參數資料
型號: LTC3736-1
廠商: Linear Technology Corporation
英文描述: No RSENSE Low EMI, Synchronous DC/DC Controller with Output Tracking
中文描述: 無檢測電阻低EMI,同步DC / DC控制器的輸出跟蹤
文件頁數: 13/28頁
文件大小: 372K
代理商: LTC3736-1
13
LTC3808
3808f
APPLICATIU
The typical LTC3808 application circuit is shown on
Figure 11. External component selection for the controller
is driven by the load requirement and begins with the
selection of the inductor and the power MOSFETs.
W
U
U
Power MOSFET Selection
The LTC3808’s controller requires two external power
MOSFETs: a P-channel MOSFET for the topside (main)
switch and a N-channel MOSFET for the bottom (synchro-
nous) switch. The main selection criteria for the power
MOSFETs are the breakdown voltage V
BR(DSS)
, threshold
voltage V
GS(TH)
, on-resistance R
DS(ON)
, reverse transfer
capacitance C
RSS
, turn-off delay t
D(OFF)
and the total gate
charge Q
G
.
The gate drive voltage is the input supply voltage. Since the
LTC3808 is designed for operation down to low input
voltages, a sublogic level MOSFET (R
DS(ON)
guaranteed at
V
GS
= 2.5V) is required for applications that work close to
this voltage. When these MOSFETs are used, make sure
that the input supply to the LTC3808 is less than the
absolute maximum MOSFET V
GS
rating, which is typically
8V.
The P-channel MOSFET’s on-resistance is chosen based
on the required load current. The maximum average load
current I
OUT(MAX)
is equal to the peak inductor current
minus half the peak-to-peak ripple current I
RIPPLE
. The
LTC3808’s current comparator monitors the drain-to-
source voltage V
DS
of the top P-channel MOSFET, which
is sensed between the SENSE
+
and SW pins. The peak
inductor current is limited by the current threshold, set by
the voltage on the I
TH
pin, of the current comparator. The
voltage on the I
TH
pin is internally clamped, which limits
the maximum current sense threshold
V
SENSE(MAX)
to
approximately 125mV when IPRG is floating (85mV when
IPRG is tied low; 204mV when IPRG is tied high).
The output current that the LTC3808 can provide is given
by:
V
R
DS ON
(
)
I
I
OUT MAX
(
SENSE MAX
RIPPLE
2
)
(
)
=
where I
RIPPLE
is the inductor peak-to-peak ripple current
(see Inductor Value Calculation).
A reasonable starting point is setting ripple current I
RIPPLE
to be 40% of I
OUT(MAX)
. Rearranging the above equation
yields:
V
I
OUT MAX
(
6
R
forDutyCycle
DS ON MAX
(
SENSE MAX
)
(
)
)
%
=
<
5
20
However, for operation above 20% duty cycle, slope
compensation has to be taken into consideration to select
the appropriate value of R
DS(ON)
to provide the required
amount of load current:
R
SF
V
I
DS ON MAX
(
SENSE MAX
OUT MAX
(
)
(
)
)
=
5
6
where SF is a scale factor whose value is obtained from the
curve in Figure 1.
These must be further derated to take into account the
significant variation in on-resistance with temperature.
The following equation is a good guide for determining the
required R
DS(ON)MAX
at 25
°
C (manufacturer’s specifica-
tion), allowing some margin for variations in the LTC3808
and external component values:
R
SF
V
I
DS ON MAX
(
SENSE MAX
OUT MAX
(
T
)
(
)
)
.
0 9
=
5
6
ρ
The
ρ
T
is a normalizing term accounting for the tempera-
ture variation in on-resistance, which is typically about
0.4%/
°
C, as shown in Figure 2. Junction-to-case tempera-
ture T
JC
is about 10
°
C in most applications. For a maxi-
mum ambient temperature of 70
°
C, using
ρ
80
°
C
~ 1.3 in
the above equation is a reasonable choice.
The N-channel MOSFET’s on resistance is chosen based
on the short-circuit current limit (I
SC
). The LTC3808’s
short-circuit current limit comparator monitors the drain-
to-source voltage V
DS
of the bottom N-channel MOSFET,
相關PDF資料
PDF描述
LTC3737 No RSENSE Low EMI, Synchronous DC/DC Controller with Output Tracking
LTC3737EGN Dual 2-Phase, No RSENSE DC/DC Controller with Output Tracking
LTC3737EUF Dual 2-Phase, No RSENSE DC/DC Controller with Output Tracking
LTC3808EDE No RSENSE Low EMI, Synchronous DC/DC Controller with Output Tracking
LTC3713 Low Input Voltage, High Power, No RSENSE Synchronous Buck DC/DC Controller
相關代理商/技術參數
參數描述
LTC3736EGN 功能描述:IC REG CTRLR BUCK PWM CM 24-SSOP RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:PolyPhase® 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:96% 電源電壓:4 V ~ 36 V 降壓:無 升壓:是 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:24-WQFN 裸露焊盤 包裝:帶卷 (TR)
LTC3736EGN#PBF 功能描述:IC REG CTRLR BUCK PWM CM 24-SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:PolyPhase® 特色產品:LM3753/54 Scalable 2-Phase Synchronous Buck Controllers 標準包裝:1 系列:PowerWise® PWM 型:電壓模式 輸出數:1 頻率 - 最大:1MHz 占空比:81% 電源電壓:4.5 V ~ 18 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-5°C ~ 125°C 封裝/外殼:32-WFQFN 裸露焊盤 包裝:Digi-Reel® 產品目錄頁面:1303 (CN2011-ZH PDF) 其它名稱:LM3754SQDKR
LTC3736EGN#TR 功能描述:IC REG CTRLR BUCK PWM CM 24-SSOP RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:PolyPhase® 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:96% 電源電壓:4 V ~ 36 V 降壓:無 升壓:是 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:24-WQFN 裸露焊盤 包裝:帶卷 (TR)
LTC3736EGN#TRPBF 功能描述:IC REG CTRLR BUCK PWM CM 24-SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:PolyPhase® 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:96% 電源電壓:4 V ~ 36 V 降壓:無 升壓:是 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:24-WQFN 裸露焊盤 包裝:帶卷 (TR)
LTC3736EGN-1 功能描述:IC REG CTRLR BUCK PWM CM 24-SSOP RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:PolyPhase® 標準包裝:4,500 系列:PowerWise® PWM 型:控制器 輸出數:1 頻率 - 最大:1MHz 占空比:95% 電源電壓:2.8 V ~ 5.5 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:6-WDFN 裸露焊盤 包裝:帶卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名稱:LM1771SSDX