參數資料
型號: LTC3534EGN#TR
廠商: LINEAR TECHNOLOGY CORP
元件分類: 穩壓器
英文描述: SWITCHING REGULATOR, 1150 kHz SWITCHING FREQ-MAX, PDSO16
封裝: 0.150 INCH, LEAD FREE, PLASTIC, SSOP-16
文件頁數: 3/20頁
文件大?。?/td> 218K
代理商: LTC3534EGN#TR
LTC3534
11
3534f
In Burst Mode operation the typical maximum average
output currents in the three operating regions, buck, four
switch, and boost are given by:
IOUT(MAX)BURST–BUCK ≈ 100mA;
Burst Mode operation – buck region: VIN > VOUT
IOUT(MAX)BURST–FOUR_SWITCH ≈ 200mA;
Burst Mode operation – four switch region: VIN ≈ VOUT
IOUT(MAX)BURSTBOOST
200 VIN
VOUT
mA;
Burst Mode operation – boost region: VIN < VOUT
The efciency below 1mA becomes dominated primarily
by the quiescent current. The Burst Mode operation ef-
ciency is given by:
Efficiency
ηILOAD
25A
+ILOAD
where
η is typically 90% during Burst Mode operation.
A graph of Burst Mode operation maximum output current
vs VIN (for VOUT = 5V) is provided in the Typical Perfor-
mance Characteristics section.
Burst Mode Operation to Fixed Frequency Transient
Response
In Burst Mode operation, the compensation network is
not used and VC is disconnected from the error amplier.
During long periods of Burst Mode operation, leakage
currents in the external components or on the PC board
could cause the compensation capacitor to charge (or
discharge), which could result in a large output transient
when returning to xed frequency mode operation, even
at the same load current. To prevent this, the LTC3534
incorporates an active clamp circuit that holds the voltage
on VC at an optimal voltage during Burst Mode operation.
This minimizes any output transient when returning to
xed frequency mode operation. For optimum transient
response, Type III compensation is also recommended
to broad band the control loop and roll off past the two
pole response of the output LC lter. (See Closing the
Feedback Loop).
Soft-Start
The soft-start function is combined with shutdown. When
the RUN/SS pin is brought above 1V typical, the LTC3534
is enabled but the error amplier duty cycle is clamped
from VC. A detailed diagram of this function is shown in
Figure 3. The components RSS and CSS provide a slow
ramping voltage on RUN/SS to provide a soft-start function.
To ensure that VC is not being clamped, RUN/SS must be
raised to 2.4V or above.
OPERATION
+
15
14
13
2
11
VIN
CSS
RSS
RUN/SS
1V
FB
R1
R2
CP1
VC
VCI
VOUT
1V
TO PWM
COMPARATORS
CHIP
ENABLE
SIGNAL
3534 F03
+
ERROR
AMP
Figure 3. Soft-Start Circuitry
相關PDF資料
PDF描述
LTC3534EDHC SWITCHING REGULATOR, 1150 kHz SWITCHING FREQ-MAX, PDSO16
LTC3536EMSE#PBF 4 A SWITCHING REGULATOR, 1440 kHz SWITCHING FREQ-MAX, PDSO12
LTC3536IMSE#PBF 4 A SWITCHING REGULATOR, 1440 kHz SWITCHING FREQ-MAX, PDSO12
LTC3536EDD#PBF 4 A SWITCHING REGULATOR, 1440 kHz SWITCHING FREQ-MAX, PDSO10
LTC3546EFE#PBF DUAL SWITCHING CONTROLLER, 4000 kHz SWITCHING FREQ-MAX, PDSO28
相關代理商/技術參數
參數描述
LTC3535 制造商:LINER 制造商全稱:Linear Technology 功能描述:Dual Channel 550mA 1MHz Synchronous Step-Up DC/DC Converter
LTC3535EDD#PBF 功能描述:IC REG BST SYNC ADJ 0.55A 12DFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 設計資源:Design Support Tool 標準包裝:1 系列:- 類型:升壓(升壓) 輸出類型:固定 輸出數:1 輸出電壓:3V 輸入電壓:0.75 V ~ 2 V PWM 型:- 頻率 - 開關:- 電流 - 輸出:100mA 同步整流器:是 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:SOT-23-5 細型,TSOT-23-5 包裝:剪切帶 (CT) 供應商設備封裝:TSOT-23-5 其它名稱:AS1323-BTTT-30CT
LTC3535EDD#PBF 制造商:Linear Technology 功能描述:DC/DC CONVERTER IC
LTC3535EDD#TRPBF 功能描述:IC REG BST SYNC ADJ 0.55A 12DFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:2,500 系列:- 類型:降壓(降壓) 輸出類型:固定 輸出數:1 輸出電壓:1.2V,1.5V,1.8V,2.5V 輸入電壓:2.7 V ~ 20 V PWM 型:- 頻率 - 開關:- 電流 - 輸出:50mA 同步整流器:是 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:10-TFSOP,10-MSOP(0.118",3.00mm 寬)裸露焊盤 包裝:帶卷 (TR) 供應商設備封裝:10-MSOP 裸露焊盤
LTC3535EDD-PBF 制造商:LINER 制造商全稱:Linear Technology 功能描述:Dual Channel 550mA 1MHz Synchronous Step-Up DC/DC Converter