- 您現在的位置：買賣IC網 > PDF目錄377769 > LTC2401 (Linear Technology Corporation) 1-/2-Channel 24-Bit uPower No Latency ADC in MSOP-10 PDF資料下載
參數資料
| 型號： | LTC2401 |
| 廠商： | Linear Technology Corporation |
| 英文描述： | 1-/2-Channel 24-Bit uPower No Latency ADC in MSOP-10 |
| 中文描述： | 1-/2-Channel 24位ADC的無延遲uPower采用MSOP - 10 |
| 文件頁數： | 9/12頁 |
| 文件大小： | 171K |
| 代理商： | LTC2401 |
9
LTC2401/LTC2402
APPLICATIOU
is alternated. Embedded within the serial data output is a
status bit indicating which channel corresponds to the
conversion result. If the conversion was performed on
CH0, this bit (Bit 30) is LOW and is HIGH if the conversion
was performed on CH1 (see Figure 6).
There are no extra control or status pins required to
perform the alternating 2-channel measurements. The
LTC2402 only requires two digital signals (SCK and SDO).
This simplification is ideal for isolated temperature mea-
surements or systems where minimal control signals are
available.
Pseudo Differential Applications
Generally, designers choose fully differential topologies
for several reasons. First, the interface to a 4- or 6-wire
bridge is simple (it is a differential output). Second, they
require good rejection of line frequency noise. Third, they
W
U
U
Figure 6. Embedded Selected Channel Indicator
24012 F06
SCK
SDO
CH1
CH1 DATA OUT
CH0 DATA OUT
EOC
CH0
EOC
typically look at a small differential signal sitting on a
large common mode voltage; they need accurate
measurements of the differential signal independent of
the common mode input voltage. Many applications
currently using fully differential analog-to-digital con-
verters for any of the above reasons may migrate to a
pseudo differential conversion using the LTC2402.
Direct Connection to a Full Bridge
The LTC2402 interfaces directly to a 4- or 6-wire bridge, as
shown in Figure 7. Like the LTC2401, the LTC2402 in-
cludes a FS
SET
and a ZS
SET
for sensing the excitation
voltage directly across the bridge. This eliminates errors
due to excitation currents flowing through parasitic resis-
tors. The LTC2402 also includes two single ended input
channels which can tie directly to the differential output of
the bridge. The two conversion results may be digitally
subtracted yielding the differential result.
V
CC
LTC2402
FS
SET
ZS
SET
SCK
CH1
SDO
F
O
CS
CH0
GND
3-WIRE
SPI INTERFACE
1
5V
9
8
7
10
24012 F07
2
350
350
350
350
I
DC
= 0
3
4
5
I
DC
= 0
I
EXCITATION
Figure 7. Pseudo Differential Strain Guage Application
相關PDF資料 |
PDF描述 |
|---|---|
| LTC2401CMS | 1-/2-Channel 24-Bit uPower No Latency ADC in MSOP-10 |
| LTC2401IMS | 18-Bit Universal Bus Driver With 3-State Outputs 56-SSOP -40 to 85 |
| LTC2402 | 1-/2-Channel 24-Bit uPower No Latency ADC in MSOP-10 |
| LTC2402C | 18-Bit Universal Bus Driver With 3-State Outputs 56-TSSOP -40 to 85 |
| LTC2402I | 1-/2-Channel 24-Bit uPower No Latency ADC in MSOP-10 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC2401CMS | 功能描述:IC ADC 24BIT 1CH MICROPWR 10MSOP RoHS:否 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:16 采樣率（每秒）:45k 數據接口:串行 轉換器數目:2 功率耗散（最大）:315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端，單極 |
| LTC2401CMS#PBF | 功能描述:IC ADC 24BIT 1CH MICROPWR 10MSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:16 采樣率（每秒）:45k 數據接口:串行 轉換器數目:2 功率耗散（最大）:315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端，單極 |
| LTC2401CMS#TR | 功能描述:IC ADC 24BIT 1CH MICROPWR 10MSOP RoHS:否 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:16 采樣率（每秒）:45k 數據接口:串行 轉換器數目:2 功率耗散（最大）:315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端，單極 |
| LTC2401CMS#TRPBF | 功能描述:IC ADC 24BIT 1CH MICROPWR 10MSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:16 采樣率（每秒）:45k 數據接口:串行 轉換器數目:2 功率耗散（最大）:315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端，單極 |
| LTC2401IMS | 功能描述:IC ADC 24BIT 1CH MICROPWR 10MSOP RoHS:否 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:16 采樣率（每秒）:45k 數據接口:串行 轉換器數目:2 功率耗散（最大）:315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端，單極 |
發(fā)布緊急采購，3分鐘左右您將得到回復。