- 您現在的位置：買賣IC網 > PDF目錄2006 > LTC2383HMS-16#PBF (Linear Technology)IC ADC 16BIT 1CH 1MSPS 16-MSOP PDF資料下載
參數資料
| 型號： | LTC2383HMS-16#PBF |
| 廠商： | Linear Technology |
| 文件頁數： | 3/24頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC ADC 16BIT 1CH 1MSPS 16-MSOP |
| 標準包裝： | 37 |
| 位數： | 16 |
| 采樣率（每秒）： | 1M |
| 數據接口： | 串行，SPI? |
| 轉換器數目： | 1 |
| 功率耗散（最大）： | 16.25mW |
| 電壓電源： | 模擬和數字 |
| 工作溫度： | -40°C ~ 125°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 16-TFSOP（0.118"，3.00mm 寬） |
| 供應商設備封裝： | 16-MSOP |
| 包裝： | 管件 |
| 輸入數目和類型： | 1 個差分，雙極 |
| 配用： | DC1571A-A-ND - BOARD SAR ADC LTC2383-16 |
LTC2383-16
11
238316f
APPLICATIONS INFORMATION
time is important even for DC inputs, because the ADC
inputs draw a current spike when entering acquisition.
For best performance, a buffer amplifier should be used to
drive the analog inputs of the LTC2383-16. The amplifier
provides low output impedance, which produces fast
settling of the analog signal during the acquisition phase.
It also provides isolation between the signal source and
the current spike the ADC inputs draw.
Input Filtering
The noise and distortion of the buffer amplifier and signal
source must be considered since they add to the ADC noise
and distortion. Noisy input signals should be filtered prior
to the buffer amplifier input with an appropriate filter to
minimize noise. The simple 1-pole RC lowpass filter (LPF1)
shown in Figure 4 is sufficient for many applications.
AnotherfilternetworkconsistingofLPF2andthe100Ωseries
input resistors should be used between the buffer and ADC
inputs to both minimize the noise contribution of the buffer
and to help minimize disturbances reflected into the buffer
from sampling transients. Long RC time constants at the
analoginputswillslowdownthesettlingoftheanaloginputs.
Therefore, LPF2 requires a wider bandwidth than LPF1. A
buffer amplifier with a low noise density must be selected to
minimize degradation of the SNR. With the 482kHz lowpass
filter shown in Figure 4, the LT6350 provides the full data
sheet performance of the LTC2383-16.
High quality capacitors and resistors should be used in the
RC filters since these components can add distortion. NPO
and silver mica type dielectric capacitors have excellent
linearity. Carbon surface mount resistors can generate
distortion from self heating and from damage that may
occur during soldering. Metal film surface mount resistors
are much less susceptible to both problems.
50Ω
3300pF
6600pF
50Ω
500Ω
100Ω
LPF2
LPF1
BW = 482kHz
BW = 48kHz
SINGLE-ENDED-
TO-DIFFERENTIAL
DRIVER
SINGLE-ENDED-
INPUT SIGNAL
LTC2383-16
IN+
IN–
238316 F04
LT6350
Single-Ended-to-Differential Conversion
For single-ended input signals, a single-ended to differential
conversion circuit must be used to produce a differential
signal at the inputs of the LTC2383-16. The LT6350 ADC
driver is recommended for performing single-ended-to-
differential conversions.The LT6350 is flexible and may
be configured to convert single-ended signals of various
amplitudes to the ±2.5V differential input range of the
LTC2383-16. The LT6350 is also available in H-grade to
complement the extended temperature operation of the
LTC2383-16 up to 125°C.
Figure 5 shows the LT6350 being used to convert a 0V
to 2.5V single-ended input signal. In this case, the first
amplifier is configured as a unity gain buffer and the single-
ended input signal directly drives the high-impedance
input of the amplifier. As shown in the FFT of Figure 5a,
the LT6350 drives the LTC2383-16 to full datasheet
performance without degrading the SNR or THD .
Figure 4. Input Signal Chain
LT6350
VCM = VREF/2
2.5V to
0V
0V to
2.5V
0V to 2.5V
238316 F05
OUT1
RINT
OUT2
8
4
5
2
1
+
–
+
–
+
FREQUENCY (kHz)
0
100
200
300
400
500
–180
AMPLITUDE
(dBFS)
–60
–40
–20
–80
–100
–120
–140
–160
0
238316 F05a
SNR = 92.2dB
THD = –106.2dB
SINAD = 92dB
SFDR = 110.4dB
Figure 5. LT6350 Converting a 0V-2.5V Single-Ended Signal
to a ±2.5V Differential Input Signal
Figure 5a. 32k Point FFT Plot for Circuit Shown in Figure 5
相關PDF資料 |
PDF描述 |
|---|---|
| LTC2393IUK-16#TRPBF | IC ADC 16BIT SER/PAR 1M 48-QFN |
| LTC2410IGN#TRPBF | IC ADC 24BIT DIFF INP/REF 16SSOP |
| LTC2411-1IMS#TRPBF | IC A/DCONV DIFF INPUT&REF 10MSOP |
| LTC2418IGN#TRPBF | IC ADC 24BIT DIFF INPUT 28SSOP |
| LTC2431IMS#TRPBF | IC ADC 20BIT DIFFINPUT/REF10MSOP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC2383IDE-16#PBF | 功能描述:IC ADC 16BIT 1CH 1MSPS 16-DFN RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:12 采樣率（每秒）:300k 數據接口:并聯 轉換器數目:1 功率耗散（最大）:75mW 電壓電源:單電源 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:24-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:24-SOIC 包裝:帶卷 (TR) 輸入數目和類型:1 個單端，單極；1 個單端，雙極 |
| LTC2383IDE-16#TRPBF | 功能描述:IC ADC 16BIT 1CH 1MSPS 16-DFN RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:12 采樣率（每秒）:300k 數據接口:并聯 轉換器數目:1 功率耗散（最大）:75mW 電壓電源:單電源 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:24-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:24-SOIC 包裝:帶卷 (TR) 輸入數目和類型:1 個單端，單極；1 個單端，雙極 |
| LTC2383IMS-16#PBF | 功能描述:IC ADC 16BIT 1CH 1MSPS 16-MSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:12 采樣率（每秒）:300k 數據接口:并聯 轉換器數目:1 功率耗散（最大）:75mW 電壓電源:單電源 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:24-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:24-SOIC 包裝:帶卷 (TR) 輸入數目和類型:1 個單端，單極；1 個單端，雙極 |
| LTC2383IMS-16#TRPBF | 功能描述:IC ADC 16BIT 1CH 1MSPS 16-MSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:12 采樣率（每秒）:300k 數據接口:并聯 轉換器數目:1 功率耗散（最大）:75mW 電壓電源:單電源 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:24-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:24-SOIC 包裝:帶卷 (TR) 輸入數目和類型:1 個單端，單極；1 個單端，雙極 |
| LTC2389CLX-16#PBF | 功能描述:IC ADC 16BIT PAR/SRL 2.5M 48LQFP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 其它有關文件:TSA1204 View All Specifications 標準包裝:1 系列:- 位數:12 采樣率（每秒）:20M 數據接口:并聯 轉換器數目:2 功率耗散（最大）:155mW 電壓電源:模擬和數字 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:48-TQFP 供應商設備封裝:48-TQFP（7x7） 包裝:Digi-Reel® 輸入數目和類型:4 個單端，單極；2 個差分，單極 產品目錄頁面:1156 (CN2011-ZH PDF) 其它名稱:497-5435-6 |
發布緊急采購，3分鐘左右您將得到回復。