參數資料
型號： LTC3411EMS
廠商： LINEAR TECHNOLOGY CORP
元件分類： 穩壓器
英文描述： 1.25A, 4MHz, Synchronous Step-Down DC/DC Converter
中文描述： 2 A SWITCHING REGULATOR, 4000 kHz SWITCHING FREQ-MAX, PDSO10
封裝： PLASTIC, MSOP-10
文件頁數： 3/20頁
文件大?。?/td> 288K
代理商： LTC3411EMS
LTC3411
3
sn3411 3411fs
ELECTRICAL CHARACTERISTICS
temperature range, otherwise specifications are at T
A
= 25
°
C. V
IN
= 3.3V, R
T
= 324k unless otherwise specified. (Note 2)
SYMBOL
PARAMETER
CONDITIONS
PGOOD
Power Good Threshold
V
FB
Ramping Up, SHDN/R
T
= 1V
V
FB
Ramping Down, SHDN/R
T
= 1V
R
PGOOD
Power Good Pull-Down On-Resistance
The
G
denotes the specifications which apply over the full operating
MIN
TYP
6.8
–7.6
118
MAX
UNITS
%
%
200
Note 1:
Absolute Maximum Ratings are those values beyond which the life
of a device may be impaired.
Note 2:
The LTC3411E is guaranteed to meet specified performance from
0
°
C to 70
°
C. Specifications over the –40
°
C to 85
°
C operating ambient
termperature range are assured by design, characterization and correlation
with statistical process controls.
Note 3:
The LTC3411 is tested in a feedback loop which servos V
FB
to the
midpoint for the error amplifier (V
ITH
= 0.6V).
Note 4:
Dynamic supply current is higher due to the internal gate charge
being delivered at the switching frequency.
Note 5:
T
J
is calculated from the ambient T
A
and power dissipation P
D
according to the following formula:
LTC3411EDD: T
J
= T
A
+ (P
D
43
°
C/W)
LTC3411EMS: T
J
= T
A
+ (P
D
120
°
C/W)
Note 6:
Switch on-resistance is guaranteed by correlation to wafer level
measurements.
Note 7:
4MHz operation is guaranteed by design but not production tested
and is subject to duty cycle limitations (see Applications Information).
Note 8:
This IC includes overtemperature protection that is intended to
protect the device during momentary overload conditions. Junction
temperature will exceed 125
°
C when overtemperature protection is active.
Continuous operation above the specified maximum operating junction
temperature may impair device reliability.
PU
SHDN/R
T
(Pin 1):
Combination Shutdown and Timing
Resistor Pin. The oscillator frequency is programmed by
connecting a resistor from this pin to ground. Forcing this
pin to SV
IN
causes the device to be shut down. In shut-
down all functions are disabled.
SYNC/MODE (Pin 2):
Combination Mode Selection and
Oscillator Synchronization Pin. This pin controls the op-
eration of the device. When tied to SV
IN
or SGND, Burst
Mode operation or pulse skipping mode is selected, re-
spectively. If this pin is held at half of SV
IN
, the forced
continuous mode is selected. The oscillation frequency
can be syncronized to an external oscillator applied to this
pin. When synchronized to an external clock pulse skip
mode is selected.
SGND (Pin 3):
The Signal Ground Pin. All small signal
components and compensation components should be
connected to this ground (see Board Layout Consider-
ations).
SW (Pin 4):
The Switch Node Connection to the Inductor.
This pin swings from PV
IN
to PGND.
PGND (Pin 5):
Main Power Ground Pin. Connect to the
(–) terminal of C
OUT
, and (–) terminal of C
IN
.
PV
IN
(Pin 6):
Main Supply Pin. Must be closely decoupled
to PGND.
SV
IN
(Pin 7):
The Signal Power Pin. All active circuitry is
powered from this pin. Must be closely decoupled to
SGND. SV
IN
must be greater than or equal to PV
IN
.
PGOOD (Pin 8):
The Power Good Pin. This common drain
logic output is pulled to SGND when the output voltage is
not within
±
7.5% of regulation.
V
FB
(Pin 9):
Receives the feedback voltage from the
external resistive divider across the output. Nominal volt-
age for this pin is 0.8V.
I
TH
(Pin 10):
Error Amplifier Compensation Point. The
current comparator threshold increases with this control
voltage. Nominal voltage range for this pin is 0V to 1.5V.
相關PDF資料
PDF描述
LTC3411 1.25A, 4MHz, Synchronous Step-Down DC/DC Converter
LTC3411EDD 1.25A, 4MHz, Synchronous Step-Down DC/DC Converter
LTC3413 3A, 2MHz Monolithic Synchronous Regulator for DDR/QDR Memory Termination
LTC3413EFE 3A, 2MHz Monolithic Synchronous Regulator for DDR/QDR Memory Termination
LTC3423 Low Output Voltage 3MHz Micropower Synchronous Boost Converters
相關代理商/技術參數
參數描述
LTC3411EMS#PBF 功能描述:IC REG BUCK SYNC ADJ 10MSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:250 系列:- 類型:降壓（降壓） 輸出類型:固定 輸出數:1 輸出電壓:1.2V 輸入電壓:2.05 V ~ 6 V PWM 型:電壓模式 頻率 - 開關:2MHz 電流 - 輸出:500mA 同步整流器:是 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:6-UFDFN 包裝:帶卷 (TR) 供應商設備封裝:6-SON（1.45x1） 產品目錄頁面:1032 (CN2011-ZH PDF) 其它名稱:296-25628-2
LTC3411EMS#PBFTR 制造商:Linear Technology 功能描述:Conv DC-DC Single Step Down 2.63V to 5.5V 10-Pin MSOP T/R
LTC3411EMS#TR 功能描述:IC REG BUCK SYNC ADJ 10MSOP RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:2,500 系列:- 類型:降壓（降壓） 輸出類型:固定 輸出數:1 輸出電壓:1.2V，1.5V，1.8V，2.5V 輸入電壓:2.7 V ~ 20 V PWM 型:- 頻率 - 開關:- 電流 - 輸出:50mA 同步整流器:是 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:10-TFSOP，10-MSOP（0.118"，3.00mm 寬）裸露焊盤 包裝:帶卷 (TR) 供應商設備封裝:10-MSOP 裸露焊盤
LTC3411EMS#TRPBF 功能描述:IC REG BUCK SYNC ADJ 10MSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:2,500 系列:- 類型:降壓（降壓） 輸出類型:固定 輸出數:1 輸出電壓:1.2V，1.5V，1.8V，2.5V 輸入電壓:2.7 V ~ 20 V PWM 型:- 頻率 - 開關:- 電流 - 輸出:50mA 同步整流器:是 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:10-TFSOP，10-MSOP（0.118"，3.00mm 寬）裸露焊盤 包裝:帶卷 (TR) 供應商設備封裝:10-MSOP 裸露焊盤
LTC3411EMSPBF 制造商:Linear Technology 功能描述:LTC3411 adj 1.5A sync SD dc-dc converter
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*