- 您現在的位置：買賣IC網 > PDF目錄9002 > LTC2621CDD#PBF (Linear Technology)IC DAC 12BIT SGL R-R VOUT 10DFN PDF資料下載
參數資料
| 型號： | LTC2621CDD#PBF |
| 廠商： | Linear Technology |
| 文件頁數： | 4/16頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC DAC 12BIT SGL R-R VOUT 10DFN |
| 標準包裝： | 121 |
| 設置時間： | 7µs |
| 位數： | 12 |
| 數據接口： | 串行 |
| 轉換器數目： | 1 |
| 電壓電源： | 單電源 |
| 功率耗散（最大）： | 1.88mW |
| 工作溫度： | 0°C ~ 70°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 10-WFDFN 裸露焊盤 |
| 供應商設備封裝： | 10-DFN（3x3） |
| 包裝： | 管件 |
| 輸出數目和類型： | 1 電壓，單極 |
| 采樣率（每秒）： | * |
| 產品目錄頁面： | 1351 (CN2011-ZH PDF) |
第1頁第2頁第3頁當前第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁
LTC2601/LTC2611/LTC2621
12
2601fb
OPERATION
next device in the chain. The shift registers of the devices
are thus connected in series, effectively forming a single
input shift register which extends through the entire
chain. Because of this, the devices can be addressed and
controlled individually by simply concatenating their input
words; the rst instruction addresses the last device in
the chain and so forth. The SCK and CS/LD signals are
common to all devices in the series.
In use, CS/LD is rst taken low. Then the concatenated
input data is transferred to the chain, using SDI of the
rst device as the data input. When the data transfer is
complete, CS/LD is taken high, which executes the com-
mands specied for each of the devices simultaneously. A
single device can be controlled by using the no-operation
command (1111) for the other devices in the chain.
Power-Down Mode
For power-constrained applications, power-down mode
can be used to reduce the supply current whenever the
DAC output is not needed. When in power-down, the buffer
amplier, bias circuit and reference input is disabled and
draws essentially zero current. The DAC output is put into a
high impedance state, and the output pin is passively pulled
to ground through 90k resistors. Input- and DAC-register
contents are not disturbed during power-down.
The DAC can be put into power-down mode by using
command 0100b. The 16-bit data word is ignored. The
supply and reference currents are reduced to almost zero
when the DAC is powered down; the effective resistance at
REF rises accordingly becoming a high impedance input
(typically > 1GΩ).
Normal operation can be resumed by executing any com-
mand which includes a DAC update, as shown in Table 1 or
performing an asynchronous update (LDAC) as described
in the next section. The DAC is powered up as its voltage
output is updated. When the DAC in powered-down state
is powered up and updated, normal settling is delayed. The
main bias generation circuit block has been automatically
shut down in addition to the DAC amplier and reference
input and so the power up delay time is 12μs (for VCC =
5V) or 30μs (for VCC = 3V).
Asynchronous DAC Update Using LDAC
In addition to the update commands shown in Table 1,
the LDAC pin asynchronously updates the DAC register
with the contents of the input register.
If CS/LD is high, a low on the LDAC pin causes the DAC
register to be updated with the contents of the input
register.
If CS/LD is low, a low going pulse on the LDAC pin before
the rising edge of CS/LD powers up the DAC but does not
cause the output to be updated. If LDAC remains low after
INPUT WORD (LTC2601)
INPUT WORD (LTC2611)
INPUT WORD (LTC2621)
C3
COMMAND
DON’T CARE BITS
DATA (16 BITS)
C2
C1
C0
X
D13
D14
D15
D12 D11 D10 D9
D8
D7 D6
D5
D4
D3
D2
D1 D0
2601 TBL01
MSB
LSB
C3
COMMAND
DON’T CARE BITS
DATA (14 BITS + 2 DON’T CARE BITS)
C2
C1
C0
X
D13 D12 D11 D10 D9
D8
D7 D6
D5
D4
D3
D2
D1 D0
X
2601 TBL02
MSB
LSB
C3
COMMAND
DON’T CARE BITS
DATA (12 BITS + 4 DON’T CARE BITS)
C2
C1
C0
X
D11 D10 D9
D8
D7 D6
D5
D4
D3
D2
D1 D0
X
XX
2601 TBL03
MSB
LSB
相關PDF資料 |
PDF描述 |
|---|---|
| AD5424YRUZ | IC DAC 8BIT MULTIPLYING 16-TSSOP |
| IDT23S08E-1HPGI | IC CLK MULT PLL HI DRV 16-TSSOP |
| IDT23S08E-1HPGGI | IC CLK MULT ZD HI DRIVE 16-TSSOP |
| VI-J5V-MZ-F3 | CONVERTER MOD DC/DC 5.8V 25W |
| IDT23S08E-5HDCI | IC CLK MULT PLL HI DRV 16-SOIC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC-2621E | 功能描述:LED 顯示器和配件 3 Digit, Orange RoHS:否 制造商:Avago Technologies 顯示器類型:7 Segment 數位數量:2 字符大小:7.8 mm x 14.22 mm 照明顏色:Red 波長:628 nm 共用管腳:Common Anode 工作電壓:2.05 V 工作電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 35 C 封裝:Tube |
| LTC-2621G | 功能描述:LED 顯示器和配件 3 Digit, Green RoHS:否 制造商:Avago Technologies 顯示器類型:7 Segment 數位數量:2 字符大小:7.8 mm x 14.22 mm 照明顏色:Red 波長:628 nm 共用管腳:Common Anode 工作電壓:2.05 V 工作電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 35 C 封裝:Tube |
| LTC2621IDD | 功能描述:IC DAC 12BIT SGL R-R VOUT 10DFN RoHS:否 類別:集成電路 (IC) >> 數據采集 - 數模轉換器 系列:- 產品培訓模塊:Data Converter Fundamentals DAC Architectures 設計資源:Unipolar, Precision DC Digital-to-Analog Conversion using AD5450/1/2/3 8-14-Bit DACs (CN0052) Precision, Bipolar, Configuration for AD5450/1/2/3 8-14bit Multiplying DACs (CN0053) AC Signal Processing Using AD5450/1/2/3 Current Output DACs (CN0054) Programmable Gain Element Using AD5450/1/2/3 Current Output DAC Family (CN0055) Single Supply Low Noise LED Current Source Driver Using a Current Output DAC in the Reverse Mode (CN0139) 標準包裝:10,000 系列:- 設置時間:- 位數:12 數據接口:DSP，MICROWIRE?，QSPI?，串行，SPI? 轉換器數目:1 電壓電源:單電源 功率耗散（最大）:- 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:SOT-23-8 薄型，TSOT-23-8 供應商設備封裝:TSOT-23-8 包裝:帶卷 (TR) 輸出數目和類型:1 電流，單極；1 電流，雙極 采樣率（每秒）:2.7M |
| LTC2621IDD#PBF | 功能描述:IC DAC 12BIT SGL R-R VOUT 10DFN RoHS:是 類別:集成電路 (IC) >> 數據采集 - 數模轉換器 系列:- 產品培訓模塊:Data Converter Fundamentals DAC Architectures 設計資源:Unipolar, Precision DC Digital-to-Analog Conversion using AD5450/1/2/3 8-14-Bit DACs (CN0052) Precision, Bipolar, Configuration for AD5450/1/2/3 8-14bit Multiplying DACs (CN0053) AC Signal Processing Using AD5450/1/2/3 Current Output DACs (CN0054) Programmable Gain Element Using AD5450/1/2/3 Current Output DAC Family (CN0055) Single Supply Low Noise LED Current Source Driver Using a Current Output DAC in the Reverse Mode (CN0139) 標準包裝:10,000 系列:- 設置時間:- 位數:12 數據接口:DSP，MICROWIRE?，QSPI?，串行，SPI? 轉換器數目:1 電壓電源:單電源 功率耗散（最大）:- 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:SOT-23-8 薄型，TSOT-23-8 供應商設備封裝:TSOT-23-8 包裝:帶卷 (TR) 輸出數目和類型:1 電流，單極；1 電流，雙極 采樣率（每秒）:2.7M |
| LTC2621IDD#TR | 功能描述:IC DAC 12BIT SGL R-R VOUT 10DFN RoHS:否 類別:集成電路 (IC) >> 數據采集 - 數模轉換器 系列:- 產品培訓模塊:Data Converter Fundamentals DAC Architectures 設計資源:Unipolar, Precision DC Digital-to-Analog Conversion using AD5450/1/2/3 8-14-Bit DACs (CN0052) Precision, Bipolar, Configuration for AD5450/1/2/3 8-14bit Multiplying DACs (CN0053) AC Signal Processing Using AD5450/1/2/3 Current Output DACs (CN0054) Programmable Gain Element Using AD5450/1/2/3 Current Output DAC Family (CN0055) Single Supply Low Noise LED Current Source Driver Using a Current Output DAC in the Reverse Mode (CN0139) 標準包裝:10,000 系列:- 設置時間:- 位數:12 數據接口:DSP，MICROWIRE?，QSPI?，串行，SPI? 轉換器數目:1 電壓電源:單電源 功率耗散（最大）:- 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:SOT-23-8 薄型，TSOT-23-8 供應商設備封裝:TSOT-23-8 包裝:帶卷 (TR) 輸出數目和類型:1 電流，單極；1 電流，雙極 采樣率（每秒）:2.7M |
發布緊急采購，3分鐘左右您將得到回復。