- 您現在的位置：買賣IC網 > PDF目錄44993 > LTC3788EUH#PBF (LINEAR TECHNOLOGY CORP) DUAL SWITCHING CONTROLLER, 900 kHz SWITCHING FREQ-MAX, PQCC32 PDF資料下載
參數資料
| 型號： | LTC3788EUH#PBF |
| 廠商： | LINEAR TECHNOLOGY CORP |
| 元件分類： | 穩壓器 |
| 英文描述： | DUAL SWITCHING CONTROLLER, 900 kHz SWITCHING FREQ-MAX, PQCC32 |
| 封裝： | 5 X 5 MM, LEAD FREE, PLASTIC, MO-220WHHD, QFN-32 |
| 文件頁數： | 32/32頁 |
| 文件大?。?/td> | 386K |
| 代理商： | LTC3788EUH#PBF |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁當前第32頁
LTC3788
9
3788fb
Typical perForMance characTerisTics
pin FuncTions
SENSE1–,SENSE2–(Pin1,Pin9):NegativeCurrentSense
Comparator Input. The (–) input to the current comparator
is normally connected to the negative terminal of a cur-
rent sense resistor connected in series with the inductor.
The common mode voltage range on these pins is 2.5V
to 38V (abs max).
FREQ (Pin 2): The frequency control pin for the internal
VCO. Connecting the pin to GND forces the VCO to a fixed
low frequency of 350kHz. Connecting the pin to INTVCC
forces the VCO to a fixed high frequency of 535kHz. The
frequency can be programmed from 50kHz to 900kHz
by connecting a resistor from the FREQ pin to GND. The
resistor and an internal 20A source current create a volt-
age used by the internal oscillator to set the frequency.
Alternatively, this pin can be driven with a DC voltage to
vary the frequency of the internal oscillator.
PHASMD (Pin 3): This pin can be floated, tied to SGND, or
tied to INTVCC to program the phase relationship between
the rising edges of BG1 and BG2, as well as the phase
relationship between BG1 and CLKOUT.
CLKOUT (Pin 4): A Digital Output Used for Daisychaining
MultipleLTC3788ICsinMultiphaseSystems.ThePHASMD
pin voltage controls the relationship between BG1, BG2
and CLKOUT. This pin swings between SGND and INTVCC.
PLLIN/MODE (Pin 5): External Synchronization Input
to Phase Detector and Forced Continuous Mode Input.
When an external clock is applied to this pin, it will force
the controller into forced continuous mode of operation
and the phase-locked loop will force the rising BG1 signal
to be synchronized with the rising edge of the external
clock. When not synchronizing to an external clock, this
input, which acts on both controllers, determines how the
LTC3788 operates at light loads. Pulling this pin to ground
selects Burst Mode operation. An internal 100k resistor
to ground also invokes Burst Mode operation when the
pin is floated. Tying this pin to INTVCC forces continuous
inductor current operation. Tying this pin to a voltage
greater than 1.2V and less than INTVCC – 1.3V selects
pulse-skipping operation. This can be done by adding a
100k resistor between the PLLIN/MODE pin and INTVCC.
SGND (Pin 6): Signal Ground. All small-signal components
and compensation components should connect to this
ground, which in turn connects to PGND at a single point.
RUN1,RUN2(Pin7,Pin8):RunControlInput.Anexternal
resistor divider connects to VINandsetsthethresholdsfor
converter operation with a threshold of 1.28V. Once run-
ning,a4.5AcurrentissourcedfromtheRUNpinallowing
the user to program hysteresis using the resistor values.
Maximum Current Sense
Threshold vs Duty Cycle
Charge Pump Charging Current
vs Operating Frequency
DUTY CYCLE (%)
0
MAXIMUM
CURRENT
SENSE
VOL
TAGE
(mV)
80
100
70
60
40
20
40
10
90
30
50
80
60
100
20
0
120
3788 G25
ILIM = INTVCC
ILIM = FLOAT
ILIM = GND
OPERATING FREQUENCY (kHz)
50
0
CHARGE
PUMP
CHARGING
CURRENT
(A)
20
30
80
50
250
450 550
10
60
70
40
150
350
650 750
3788 G26
T = 130°C
T = 25°C
T = –45°C
VSW = 12V
VBOOST – VSW = 4.5V
相關PDF資料 |
PDF描述 |
|---|---|
| LTC3788IUH#PBF | DUAL SWITCHING CONTROLLER, 900 kHz SWITCHING FREQ-MAX, PQCC32 |
| LTC3788IGN-1#PBF | DUAL SWITCHING CONTROLLER, 900 kHz SWITCHING FREQ-MAX, PDSO28 |
| LTC3788EGN-1#TRPBF | DUAL SWITCHING CONTROLLER, 900 kHz SWITCHING FREQ-MAX, PDSO28 |
| LTC3789EGN#TRPBF | 0.1 A SWITCHING CONTROLLER, 710 kHz SWITCHING FREQ-MAX, PDSO28 |
| LTC3789EUFD#TRPBF | 0.1 A SWITCHING CONTROLLER, 710 kHz SWITCHING FREQ-MAX, PQCC28 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC3788IGN-1#PBF | 功能描述:IC REG CTRLR BST PWM CM 28-SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:4,500 系列:PowerWise® PWM 型:控制器 輸出數:1 頻率 - 最大:1MHz 占空比:95% 電源電壓:2.8 V ~ 5.5 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:6-WDFN 裸露焊盤 包裝:帶卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名稱:LM1771SSDX |
| LTC3788IGN-1#TRPBF | 功能描述:IC REG CTRLR BST PWM CM 28-SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:4,500 系列:PowerWise® PWM 型:控制器 輸出數:1 頻率 - 最大:1MHz 占空比:95% 電源電壓:2.8 V ~ 5.5 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:6-WDFN 裸露焊盤 包裝:帶卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名稱:LM1771SSDX |
| LTC3788IUH#PBF | 功能描述:IC REG CTRLR BST PWM CM 32-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:4,500 系列:PowerWise® PWM 型:控制器 輸出數:1 頻率 - 最大:1MHz 占空比:95% 電源電壓:2.8 V ~ 5.5 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:6-WDFN 裸露焊盤 包裝:帶卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名稱:LM1771SSDX |
| LTC3788IUH#TRPBF | 功能描述:IC REG CTRLR BST PWM CM 32-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:4,500 系列:PowerWise® PWM 型:控制器 輸出數:1 頻率 - 最大:1MHz 占空比:95% 電源電壓:2.8 V ~ 5.5 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:6-WDFN 裸露焊盤 包裝:帶卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名稱:LM1771SSDX |
| LTC3789EGN#PBF | 功能描述:IC REG CTRLR BST PWM CM 28-SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:4,500 系列:PowerWise® PWM 型:控制器 輸出數:1 頻率 - 最大:1MHz 占空比:95% 電源電壓:2.8 V ~ 5.5 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:6-WDFN 裸露焊盤 包裝:帶卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名稱:LM1771SSDX |
發布緊急采購，3分鐘左右您將得到回復。