- 您現在的位置：買賣IC網 > PDF目錄44993 > LTC3789IGN#TRPBF (LINEAR TECHNOLOGY CORP) 0.1 A SWITCHING CONTROLLER, 710 kHz SWITCHING FREQ-MAX, PDSO28 PDF資料下載
參數資料
| 型號： | LTC3789IGN#TRPBF |
| 廠商： | LINEAR TECHNOLOGY CORP |
| 元件分類： | 穩壓器 |
| 英文描述： | 0.1 A SWITCHING CONTROLLER, 710 kHz SWITCHING FREQ-MAX, PDSO28 |
| 封裝： | 0.150 INCH, LEAD FREE, PLASTIC, SSOP-28 |
| 文件頁數： | 14/28頁 |
| 文件大小： | 486K |
| 代理商： | LTC3789IGN#TRPBF |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁當前第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁
LTC3789
21
3789f
applicaTions inForMaTion
to ground. The soft-start range is defined to be the voltage
range from 0V to 0.8V on the SS pin. The total soft-start
time can be calculated as:
tSOFTSTART = 0.8
CSS
3A
Regardless of the mode selected by the MODE/PLLIN pin,
the regulator will always start in pulse-skipping mode up
to SS = 0.8V.
Fault Conditions: Current Limit and Current Foldback
The maximum inductor current is inherently limited in a
currentmodecontrollerbythemaximumsensevoltage.In
the boost region, maximum sense voltage and the sense
resistance determine the maximum allowed inductor peak
current, which is:
IL(MAX,BOOST) =
140mV
RSENSE
In the buck region, maximum sense voltage and the sense
resistancedeterminethemaximumallowedinductorvalley
current, which is:
IL(MAX,BUCK) =
90mV
RSENSE
To further limit current in the event of a short circuit to
ground, the LTC3789 includes foldback current limiting.
If the output falls by more than 50%, then the maximum
sense voltage is progressively lowered to about one-third
of its full value.
Efficiency Considerations
The percent efficiency of a switching regulator is equal
to the output power divided by the input power times
100%. It is often useful to analyze individual losses
to determine what is limiting the efficiency and which
change would produce the most improvement. Although
all dissipative elements in circuit produce losses, four
main sources account for most of the losses in LTC3789
circuits:
1. DC I2R losses. These arise from the resistances of the
MOSFETs,sensingresistor,inductorandPCboardtraces
and cause the efficiency to drop at high output currents.
2. Transition loss. This loss arises from the brief amount
of time switch A or switch C spends in the saturated
region during switch node transitions. It depends upon
the input voltage, load current, driver strength and
MOSFET capacitance, among other factors. The loss
is significant at input voltages above 20V and can be
estimated from:
Transition Loss ≈ 1.7A–1 VIN2 IOUT CRSS f
where CRSS is the reverse transfer capacitance.
3. INTVCC current. This is the sum of the MOSFET driver
and control currents. This loss can be reduced by sup-
plying INTVCC current through the EXTVCC pin from a
high efficiency source, such as the output (if 4.7V <
VOUT < 14V) or alternate supply if available.
4. CIN and COUT loss. The input capacitor has the difficult
job of filtering the large RMS input current to the regula-
tor in buck mode. The output capacitor has the more
difficult job of filtering the large RMS output current in
boost mode. Both CIN and COUT are required to have
low ESR to minimize the AC I2R loss and sufficient
capacitance to prevent the RMS current from causing
additional upstream losses in fuses or batteries.
5. Other losses. Schottky diodes D1 and D2 are respon-
sible for conduction losses during dead time and light
load conduction periods. Inductor core loss occurs
predominately at light loads. Switch C causes reverse
recovery current loss in boost mode.
When making adjustments to improve efficiency, the input
current is the best indicator of changes in efficiency. If one
makes a change and the input current decreases, then the
efficiency has increased. If there is no change in input
current, then there is no change in efficiency.
相關PDF資料 |
PDF描述 |
|---|---|
| LTC3803HS6-3#TRPBF | 1 A SWITCHING CONTROLLER, 330 kHz SWITCHING FREQ-MAX, PDSO6 |
| LTC3803MPS6-3#TR | 1 A SWITCHING CONTROLLER, 330 kHz SWITCHING FREQ-MAX, PDSO6 |
| LTC3803MPS6-3#TRM | 1 A SWITCHING CONTROLLER, 330 kHz SWITCHING FREQ-MAX, PDSO6 |
| LTC3803MPS6-3 | 1 A SWITCHING CONTROLLER, 330 kHz SWITCHING FREQ-MAX, PDSO6 |
| LTC3803HS6-3#PBF | 1 A SWITCHING CONTROLLER, 330 kHz SWITCHING FREQ-MAX, PDSO6 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC3789IUFD#PBF | 功能描述:IC REG CTRLR BST PWM CM 28-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:4,500 系列:PowerWise® PWM 型:控制器 輸出數:1 頻率 - 最大:1MHz 占空比:95% 電源電壓:2.8 V ~ 5.5 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:6-WDFN 裸露焊盤 包裝:帶卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名稱:LM1771SSDX |
| LTC3789IUFD#TRPBF | 功能描述:IC REG CTRLR BST PWM CM 28-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:4,500 系列:PowerWise® PWM 型:控制器 輸出數:1 頻率 - 最大:1MHz 占空比:95% 電源電壓:2.8 V ~ 5.5 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:6-WDFN 裸露焊盤 包裝:帶卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名稱:LM1771SSDX |
| LTC3789IUFDPBF | 制造商:Linear Technology 功能描述:4-Switch Buck-Boost Controller QFN28EP |
| LTC-37XX | 制造商:LITEON 制造商全稱:Lite-On Technology Corporation 功能描述:0.3 FOUR LED CLOCK FREQUENCY DISPLAYS |
| LTC3801BES6#PBF | 制造商:Linear Technology 功能描述:DC DC Cntrlr Single-OUT Step Down 2.4V to 9.8V Input 6-Pin TSOT-23 |
發布緊急采購，3分鐘左右您將得到回復。