參數資料
型號： LTC3775EMSE#TRPBF
廠商： LINEAR TECHNOLOGY CORP
元件分類： 穩壓器
英文描述： SWITCHING CONTROLLER, 575 kHz SWITCHING FREQ-MAX, PDSO16
封裝： LEAD FREE, PLASTIC, MSOP-16
文件頁數： 15/34頁
文件大?。?/td> 534K
代理商： LTC3775EMSE#TRPBF
LTC3775
22
3775fa
ΔIL may be calculated using the equation:
IL =
VOUT
LfSW
1–
VOUT
VIN
Since ΔIL increases with input voltage, the output ripple
voltage is highest at maximum input voltage. Typically,
once the ESR requirement is satised, the capacitance is
adequate for ltering and has the necessary RMS current
rating.
Manufacturers such as Sanyo, Panasonic and Cornell
Dublilier should be considered for high performance
through-hole capacitors. The OS-CON semiconductor
electrolyte capacitor available from Sanyo has a good
(ESR)(size) product. An additional ceramic capacitor in
parallel with OS-CON capacitors is recommended to offset
the effect of lead inductance.
In surface mount applications, multiple capacitors may
have to be connected in parallel to meet the ESR or tran-
sient current handling requirements of the application.
Aluminum electrolytic and dry tantalum capacitors are
both available in surface mount congurations. New special
polymer surface mount capacitors offer very low ESR also
but have much lower capacitive density per unit volume.
In the case of tantalum, it is critical that the capacitors are
surge tested for use in switching power supplies. Several
excellent output capacitor choices are the Sanyo POSCAP
TPD, POSCAP TPB, AVX TPS, AVX TPSV, the Kemet T510
series of surface mount tantalums, Kemet AO-CAPs or the
Panasonic SP series of surface mount special polymer
capacitors available in case heights ranging from 2mm
to 4mm. Other capacitor types include Nichicon PL series
and Sprague 595D series. Consult the manufacturer for
other specic recommendations.
Inductor Selection
The inductor in a typical LTC3775 application circuit is
chosen based on the required ripple current, its size and
its saturation current rating. The inductor should not be al-
lowed to saturate below the hard current limit threshold.
The inductor value sets the ripple current, which is com-
monly chosen at around 40% of the anticipated full load
current. Lower ripple current reduces core losses in the
inductor, ESR losses in the output capacitors and out-
put voltage ripple. Highest efciency is obtained at low
frequency with small ripple current. However, achieving
high efciency requires a large inductor and generates
higher output voltage excursion during load transients.
There is a trade-off between component size, efciency
and operating frequency. Given a specied limit for ripple
current, the inductor value can be obtained using the fol-
lowing equation:
L =
VOUT
fSW IL(MAX)
1–
VOUT
VIN(MAX)
Once the value for L is known, the type of inductor must
be selected. High efciency converters generally cannot
afford the core loss found in low cost powdered iron cores,
forcing the use of more expensive ferrite, molypermalloy or
Kool Mμ cores. A variety of inductors designed for high
current, low voltage applications are available from manu-
facturers such as Sumida, Panasonic, Coiltronics, Coilcraft
and Toko. See the Current Limit Programming section for
calculation of the inductor saturation current.
Current Limit Programming
If current sensing is implemented with a sense resistor,
the topside current limit can be programmed by setting
RILIMT as follows:
RILIMT =CF RSENSE
IO(MAX) +0.5 IL
ILIMIT(MIN)
where:
RSENSE = Sense resistor value
IO(MAX) = Maximum output current
ΔIL = Inductor ripple current (refer to the Output Capaci-
tor Selection section).
ILIMT(MIN) = ILIMT pin minimum pull-down current of
90μA
CF = Correction factor to provide safety margin and
account for RSENSE tolerance; use a value of CF = 1.2
is reasonable.
APPLICATIONS INFORMATION
相關PDF資料
PDF描述
LTC3775IMSE#PBF SWITCHING CONTROLLER, 575 kHz SWITCHING FREQ-MAX, PDSO16
LTC3805MPMSE#PBF SWITCHING REGULATOR, 700 kHz SWITCHING FREQ-MAX, PDSO10
LTC3805MPMSE#TR SWITCHING REGULATOR, 700 kHz SWITCHING FREQ-MAX, PDSO10
LTC3829IFE#PBF SWITCHING REGULATOR, PDSO38
LTC3829IFE#TRPBF SWITCHING REGULATOR, PDSO38
相關代理商/技術參數
參數描述
LTC3775EUD#PBF 功能描述:IC REG CTRLR BUCK PWM VM 16-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:96% 電源電壓:4 V ~ 36 V 降壓:無 升壓:是 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:24-WQFN 裸露焊盤 包裝:帶卷 (TR)
LTC3775EUD#PBF 制造商:Linear Technology 功能描述:IC SYNC STEP-DOWN DC/DC CONTROLLER QFN16
LTC3775EUD#TRPBF 功能描述:IC REG CTRLR BUCK PWM VM 16-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:96% 電源電壓:4 V ~ 36 V 降壓:無 升壓:是 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:24-WQFN 裸露焊盤 包裝:帶卷 (TR)
LTC3775IMSE#PBF 功能描述:IC REG CTRLR BUCK PWM VM 16-MSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:96% 電源電壓:4 V ~ 36 V 降壓:無 升壓:是 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:24-WQFN 裸露焊盤 包裝:帶卷 (TR)
LTC3775IMSE#TRPBF 功能描述:IC REG CTRLR BUCK PWM VM 16-MSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:96% 電源電壓:4 V ~ 36 V 降壓:無 升壓:是 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:24-WQFN 裸露焊盤 包裝:帶卷 (TR)
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*