- 您現在的位置：買賣IC網 > PDF目錄377775 > LTC3548EMSE (LINEAR TECHNOLOGY CORP) Dual Synchronous,400mA/800mA, 2.25MHz Step-Down DC/DC Regulator PDF資料下載
參數資料
| 型號： | LTC3548EMSE |
| 廠商： | LINEAR TECHNOLOGY CORP |
| 元件分類： | 穩壓器 |
| 英文描述： | Dual Synchronous,400mA/800mA, 2.25MHz Step-Down DC/DC Regulator |
| 中文描述： | 1.6 A SWITCHING REGULATOR, 2700 kHz SWITCHING FREQ-MAX, PDSO10 |
| 封裝： | PLASTIC, MSOP-10 |
| 文件頁數： | 5/16頁 |
| 文件大?。?/td> | 239K |
| 代理商： | LTC3548EMSE |
LTC3548
5
3548f
V
FB1
(Pin 1):
Output Feedback. Receives the feedback
voltage from the external resistive divider across the
output. Nominal voltage for this pin is 0.6V.
RUN1 (Pin 2):
Regulator 1 Enable. Forcing this pin to V
IN
enables regulator 1, while forcing it to GND causes regu-
lator 1 to shut down. This pin must be driven; do not float.
V
IN
(Pin 3):
Main Power Supply. Must be closely decoupled
to GND.
SW1 (Pin 4):
Regulator 1 Switch Node Connection to the
Inductor. This pin swings from V
IN
to GND.
GND (Pin 5):
Main Ground. Connect to the (–) terminal of
C
OUT
, and (–) terminal of C
IN
.
MODE/SYNC (Pin 6):
Combination Mode Selection and
Oscillator Synchronization. This pin controls the operation
of the device. When tied to V
IN
or GND, Burst Mode
operation or pulse skipping mode is selected, respec-
tively. Do not float this pin. The oscillation frequency can
PIU
be synchronized to an external oscillator applied to this pin
and pulse skipping mode is automatically selected.
SW2 (Pin 7):
Regulator 2 Switch Node Connection to the
Inductor. This pin swings from V
IN
to GND.
POR (Pin 8):
Power-On Reset . This common-drain logic
output is pulled to GND when the output voltage falls
below –8.5% of regulation and goes high after 117ms
when both channels are within regulation.
RUN2 (Pin 9):
Regulator 2 Enable. Forcing this pin to V
IN
enables regulator 2, while forcing it to GND causes regu-
lator 2 to shut down. This pin must be driven; do not float.
V
FB2
(Pin 10):
Output Feedback. Receives the feedback
voltage from the external resistive divider across the
output. Nominal voltage for this pin is 0.6V.
Exposed Pad (GND) (Pin 11):
Power Ground. Connect to
the (–) terminal of C
OUT
, and (–) terminal of C
IN
. Must be
connected to electrical ground on PCB.
相關PDF資料 |
PDF描述 |
|---|---|
| LTC3701EGN | 2-Phase, Low Input Voltage, Dual Step-Down DC/DC Controller |
| LTC3701 | 16-Bit Universal Bus Driver With 3-State Outputs 48-SSOP -40 to 85 |
| LTC3708 | No RSENSE Low EMI, Synchronous DC/DC Controller with Output Tracking |
| LTC3736 | CTV 5C 5#20 SKT PLUG |
| LTC3736EGN | Dual 2-Phase, No RSENSE Synchronous Controller with Output Tracking |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC3548EMSE#PBF | 功能描述:IC REG BUCK SYNC ADJ DL 10MSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:2,500 系列:- 類型:降壓（降壓） 輸出類型:固定 輸出數:1 輸出電壓:1.2V，1.5V，1.8V，2.5V 輸入電壓:2.7 V ~ 20 V PWM 型:- 頻率 - 開關:- 電流 - 輸出:50mA 同步整流器:是 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:10-TFSOP，10-MSOP（0.118"，3.00mm 寬）裸露焊盤 包裝:帶卷 (TR) 供應商設備封裝:10-MSOP 裸露焊盤 |
| LTC3548EMSE#TRPBF | 功能描述:IC REG BUCK SYNC ADJ DL 10MSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:2,500 系列:- 類型:降壓（降壓） 輸出類型:固定 輸出數:1 輸出電壓:1.2V，1.5V，1.8V，2.5V 輸入電壓:2.7 V ~ 20 V PWM 型:- 頻率 - 開關:- 電流 - 輸出:50mA 同步整流器:是 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:10-TFSOP，10-MSOP（0.118"，3.00mm 寬）裸露焊盤 包裝:帶卷 (TR) 供應商設備封裝:10-MSOP 裸露焊盤 |
| LTC3548EMSE-PBF | 制造商:LINER 制造商全稱:Linear Technology 功能描述:Dual Synchronous, 400mA/800mA, 2.25MHz Step-Down DC/DC Regulator |
| LTC3548EMSE-TRPBF | 制造商:LINER 制造商全稱:Linear Technology 功能描述:Dual Synchronous, 400mA/800mA, 2.25MHz Step-Down DC/DC Regulator |
| LTC3548IDD | 制造商:LINER 制造商全稱:Linear Technology 功能描述:Dual Synchronous, 400mA/800mA, 2.25MHz |
發布緊急采購，3分鐘左右您將得到回復。