impedance for the REF+ and REF
參數資料
型號: LTC2439-1CGN
廠商: Linear Technology
文件頁數: 18/28頁
文件大?。?/td> 0K
描述: IC ADC 16BIT 16CH MCRPWR 28SSOP
標準包裝: 49
位數: 16
采樣率(每秒): 6.8
數據接口: MICROWIRE?,串行,SPI?
轉換器數目: 1
功率耗散(最大): 1mW
電壓電源: 單電源
工作溫度: 0°C ~ 70°C
安裝類型: 表面貼裝
封裝/外殼: 28-SSOP(0.154",3.90mm 寬)
供應商設備封裝: 28-SSOP
包裝: 管件
輸入數目和類型: 16 個單端,雙極;8 個差分,雙極
配用: DC790A-ND - BOARD DELTA SIGMA ADC LTC2439-1
LTC2439-1
25
24391fa
impedance for the REF+ and REFpins does not help the
gain or the INL error. The user is thus advised to minimize
the combined source impedance driving the REF+ and
REFpins rather than to try to match it.
The magnitude of the dynamic reference current depends
upon the size of the very stable internal sampling capaci-
tors and upon the accuracy of the converter sampling
clock. The accuracy of the internal clock over the entire
temperature and power supply range is typical better than
0.5%. Such a specification can also be easily achieved by
an external clock. When relatively stable resistors
(50ppm/
°C) are used for the external source impedance
seen by REF+ and REF, the expected drift of the dynamic
current gain error will be insignificant (about 1% of its
value over the entire temperature and voltage range). Even
for the most stringent applications a one-time calibration
operation may be sufficient.
In addition to the reference sampling charge, the reference
pins ESD protection diodes have a temperature dependent
leakage current. This leakage current, nominally 1nA
(
±10nA max), results in a small gain error. A 100 source
resistance will create a 0.05
V typical and 0.5V maxi-
mum full-scale error.
Output Data Rate
When using its internal oscillator, the LTC2439-1 can
produce up to 6.8 readings per second. The actual output
data rate will depend upon the length of the sleep and data
output phases which are controlled by the user and which
can be made insignificantly short. When operated with an
external conversion clock (FO connected to an external
oscillator), the LTC2439-1 output data rate can be in-
creased as desired. The duration of the conversion phase
is 20510/fEOSC. If fEOSC = 139,800Hz, the converter be-
haves as if the internal oscillator is used with simultaneous
50Hz/60Hz. There is no significant difference in the
LTC2439-1 performance between these two operation
modes.
An increase in fEOSC over the nominal 139,800Hz will
translate into a proportional increase in the maximum
output data rate. This substantial advantage is neverthe-
less accompanied by three potential effects, which must
be carefully considered.
RSOURCE ()
0 100 200 300 400 500 600 700 800 900 1000
+
FS
ERROR
(LSB)
24361 F21
0
6
11
17
22
30
VCC = 5V
REF+ = 5V
REF= GND
IN+ = 3.75V
IN = 1.25V
FO = GND
TA = 25°C
CREF = 0.01F
CREF = 0.1F
CREF = 1F, 10F
RSOURCE ()
0 100 200 300 400 500 600 700 800 900 1000
FS
ERROR
(LSB)
24361 F22
30
22
17
11
6
0
VCC = 5V
REF+ = 5V
REF= GND
IN+ = 1.25V
IN = 3.75V
FO = GND
TA = 25°C
CREF = 0.01F
CREF = 0.1F
CREF = 1F, 10F
VINDIF/VREFDIF
–0.5 –0.4–0.3–0.2–0.1 0
0.1 0.2 0.3 0.4 0.5
INL
(LSB)
1
0
–1
VCC = 5V
REF+ = 5V
REF– = GND
VINCM = 0.5 (IN
+ + IN) = 2.5V
FO = GND
CREF = 10F
TA = 25°C
RSOURCE = 1000
24361 F23
Figure 21. +FS Error vs RSOURCE at REF+ and REF(Large CREF)
Figure 22. –FS Error vs RSOURCE at REF+ and REF(Large CREF)
Figure 23. INL vs Differential Input Voltage (VIN = IN
+ – IN)
and Reference Source Resistance (RSOURCE at REF+ and REF
for Large CREF Values (CREF ≥ 1F)
APPLICATIO S I FOR ATIO
WU
UU
相關PDF資料
PDF描述
VE-21X-IU-S CONVERTER MOD DC/DC 5.2V 200W
VE-B33-IX-B1 CONVERTER MOD DC/DC 24V 75W
MS27497E22B35SLC CONN HSG RCPT 100POS WALL MT SKT
LTC1198-1BCS8 IC ADC 8BIT 750KHZ SAMPL 8-SOIC
VE-B31-IX-B1 CONVERTER MOD DC/DC 12V 75W
相關代理商/技術參數
參數描述
LTC2439-1CGN#PBF 功能描述:IC ADC 16BIT 16CH MCRPWR 28SSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:16 采樣率(每秒):45k 數據接口:串行 轉換器數目:2 功率耗散(最大):315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC(0.295",7.50mm 寬) 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端,單極
LTC2439-1CGN#TR 功能描述:IC ADC 16BIT 16CH MCRPWR 28SSOP RoHS:否 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:16 采樣率(每秒):45k 數據接口:串行 轉換器數目:2 功率耗散(最大):315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC(0.295",7.50mm 寬) 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端,單極
LTC2439-1CGN#TRPBF 功能描述:IC ADC 16BIT 16CH MCRPWR 28SSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:16 采樣率(每秒):45k 數據接口:串行 轉換器數目:2 功率耗散(最大):315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC(0.295",7.50mm 寬) 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端,單極
LTC24391IGN 制造商:Linear Technology 功能描述:
LTC2439-1IGN 功能描述:IC ADC 16BIT 16CH MCRPWR 28SSOP RoHS:否 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:16 采樣率(每秒):45k 數據接口:串行 轉換器數目:2 功率耗散(最大):315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC(0.295",7.50mm 寬) 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端,單極