參數資料
型號: LTC3615IFE#PBF
廠商: LINEAR TECHNOLOGY CORP
元件分類: 穩壓器
英文描述: SWITCHING REGULATOR, PDSO24
封裝: 4.40 MM, LEAD FREE, PLASTIC, TSSOP-24
文件頁數: 9/32頁
文件大?。?/td> 585K
代理商: LTC3615IFE#PBF
LTC3615/LTC3615-1
17
3615fa
the burst clamp. Lower inductor values result in higher
ripple current which causes this to occur at lower DC
load currents. This causes a dip in efciency in the upper
range of low current operation. In Burst Mode operation,
lower inductance values will cause the burst frequency
to increase.
Inductor Core Selection
Once the value for L is known, the type of inductor must
be selected. Actual core loss is independent of core size
for xed inductor value, but it is very dependent on the
inductance selected. As the inductance increases, core
losses decrease. Unfortunately, increased inductance
requires more turns of wire, and therefore, copper losses
will increase.
Ferrite designs have very low core losses and are preferred
at high switching frequencies, so design goals can
concentrate on copper loss and preventing saturation.
Ferrite core material saturates hard, which means that
inductance collapses abruptly when the peak design current
is exceeded. This results in an abrupt increase in inductor
ripple current and consequent output voltage ripple. Do
not allow a ferrite core to saturate!
Different core materials and shapes will change the size/
current and price/current relationship of an inductor.
Toroid or shielded pot cores in ferrite or permalloy materials
are small and do not radiate much energy, but generally
cost more than powdered iron core inductors with similar
characteristics. The choice of which style inductor to use
mainly depends on the price versus size requirements
and any radiated eld/EMI requirements. Table 1 shows
some typical surface mount inductors that work well in
LTC3615 applications.
Input Capacitor CIN Selection
In continuous mode, the source current of the top P-channel
MOSFET is a square wave of duty cycle VOUT/VIN.Toprevent
large voltage transients, a low ESR capacitor sized for the
maximum RMS current must be used for CIN.
The maximum RMS capacitor current is given by:
II
V
RMS
OUT MAX
OUT
IN
OUT
=
()
– 1
This formula has a maximum at VIN = 2VOUT, where IRMS =
IOUT/2.Thissimpleworst-caseconditioniscommonlyused
for design because even signicant deviations do not offer
much relief. Note that ripple current ratings from capacitor
manufacturers are often based on only 2000 hours of life
which makes it advisable to further derate the capacitor,
or choose a capacitor rated at a higher temperature than
required. Several capacitors may also be paralleled to meet
size or height requirements in the design.
APPLICATIONS INFORMATION
Table 1. Representative Surface Mount Inductors
INDUCTANCE
(μH)
DCR
(mΩ)
MAX
CURRENT (A)
DIMENSIONS
(mm)
HEIGHT
(mm)
Vishay IHLP-2020BZ-01
0.33
7.6
25
5.18 × 5.49
2
0.47
8.9
21
5.18 × 5.49
2
0.68
11.2
15
5.18 × 5.49
2
1
18.9
16
5.18 × 5.49
2
Toko DE3518C Series
0.22
8
24
4.3 × 4.7
2
Sumida CDMC6D28 Series
0.3
3.2
15.4
6.7 × 7.25
3
0.47
4.2
13.6
6.7 × 7.25
3
0.68
5.4
11.3
6.7 × 7.25
3
1
8.8
6.7 × 7.25
3
NEC/Tokin MPLC0730L Series
0.47
4.5
16.6
6.9 × 7.7
3.0
0.75
7.5
12.2
6.9 × 7.7
3.0
1.0
9.0
10.6
6.9 × 7.7
3.0
Coilcraft DO1813H Series
0.33
4
10
8.9 × 6.1
5
0.56
10
7.7
8.9 × 6.1
5
Coilcraft SLC7530 Series
0.27
0.1
14
7.5 × 6.7
3
0.35
0.1
11
7.5 × 6.7
3
0.4
0.1
8
7.5 × 6.7
3
相關PDF資料
PDF描述
LTC3727IG-1#TR 3 A SWITCHING CONTROLLER, 580 kHz SWITCHING FREQ-MAX, PDSO28
LTC3727IG-1 3 A SWITCHING CONTROLLER, 580 kHz SWITCHING FREQ-MAX, PDSO28
LTC3765IMSE#TRPBF 1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO16
LTC3766IGN#PBF SWITCHING CONTROLLER, 316 kHz SWITCHING FREQ-MAX, PDSO28
LTC3766HGN#TRPBF SWITCHING CONTROLLER, 316 kHz SWITCHING FREQ-MAX, PDSO28
相關代理商/技術參數
參數描述
LTC3615IUF#PBF 功能描述:IC REG BUCK SYNC ADJ 3A DL 24QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:250 系列:- 類型:降壓(降壓) 輸出類型:固定 輸出數:1 輸出電壓:1.2V 輸入電壓:2.05 V ~ 6 V PWM 型:電壓模式 頻率 - 開關:2MHz 電流 - 輸出:500mA 同步整流器:是 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:6-UFDFN 包裝:帶卷 (TR) 供應商設備封裝:6-SON(1.45x1) 產品目錄頁面:1032 (CN2011-ZH PDF) 其它名稱:296-25628-2
LTC3615IUF#TRPBF 功能描述:IC REG BUCK SYNC ADJ 3A DL 24QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 設計資源:Design Support Tool 標準包裝:1 系列:- 類型:升壓(升壓) 輸出類型:固定 輸出數:1 輸出電壓:3V 輸入電壓:0.75 V ~ 2 V PWM 型:- 頻率 - 開關:- 電流 - 輸出:100mA 同步整流器:是 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:SOT-23-5 細型,TSOT-23-5 包裝:剪切帶 (CT) 供應商設備封裝:TSOT-23-5 其它名稱:AS1323-BTTT-30CT
LTC3615IUF-1#PBF 功能描述:IC REG BUCK SYNC ADJ 3A DL 24QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 設計資源:Design Support Tool 標準包裝:1 系列:- 類型:升壓(升壓) 輸出類型:固定 輸出數:1 輸出電壓:3V 輸入電壓:0.75 V ~ 2 V PWM 型:- 頻率 - 開關:- 電流 - 輸出:100mA 同步整流器:是 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:SOT-23-5 細型,TSOT-23-5 包裝:剪切帶 (CT) 供應商設備封裝:TSOT-23-5 其它名稱:AS1323-BTTT-30CT
LTC3615IUF-1#TRPBF 功能描述:IC REG BUCK SYNC ADJ 3A DL 24QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 設計資源:Design Support Tool 標準包裝:1 系列:- 類型:升壓(升壓) 輸出類型:固定 輸出數:1 輸出電壓:3V 輸入電壓:0.75 V ~ 2 V PWM 型:- 頻率 - 開關:- 電流 - 輸出:100mA 同步整流器:是 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:SOT-23-5 細型,TSOT-23-5 包裝:剪切帶 (CT) 供應商設備封裝:TSOT-23-5 其它名稱:AS1323-BTTT-30CT
LTC3615IUFPBF 制造商:Linear Technology 功能描述:Dual 4MHz 3A Synch Step-Down DC/DC QFN24