- 您現在的位置：買賣IC網 > PDF目錄377775 > LTC3701EGN (LINEAR TECHNOLOGY CORP) 2-Phase, Low Input Voltage, Dual Step-Down DC/DC Controller PDF資料下載
參數資料
| 型號： | LTC3701EGN |
| 廠商： | LINEAR TECHNOLOGY CORP |
| 元件分類： | 穩壓器 |
| 英文描述： | 2-Phase, Low Input Voltage, Dual Step-Down DC/DC Controller |
| 中文描述： | 1 A DUAL SWITCHING CONTROLLER, 890 kHz SWITCHING FREQ-MAX, PDSO16 |
| 封裝： | 0.150 INCH, PLASTIC, SSOP-16 |
| 文件頁數： | 7/20頁 |
| 文件大小： | 250K |
| 代理商： | LTC3701EGN |
7
LTC3701
3701fa
OPERATIOU
Main Control Loop
The LTC3701 uses a constant frequency, current mode
architecture with the two controller channels operating
180 degrees out of phase. During normal operation, each
external P-channel power MOSFET is turned on when the
clock for that channel sets the RS latch, and turned off
when the current comparator (I
CMP
) resets the latch. The
peak inductor current at which I
CMP
resets the RS latch is
controlled by the voltage on the I
TH
/RUN pin, which is the
output of each error amplifier, EAMP. The V
FB
pin receives
the voltage feedback signal, which is compared to the
internal reference voltage by the EAMP. When the load
current increases, it causes a slight decrease in V
FB
relative to the 0.8V reference, which in turn, causes the I
TH
/
RUN voltage to increase until the average inductor current
matches the new load current.
Each main control loop is shut down by pulling the
respective I
TH
/RUN pin low. When both I
TH
/RUN1 and I
TH
/
RUN2 are low, all LTC3701 controller functions are shut
down. Releasing I
TH
/RUN allows an internal 0.5
μ
A current
source to charge up the external compensation network.
When the I
TH
/RUN pin reaches 0.35V, the main control
loop is enabled with the I
TH
/RUN voltage then pulled up to
its zero current level of approximately 0.7V. After the loop
is enabled, an internal soft-start begins. During this soft-
start time of 2048 clock cycles, the I
TH
/RUN voltage is
clamped such that the maximum peak current sense
voltage (V
SENSE+
– V
SENSE–
) is held to approximately 0%,
25%, 50% and 75%, respectively, of its maximum value of
120mV for four equally timed intervals. After soft-start is
completed, full current operation is allowed. As the exter-
nal compensation network continues to charge, the corre-
sponding output current trip level follows, allowing normal
operation.
Comparator OVP guards against transient output voltage
overshoots greater than 10% by turning off the external
P-channel power MOSFET and keeping it off until the fault
is removed.
Burst Mode Operation
The LTC3701 can be enabled to enter Burst Mode opera-
tion at low load currents by tying the EXTCLK/MODE pin to
(Refer to Functional Diagram)
V
IN
or to a voltage of at least 2V. To disable Burst Mode
operation and enable PWM pulse skipping mode, connect
the EXTCLK/MODE pin to ground. In this mode, the
efficiency is lower at light loads. However, pulse skipping
mode has the advantages of lower output ripple and less
interference to audio circuitry.
When a controller is in Burst Mode operation, the peak
current of the inductor is set as if V
ITH
/RUN = 1V, even
though the voltage at the I
TH
/RUN pin is at a lower value.
If the inductor’s average current is greater than the load
requirement, the voltage at the I
TH
/RUN pin will drop.
When the I
TH
/RUN voltage goes below 0.85V, the sleep
signal goes high, turning off the external MOSFET. The
sleep signal goes low when the I
TH
/RUN voltage goes
above 0.925V and that controller channel resumes normal
operation. The next oscillator cycle will turn the external
MOSFET on and the switching cycle repeats.
Frequency Synchronization
A phase-locked loop (PLL) is available on the LTC3701 to
allow the internal oscillator to be synchronized to an
external clock source connected to the EXTCLK/MODE
pin. The output of the phase detector at the PLLLPF pin
operates over a 0V to 2.4V range corresponding to ap-
proximately 300kHz to 750kHz. When locked, the PLL
aligns the turn-on of the external MOSFET of controller
channel 1 to the rising edge of the synchronizing signal.
The turn-on of the external MOSFET of controller channel
2 is 180 degrees out of phase with the rising edge of the
external clock source.
When the LTC3701 is clocked by an external source, Burst
Mode operation is disabled and the LTC3701 operates in
PWM pulse skipping mode. In this mode, when the output
load is very low, the current comparator I
CMP
may remain
tripped for several cycles and force the external MOSFET
to stay off for the same number of cycles. Increasing the
output load slightly allows constant frequency PWM op-
eration to resume. This mode exhibits low output ripple as
well as low audio noise and reduced RF interference while
providing reasonable low current efficiency.
相關PDF資料 |
PDF描述 |
|---|---|
| LTC3701 | 16-Bit Universal Bus Driver With 3-State Outputs 48-SSOP -40 to 85 |
| LTC3708 | No RSENSE Low EMI, Synchronous DC/DC Controller with Output Tracking |
| LTC3736 | CTV 5C 5#20 SKT PLUG |
| LTC3736EGN | Dual 2-Phase, No RSENSE Synchronous Controller with Output Tracking |
| LTC3736EUF | Dual 2-Phase, No RSENSE Synchronous Controller with Output Tracking |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC3701EGN#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 16-SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:PolyPhase® 特色產品:LM3753/54 Scalable 2-Phase Synchronous Buck Controllers 標準包裝:1 系列:PowerWise® PWM 型:電壓模式 輸出數:1 頻率 - 最大:1MHz 占空比:81% 電源電壓:4.5 V ~ 18 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-5°C ~ 125°C 封裝/外殼:32-WFQFN 裸露焊盤 包裝:Digi-Reel® 產品目錄頁面:1303 (CN2011-ZH PDF) 其它名稱:LM3754SQDKR |
| LTC3701EGN#TR | 功能描述:IC REG CTRLR BUCK PWM CM 16-SSOP RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:PolyPhase® 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:96% 電源電壓:4 V ~ 36 V 降壓:無 升壓:是 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:24-WQFN 裸露焊盤 包裝:帶卷 (TR) |
| LTC3701EGN#TRPBF | 功能描述:IC REG CTRLR BUCK PWM CM 16-SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:PolyPhase® 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:96% 電源電壓:4 V ~ 36 V 降壓:無 升壓:是 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:24-WQFN 裸露焊盤 包裝:帶卷 (TR) |
| LTC3701EGNPBF | 制造商:Linear Technology 功能描述:DC-DC Controller Dual Step-Dn 10V SSOP16 |
| LTC3701EGNTRPBF | 制造商:LINEAR TECHNOLGY 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。