- 您現在的位置：買賣IC網 > PDF目錄30770 > LTC3615EUF#TRPBF (LINEAR TECHNOLOGY CORP) SWITCHING REGULATOR, PQCC24 PDF資料下載
參數資料
| 型號： | LTC3615EUF#TRPBF |
| 廠商： | LINEAR TECHNOLOGY CORP |
| 元件分類： | 穩壓器 |
| 英文描述： | SWITCHING REGULATOR, PQCC24 |
| 封裝： | 4 X 4 MM, LEAD FREE, PLASTIC, MO-220WGGD, QFN-24 |
| 文件頁數： | 6/32頁 |
| 文件大?。?/td> | 585K |
| 代理商： | LTC3615EUF#TRPBF |
第1頁第2頁第3頁第4頁第5頁當前第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁
LTC3615/LTC3615-1
14
3615fa
Low Supply Operation
The LTC3615 is designed to operate down to an input supply
voltage of 2.25V. An important consideration at low input
supply voltages is that the RDS(ON) of the P-channel and
N-channel power switches increases by 50% compared to
5V. The user should calculate the power dissipation when
the LTC3615 is used at 100% duty cycle with low input
voltages to ensure that thermal limits are not exceeded.
Slope Compensation and Inductor Peak Current
Slope compensation provides stability in current mode
constant-frequency architectures by preventing subhar-
monic oscillations at duty cycles greater than 50%. The
LTC3615 implements slope compensation by adding a
compensation ramp to the inductor current signal.
Short-Circuit Protection
The peak inductor current at which the current comparator
shuts off the top power switch is controlled by the voltage
on the ITH pin.
If the output current increases, the error amplier raises
the ITH pin voltage until the average inductor current
matches the new load current. In normal operation,
the LTC3615 clamps the maximum ITH pin voltage at
approximately 1.05V which corresponds to about 5A peak
inductor current.
When the output is shorted to ground, the inductor current
decays very slowly during a single switching cycle. The
LTC3615 uses two techniques to prevent current runaway
from occurring:
1. If the output voltage drops below 50% of its nominal
value, the clamp voltage at pin ITH is lowered, causing
the maximum peak inductor current to lower gradu-
ally with the output voltage. When the output voltage
reaches 0V, the clamp voltage at the ITH pin drops to
40% of the clamp voltage during normal operation. The
short-circuit peak inductor current is determined by the
minimum on-time of the LTC3615, the input voltage
and the inductor value. This foldback behavior helps
in limiting the peak inductor current when the output
is shorted to ground. It is disabled during internal or
external soft-start and tracking up/down operation (see
the Applications Information section).
2. If the inductor current of the bottom MOSFET increases
beyond 6A typical, the top power MOSFET will be held
off and switching cycles will be skipped until the induc-
tor current reduces.
OPERATION
相關PDF資料 |
PDF描述 |
|---|---|
| LTC3615IFE#PBF | SWITCHING REGULATOR, PDSO24 |
| LTC3727IG-1#TR | 3 A SWITCHING CONTROLLER, 580 kHz SWITCHING FREQ-MAX, PDSO28 |
| LTC3727IG-1 | 3 A SWITCHING CONTROLLER, 580 kHz SWITCHING FREQ-MAX, PDSO28 |
| LTC3765IMSE#TRPBF | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO16 |
| LTC3766IGN#PBF | SWITCHING CONTROLLER, 316 kHz SWITCHING FREQ-MAX, PDSO28 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC3615HFE#PBF | 制造商:Linear Technology 功能描述:IC REG BUCK SYNC ADJ 3A 24TSSOP |
| LTC3615HFE#TRPBF | 制造商:Linear Technology 功能描述:IC REG BUCK SYNC ADJ 3A 24TSSOP |
| LTC3615HFE-1#PBF | 制造商:Linear Technology 功能描述:IC REG BUCK SYNC ADJ 3A 24TSSOP |
| LTC3615HFE-1#TRPBF | 制造商:Linear Technology 功能描述:IC REG BUCK SYNC ADJ 3A 24TSSOP |
| LTC3615HUF#PBF | 制造商:Linear Technology 功能描述:IC REG BUCK SYNC ADJ 3A 24TSSOP |
發布緊急采購，3分鐘左右您將得到回復。