- 您現在的位置：買賣IC網 > PDF目錄377775 > LTC3442EDE (Linear Integrated Systems) Micropower Synchronous Buck-Boost DC/DC Converter with Automatic Burst Mode Operation PDF資料下載
參數資料
| 型號： | LTC3442EDE |
| 廠商： | Linear Integrated Systems |
| 英文描述： | Micropower Synchronous Buck-Boost DC/DC Converter with Automatic Burst Mode Operation |
| 中文描述： | 微功率同步降壓升壓與自動突發模式的DC / DC轉換器操作 |
| 文件頁數： | 11/20頁 |
| 文件大?。?/td> | 332K |
| 代理商： | LTC3442EDE |
LTC3442
11
3442f
current in Amps. Do not use values of R
BURST
greater than
250k.
For automatic operation, a filter capacitor should also be
connected from BURST to ground to prevent ripple on
BURST from causing the IC to oscillate in and out of Burst
Mode operation. The equation for the minimum capacitor
value is:
C
C
V
BURST MIN
OUT
60 000
OUT
(
)
,
≥
where C
BURST(MIN)
and C
OUT
are in
μ
F
In the event that a load transient causes the feedback pin
to drop by more than 4% from the regulation value while
in Burst Mode operation, the IC will immediately switch to
fixed frequency mode and an internal pull-up will be
momentarily applied to BURST, rapidly charging the
BURST cap. This prevents the IC from immediately re-
entering Burst Mode operation once the output achieves
regulation.
Manual Burst Mode Operation
For manual control of Burst Mode operation, the RC
network connected to BURST can be eliminated. To force
fixed frequency mode, BURST should be connected to
V
OUT
. To force Burst Mode operation, BURST should be
grounded. When commanding Burst Mode operation
manually, the circuit connected to BURST should be able
to sink up to 2mA.
For optimum transient response with large dynamic loads,
the operating mode should be controlled manually by the
host. By commanding fixed frequency operation prior to a
sudden increase in load, output voltage droop can be
minimized. Note that if the load current applied during
forced Burst Mode operation (BURST pin is grounded)
exceeds the current that can be supplied, the output
voltage will start to droop and the IC will automatically
come out of Burst Mode operation and enter fixed fre-
quency mode, raising V
OUT
. Once regulation is achieved,
the IC will then enter Burst Mode operation once again,
and the cycle will repeat, resulting in about 4% output
ripple. Note that Burst Mode operation is inhibited during
soft-start.
Burst Mode Operation to Fixed Frequency Transient
Response
In Burst Mode operation, the compensation network is not
used and V
C
is disconnected from the error amplifier.
During long periods of Burst mode operation, leakage
currents in the external components or on the PC board
could cause the compensation capacitor to charge (or
discharge), which could result in a large output transient
when returning to fixed frequency mode of operation, even
at the same load current. To prevent this, the LTC3442
incorporates an active clamp circuit that holds the voltage
on V
C
at an optimal voltage during Burst Mode operation.
This minimizes any output transient when returning to
fixed frequency mode operation. For optimum transient
OPERATIOU
相關PDF資料 |
PDF描述 |
|---|---|
| LTC3458L | 1.7A, 1.5MHz Synchronous Step-Up DC/DC Converter with Output Disconnect |
| LTC3458EDE | 1.4A, 1.5MHz Synchronous Step-Up DC/DC Converter with Output Disconnect |
| LTC3458 | ECONOLINE: RSZ/P - 1kVDC |
| LTC3458LEDE | 1.7A, 1.5MHz Synchronous Step-Up DC/DC Converter with Output Disconnect |
| LTC3548EDD | Dual Synchronous,400mA/800mA, 2.25MHz Step-Down DC/DC Regulator |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC3442EDE#PBF | 功能描述:IC REG BUCK BOOST SYNC ADJ 12DFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:250 系列:- 類型:降壓（降壓） 輸出類型:固定 輸出數:1 輸出電壓:1.2V 輸入電壓:2.05 V ~ 6 V PWM 型:電壓模式 頻率 - 開關:2MHz 電流 - 輸出:500mA 同步整流器:是 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:6-UFDFN 包裝:帶卷 (TR) 供應商設備封裝:6-SON（1.45x1） 產品目錄頁面:1032 (CN2011-ZH PDF) 其它名稱:296-25628-2 |
| LTC3442EDE#TR | 制造商:Linear Technology 功能描述:Conv DC-DC Single Non-Inv/Inv/Step Up/Step Down 2.4V to 5.5V 12-Pin DFN EP T/R |
| LTC3442EDE#TRPBF | 功能描述:IC REG BUCK BOOST SYNC ADJ 12DFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:2,500 系列:- 類型:降壓（降壓） 輸出類型:固定 輸出數:1 輸出電壓:1.2V，1.5V，1.8V，2.5V 輸入電壓:2.7 V ~ 20 V PWM 型:- 頻率 - 開關:- 電流 - 輸出:50mA 同步整流器:是 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:10-TFSOP，10-MSOP（0.118"，3.00mm 寬）裸露焊盤 包裝:帶卷 (TR) 供應商設備封裝:10-MSOP 裸露焊盤 |
| LTC3443 | 制造商:LINER 制造商全稱:Linear Technology 功能描述:High Current Micropower 600kHz Synchronous Buck-Boost DC/DC Converter |
| LTC3443EDE | 功能描述:IC REG BUCK BOOST SYNC ADJ 12DFN RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:2,500 系列:- 類型:降壓（降壓） 輸出類型:固定 輸出數:1 輸出電壓:1.2V，1.5V，1.8V，2.5V 輸入電壓:2.7 V ~ 20 V PWM 型:- 頻率 - 開關:- 電流 - 輸出:50mA 同步整流器:是 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:10-TFSOP，10-MSOP（0.118"，3.00mm 寬）裸露焊盤 包裝:帶卷 (TR) 供應商設備封裝:10-MSOP 裸露焊盤 |
發布緊急采購，3分鐘左右您將得到回復。