參數資料
型號： LTC2442IG#PBF
廠商： Linear Technology
文件頁數： 28/32頁
文件大?。?/td> 0K
描述： IC ADC 24BIT 4CH 36-SSOP
標準包裝： 37
位數： 24
采樣率（每秒）： 8k
數據接口： MICROWIRE?，串行，SPI?
轉換器數目： 1
功率耗散（最大）： 50mW
電壓電源： 單電源
工作溫度： -40°C ~ 85°C
安裝類型： 表面貼裝
封裝/外殼： 36-SSOP（0.209"，5.30mm 寬）
供應商設備封裝： 36-SSOP
包裝： 管件
輸入數目和類型： 4 個單端，雙極；2 個差分，雙極
產品目錄頁面： 1348 (CN2011-ZH PDF)
配用： DC979A-ND - BOARD DELTA SIGMA ADC LTC2442
LTC2442
5
2442fa
For more information www.linear.com/LTC2442
Note 1: Stresses beyond those listed under Absolute Maximum Ratings
may cause permanent damage to the device. Exposure to any Absolute
Maximum Rating condition for extended periods may affect device
reliability and lifetime.
Note 2: All voltage values are with respect to GND.
Note 3: VCC = 4.5V to 5.5V unless otherwise specified.
VREF = REF+ – REF–, VREFCM = (REF+ + REF–)/2;
VIN = SEL+ – SEL–, VINCM = (SEL+ + SEL–)/2.
Note 4: FO pin tied to GND or to external conversion clock source with
fEOSC = 10MHz unless otherwise specified.
Note 5: Guaranteed by design, not subject to test.
Note 6: Integral nonlinearity is defined as the deviation of a code from a
straight line passing through the actual endpoints of the transfer curve.
The deviation is measured from the center of the quantization band.
Note 7: The converter uses the internal oscillator.
Note 8: The converter is in external SCK mode of operation such that the
SCK pin is used as a digital input. The frequency of the clock signal driving
SCK during the data output is fESCK and is expressed in Hz.
Note 9: The converter is in internal SCK mode of operation such that the
SCK pin is used as a digital output. In this mode of operation, the SCK pin
has a total equivalent load capacitance of CLOAD = 20pF.
Note 10: The external oscillator is connected to the FO pin. The external
oscillator frequency, fEOSC, is expressed in Hz.
Note 11: The converter uses the internal oscillator. FO = 0V.
Note 12: Guaranteed by design and test correlation.
Note 13: There is an internal reset that adds an additional 1s (typ) to the
conversion time.
Note 14: In order to achieve optimum linearity, the amplifier power
positive supply input (V+) must exceed the maximum input voltage level by
2V or greater. The negative amplifier power supply input (V–) must be at
least 200mV below the minimum input voltage level.
Note 15: Amplifiers are externally compensated with 0.1F.
The l denotes the specifications which apply over the full operating temperature
range, otherwise specifications are at TA = 25°C. (Note 3)
SYMBOL
PARAMETER
CONDITIONS
MIN
TYP
MAX
UNITS
fEOSC
External Oscillator Frequency Range
l
0.1
20
MHz
tHEO
External Oscillator High Period
l
25
10000
ns
tLEO
External Oscillator Low Period
l
25
10000
ns
tCONV
Conversion Time
OSR = 256 (SDI = 0)
OSR = 32768 (SDI = 1)
External Oscillator (Notes 10, 13)
l
0.99
126
1.13
145
40 OSR + 170
fEOSC (KHz)
1.33
170
ms
fISCK
Internal SCK Frequency
Internal Oscillator (Note 9)
External Oscillator (Notes 9, 10)
l
0.8
0.9
fEOSC/10
1
MHz
Hz
DISCK
Internal SCK Duty Cycle
(Note 9)
l
45
55
%
fESCK
External SCK Frequency Range
(Note 8)
l
20
MHz
fLESCK
External SCK Low Period
(Note 8)
l
25
ns
tHESCK
External SCK High Period
(Note 8)
l
25
ns
tDOUT_ISCK
Internal SCK 32-Bit Data Output Time
Internal Oscillator (Notes 9, 11)
External Oscillator (Notes 9, 10)
l
30.9
35.3
320/fEOSC
41.6
s
tDOUT_ESCK
External SCK 32-Bit Data Output Time
(Note 8)
l
32/fESCK
s
t1
CS
↓ to SDO Low Z
(Note 12)
l
0
25
ns
t2
CS
↑ to SDO High Z
(Note 12)
l
0
25
ns
t3
CS
↓ to SCK ↓
(Note 9)
5
s
t4
CS
↓ to SCK ↑
(Note 8, 12)
l
25
ns
tKQMAX
SCK
↓ to SDO Valid
l
25
ns
tKQMIN
SDO Hold After SCK
↓
(Note 5)
l
15
ns
t5
SCK Setup Before CS
↓
l
50
ns
t6
SCK Hold After CS
↓
l
50
ns
t7
SDI Setup Before SCK
↑
(Note 5)
l
10
ns
t8
SDI Hold After SCK
↑
(Note 5)
l
10
ns
tiMing characteristics
相關PDF資料
PDF描述
LTC2446IUHF#TRPBF IC ADC 24BIT 8CH HI SPEED 38QFN
LTC2448IUHF#TRPBF IC ADC 24BIT HI SPEED 38QFN
LTC2451ITS8#TRPBF IC ADC 16BIT DELTA SIG TSOT23-8
LTC2452ITS8#TRPBF IC ADC 16BIT DELTA SIG TSOT23-8
LTC2453ITS8#TRMPBF IC ADC 16BIT DELTA SIG TSOT23-8
相關代理商/技術參數
參數描述
LTC2444CUHF 功能描述:IC ADC 24BIT HI SPEED 38QFN RoHS:否 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:16 采樣率（每秒）:45k 數據接口:串行 轉換器數目:2 功率耗散（最大）:315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端，單極
LTC2444CUHF#PBF 功能描述:IC ADC 24BIT HI SPEED 38QFN RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 其它有關文件:TSA1204 View All Specifications 標準包裝:1 系列:- 位數:12 采樣率（每秒）:20M 數據接口:并聯 轉換器數目:2 功率耗散（最大）:155mW 電壓電源:模擬和數字 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:48-TQFP 供應商設備封裝:48-TQFP（7x7） 包裝:Digi-Reel® 輸入數目和類型:4 個單端，單極；2 個差分，單極 產品目錄頁面:1156 (CN2011-ZH PDF) 其它名稱:497-5435-6
LTC2444CUHF#TR 功能描述:IC ADC 24BIT HI SPEED 38QFN RoHS:否 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:16 采樣率（每秒）:45k 數據接口:串行 轉換器數目:2 功率耗散（最大）:315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端，單極
LTC2444CUHF#TRPBF 功能描述:IC ADC 24BIT HI SPEED 38QFN RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:16 采樣率（每秒）:45k 數據接口:串行 轉換器數目:2 功率耗散（最大）:315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端，單極
LTC2444IUHF 功能描述:IC ADC 24BIT HI SPEED 38QFN RoHS:否 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:16 采樣率（每秒）:45k 數據接口:串行 轉換器數目:2 功率耗散（最大）:315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端，單極
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*