參數資料
型號: LTC3770EG
廠商: LINEAR TECHNOLOGY CORP
元件分類: 穩壓器
英文描述: Synchronous Controller with Margining, Tracking and PLL
中文描述: 4 A SWITCHING CONTROLLER, PDSO28
封裝: 5.30 MM, PLASTIC, SSOP-28
文件頁數: 18/24頁
文件大小: 302K
代理商: LTC3770EG
18
LTC3770
3770f
Margining
Margining is a way to program the reference voltage to the
error amplifier to a voltage different from the default 0.6V.
Margining is useful for customers who want to stress their
systems by varying supply voltages during testing. The
reference voltage to the error amplifier is set according to
the following equation when the margining function is
enabled:
V
REFIN
= 0.6V
±
(1.18V/R4) R3
Referring to the functional diagram, 0.6V is the buffered
system reference at the V
REFOUT
pin. R3 and R4 are
resistors used for programming the amount of margining.
V
REFIN
should be a voltage between 0.5V and 1V.
There are two logic control pins, MARGIN1 and MARGIN0,
to determine whether the margining function is enabled,
Margin up(+) or Margin down(–). Table 1 summarizes the
configurations:
Table 1: Margining Function
MARGIN1
LOW
LOW
HIGH
HIGH
MARGIN0
LOW
HIGH
LOW
HIGH
Mode
No Margining
Margin Up
Margin Down
No Margining
The buffered reference at V
REFOUT
has the ability to source
a large amount of current. However, it can only sink a
maximum of 50
μ
A of current. To increase the sinking
capability of this reference, connect a resistor to ground at
this pin. One may also be tempted to connect a large
capacitor to this pin to filter out the noise.
However, it is
recommended that no larger than 100pF of capacitance
should be connected to this pin.
Phase-Locked Loop and Frequency Synchronization
The LTC3770 has a phase-locked loop comprised of an
internal voltage controlled oscillator and phase detector.
This allows the top MOSFET turn-on to be locked to the
rising edge of an external source. The frequency range of
the voltage controlled oscillator is
±
30% around the
center frequency f
O
. The center frequency is the operating
frequency discussed in the previous section. The LTC3770
incorporates a pulse detection circuit that will detect a
clock on the PLLIN pin. In turn, it will turn on the phase-
locked loop function. The pulse width of the clock has to
be greater than 400ns and the amplitude of the clock
should be greater than 2V.
During the start-up phase, phase-locked loop function is
disabled. When LTC3770 is not in synchronization mode,
PLLFLTR pin voltage is set to around 1.18V. Frequency
synchronization is accomplished by changing the internal
on-time current according to the voltage on the PLLFLTR
pin.
The phase detector used is an edge sensitive digital type
which provides zero degrees phase shift between the
external and internal pulses. This type of phase detector
will not lock up on input frequencies close to the harmon-
ics of the VCO center frequency. The PLL hold-in range,
f
H
, is equal to the capture range,
f
C:
f
H
=
f
C
=
±
0.3 f
O
The output of the phase detector is a complementary pair
of current sources charging or discharging the external
filter network on the PLLFLTR pin. A simplified block
diagram is shown in Figure 10.
If the external frequency (f
PLLIN
) is greater than the oscil-
lator frequency f
O
, current is sourced continuously, pull-
ing up the PLLFLTR pin. When the external frequency is
less than f
O
, current is sunk continuously, pulling down
the PLLFLTR pin. If the external and internal frequencies
are the same but exhibit a phase difference, the current
sources turn on for an amount of time corresponding to
the phase difference. Thus the voltage on the PLLFLTR
pin is adjusted until the phase and frequency of the
external and internal oscillators are identical. At this stable
DIGITAL
PHASE/
FREQUENCY
DETECTOR
PLLIN
PLLFLTR
2.4V
C
LP
3770 F10
R
LP
VCO
Figure 10. Phase-Locked Loop Block Diagram
APPLICATIU
W
U
U
相關PDF資料
PDF描述
LTC3770EUH Synchronous Controller with Margining, Tracking and PLL
LTC3776 16-Bit Buffer/Driver With 3-State Outputs 48-TVSOP -40 to 85
LTC3776EUF Dual 2-Phase, No RSENSE Synchronous Controller for DDR/QDR Memory Termination
LTC3776EGN Dual 2-Phase, No RSENSE Synchronous Controller for DDR/QDR Memory Termination
LTC3780 DIODE SCHOTTKY DUAL ISOLATED 25V 150mW 0.33V-vf 200mA-IFM 2mA-IF 0.5uA-IR SOT-563 3K/REEL
相關代理商/技術參數
參數描述
LTC3770EG#PBF 功能描述:IC REG CTRLR BUCK PWM CM 28-SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:96% 電源電壓:4 V ~ 36 V 降壓:無 升壓:是 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:24-WQFN 裸露焊盤 包裝:帶卷 (TR)
LTC3770EG#TRPBF 功能描述:IC REG CTRLR BUCK PWM CM 28-SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:96% 電源電壓:4 V ~ 36 V 降壓:無 升壓:是 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:24-WQFN 裸露焊盤 包裝:帶卷 (TR)
LTC3770EUH#PBF 功能描述:IC REG CTRLR BUCK PWM CM 32-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:96% 電源電壓:4 V ~ 36 V 降壓:無 升壓:是 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:24-WQFN 裸露焊盤 包裝:帶卷 (TR)
LTC3770EUH#TRPBF 功能描述:IC REG CTRLR BUCK PWM CM 32-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:96% 電源電壓:4 V ~ 36 V 降壓:無 升壓:是 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:24-WQFN 裸露焊盤 包裝:帶卷 (TR)
LTC3772BEDDB#TRMPBF 功能描述:IC REG CTRLR BUCK PWM CM 8-DFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:96% 電源電壓:4 V ~ 36 V 降壓:無 升壓:是 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:24-WQFN 裸露焊盤 包裝:帶卷 (TR)