- 您現在的位置：買賣IC網 > PDF目錄30770 > LTC3554EUD#PBF (LINEAR TECHNOLOGY CORP) 0.6 A BATTERY CHARGE CONTROLLER, 2590 kHz SWITCHING FREQ-MAX, PQCC20 PDF資料下載
參數資料
| 型號： | LTC3554EUD#PBF |
| 廠商： | LINEAR TECHNOLOGY CORP |
| 元件分類： | 穩壓器 |
| 英文描述： | 0.6 A BATTERY CHARGE CONTROLLER, 2590 kHz SWITCHING FREQ-MAX, PQCC20 |
| 封裝： | 3 X 3 MM, 0.75 MM HEIGHT, LEAD FREE, PLASTIC, QFN-20 |
| 文件頁數： | 15/36頁 |
| 文件大?。?/td> | 418K |
| 代理商： | LTC3554EUD#PBF |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁當前第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁
LTC3554/LTC3554-2
22
35542fb
In standby mode, each regulator operates hysteretically.
When the FB pin voltage falls below the internal 0.8V
reference, a current source from BVIN to SW turns on,
delivering current through the inductor to the switching
regulator output capacitor and load. When the FB pin
voltage rises above the reference plus a small hysteresis
voltage, that current is shut off. In this way, output regula-
tion is maintained.
Since the power transfer from BVIN to SW is through a
high impedance current source rather than through a low
impedance MOSFET switch, power loss scales with load
current as in a linear low dropout (LDO) regulator, rather
than as in a switching regulator. For near-zero load condi-
tions where regulator quiescent current is the dominant
power loss, standby mode is ideal. But at any appreciable
load current, Burst Mode operation yields the best overall
conversion efciency.
Shutdown
Each step-down switching regulator is shut down and
enabled via the pushbutton interface. In shutdown, each
switching regulator draws only a few nanoamps of leak-
age current from the BVIN pin. Each disabled regulator
also pulls down on its output with a 10k resistor from its
switch pin to ground.
Dropout Operation
It is possible for a step-down switching regulator’s input
voltage to fall near or below its programmed output volt-
age (e.g., a battery voltage of 3.4V with a programmed
output voltage of 3.3V). When this happens, the PMOS
switch duty cycle increases to 100%, keeping the switch on
OPERATION
continuously. Known as dropout operation, the respective
output voltage equals the regulator’s input voltage minus
the voltage drops across the internal P-channel MOSFET
and the inductor.
Soft-Start Operation
In normal operating mode, soft-start works by gradually
increasing the peak inductor current for each step-down
switching regulator over a 500μs period. This allows each
output to rise slowly, helping minimize the inrush current
needed to charge up the output capacitor. A soft-start cycle
occurs whenever a given switching regulator is enabled.
Soft-start occurs only in normal operation, but not in
standby mode. Standby mode operation is already in-
herently current-limited, since the regulator works by
intermittently turning on a current source from BVIN to
SW. Changing the state of the STBY pin while the regu-
lators are operating doesn’t trigger a new soft-start cycle,
to avoid glitching the outputs.
Frequency/Slew Rate Select
The FSEL pin allows an application to dynamically trade
off between highest efciency and reduced electromag-
netic interference (EMI) emission.
When FSEL is high, the switching regulator frequency is
set to 2.25MHz to stay out of the AM radio band. Also,
new patented circuitry is enabled which limits the slew rate
of the switch nodes (SW1 and SW2). This new circuitry
is designed to transition the switch node over a period of
a few nanoseconds, signicantly reducing radiated EMI
and conducted supply noise.
相關PDF資料 |
PDF描述 |
|---|---|
| LTC3565EDD#PBF | 2.5 A SWITCHING REGULATOR, 4000 kHz SWITCHING FREQ-MAX, PDSO10 |
| LTC3565EDD#TRPBF | 2.5 A SWITCHING REGULATOR, 4000 kHz SWITCHING FREQ-MAX, PDSO10 |
| LTC3565EMSE#TRPBF | 2.5 A SWITCHING REGULATOR, 4000 kHz SWITCHING FREQ-MAX, PDSO10 |
| LTC3565IMSE#PBF | 2.5 A SWITCHING REGULATOR, 4000 kHz SWITCHING FREQ-MAX, PDSO10 |
| LTC3589EUJ-1#TRPBF | SWITCHING REGULATOR, 2600 kHz SWITCHING FREQ-MAX, PQCC40 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC3555 | 制造商:LINER 制造商全稱:Linear Technology 功能描述:High Effi ciency USB Power Manager + Triple Step-Down DC/DC |
| LTC3555EUFD#PBF | 功能描述:IC USB POWER HE 28-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 電源管理 - 專用 系列:- 標準包裝:1 系列:- 應用:手持/移動設備 電流 - 電源:- 電源電壓:3 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:14-WFDFN 裸露焊盤 供應商設備封裝:14-LLP-EP（4x4） 包裝:Digi-Reel® 配用:LP3905SD-30EV-ND - BOARD EVALUATION LP3905SD-30 其它名稱:LP3905SD-30DKR |
| LTC3555EUFD#TRPBF | 功能描述:IC USB POWER HE 28-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 電源管理 - 專用 系列:- 標準包裝:1 系列:- 應用:手持/移動設備 電流 - 電源:- 電源電壓:3 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:14-WFDFN 裸露焊盤 供應商設備封裝:14-LLP-EP（4x4） 包裝:Digi-Reel® 配用:LP3905SD-30EV-ND - BOARD EVALUATION LP3905SD-30 其它名稱:LP3905SD-30DKR |
| LTC3555EUFD-1#PBF | 功能描述:IC USB POWER HE 28-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 電源管理 - 專用 系列:- 標準包裝:1 系列:- 應用:手持/移動設備 電流 - 電源:- 電源電壓:3 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:14-WFDFN 裸露焊盤 供應商設備封裝:14-LLP-EP（4x4） 包裝:Digi-Reel® 配用:LP3905SD-30EV-ND - BOARD EVALUATION LP3905SD-30 其它名稱:LP3905SD-30DKR |
| LTC3555EUFD-1#TRPBF | 功能描述:IC USB POWER HE 28-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 電源管理 - 專用 系列:- 標準包裝:1 系列:- 應用:手持/移動設備 電流 - 電源:- 電源電壓:3 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:14-WFDFN 裸露焊盤 供應商設備封裝:14-LLP-EP（4x4） 包裝:Digi-Reel® 配用:LP3905SD-30EV-ND - BOARD EVALUATION LP3905SD-30 其它名稱:LP3905SD-30DKR |
發布緊急采購，3分鐘左右您將得到回復。