24-WQFN 裸露焊盤 包裝:帶卷 (TR) |
| LTC3805IMSE#PBF | 功能描述:IC REG CTRLR BST FLYBK CM 10MSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:96% 電源電壓:4 V ~ 36 V 降壓:無 升壓:是 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:24-WQFN 裸露焊盤 包裝:帶卷 (TR) |
發布緊急采購，3分鐘左右您將得到回復。