Figure 11. 32k Point FFT with fIN = 2kHz of the LTC2377-18" />
參數資料
型號： LTC2377IMS-18#TRPBF
廠商： Linear Technology
文件頁數： 6/24頁
文件大小： 0K
描述： IC ADC 18BIT 500KSPS 16-MSOP
產品培訓模塊： LTC2379- 18-/16-bit Fully-Differential SAR ADC Family Overview
標準包裝： 2,500
位數： 18
采樣率（每秒）： 500k
數據接口： 串行，SPI?
轉換器數目： 1
功率耗散（最大）： 8mW
電壓電源： 模擬和數字
工作溫度： -40°C ~ 85°C
安裝類型： 表面貼裝
封裝/外殼： 16-TFSOP（0.118"，3.00mm 寬）
供應商設備封裝： 16-MSOP
包裝： 帶卷 (TR)
輸入數目和類型： 1 個差分，雙極
配用： DC1783A-G-ND - BOARD SAR ADC LTC2377-18
DC1783A-C-ND - BOARD SAR ADC LTC2377-16
LTC2377-18
14
237718f
Figure 11. 32k Point FFT with fIN = 2kHz of the LTC2377-18
FREQUENCY (kHz)
0
50
100
150
250
200
–180
AMPLITUDE
(dBFS)
–60
–40
–20
–80
–100
–120
–140
–160
0
237718 F11
SNR = 102.3dB
THD = –124dB
SINAD = 102.2dB
SFDR = 125dB
SNR = 102.3dB
THD = –124dB
SINAD = 102.2dB
SFDR = 125dB
APPLICATIONS INFORMATION
0μA to a maximum of 0.4mA at 500ksps. This step in DC
current draw triggers a transient response in the reference
that must be considered since any deviation in the refer-
ence output voltage will affect the accuracy of the output
code. In applications where the transient response of the
reference is important, the fast settling LTC6655-5 refer-
ence is also recommended.
DYNAMIC PERFORMANCE
Fast Fourier Transform (FFT) techniques are used to test
the ADC’s frequency response, distortion and noise at the
rated throughput. By applying a low distortion sine wave
and analyzing the digital output using an FFT algorithm,
the ADC’s spectral content can be examined for frequen-
cies outside the fundamental. The LTC2377-18 provides
guaranteed tested limits for both AC distortion and noise
measurements.
Signal-to-Noise and Distortion Ratio (SINAD)
The signal-to-noise and distortion ratio (SINAD) is the
ratio between the RMS amplitude of the fundamental input
frequency and the RMS amplitude of all other frequency
components at the A/D output. The output is band-limited
to frequencies from above DC and below half the sampling
frequency. Figure 11 shows that the LTC2377-18 achieves
a typical SINAD of 102dB at a 500kHz sampling rate with
a 2kHz input.
Signal-to-Noise Ratio (SNR)
The signal-to-noise ratio (SNR) is the ratio between the
RMS amplitude of the fundamental input frequency and
the RMS amplitude of all other frequency components
except the first five harmonics and DC. Figure 11 shows
that the LTC2377-18 achieves a typical SNR of 102dB at
a 500kHz sampling rate with a 2kHz input.
Total Harmonic Distortion (THD)
Total Harmonic Distortion (THD) is the ratio of the RMS sum
of all harmonics of the input signal to the fundamental itself.
The out-of-band harmonics alias into the frequency band
between DC and half the sampling frequency (fSMPL/2).
THD is expressed as:
THD
=20log
V2
2 + V32 + V42 +…+ V
N
2
V1
where V1 is the RMS amplitude of the fundamental fre-
quency and V2 through VN aretheamplitudesofthesecond
through Nth harmonics.
POWER CONSIDERATIONS
The LTC2377-18 provides two power supply pins: the
2.5V power supply (VDD), and the digital input/output
interface power supply (OVDD). The flexible OVDD supply
allows the LTC2377-18 to communicate with any digital
logic operating between 1.8V and 5V, including 2.5V and
3.3V systems.
Power Supply Sequencing
The LTC2377-18 does not have any specific power supply
sequencing requirements. Care should be taken to adhere
to the maximum voltage relationships described in the
Absolute Maximum Ratings section. The LTC2377-18
has a power-on-reset (POR) circuit that will reset the
LTC2377-18 at initial power-up or whenever the power
supply voltage drops below 1V. Once the supply voltage
re-enters the nominal supply voltage range, the POR will
reinitialize the ADC. No conversions should be initiated
until 20μs after a POR event to ensure the reinitialization
period has ended. Any conversions initiated before this
time will produce invalid results.
相關PDF資料
PDF描述
LT1328CMS8 IC RECEIVER 4MBPS IRDA IR 8-MSOP
IDT72413L25SOG IC FIFO PAR W/FLAGS 32KB 20SOIC
MS3102R28-10P CONN RCPT 7POS BOX MNT W/PINS
ADM242AN IC TX/RX RS-232 W/EN/SD 18DIP
IDT7204L35TP IC FIFO ASYNCH 4KX9 35NS 28DIP
相關代理商/技術參數
參數描述
LTC2377IMS-20#PBF 制造商:Linear Technology 功能描述:IC ADC 20BIT 500KSPS 16MSOP
LTC2377IMS-20#PBF 制造商:Linear Technology 功能描述:ADC 20BIT 500KSPS SPI MSOP 制造商:Linear Technology 功能描述:ADC 20BIT 500KSPS SPI MSOP-16 制造商:Linear Technology 功能描述:ADC, 20BIT, 500KSPS, SPI, MSOP-16
LTC2377IMS-20#TRPBF 制造商:Linear Technology 功能描述:IC ADC 20BIT 500KSPS 16MSOP
LTC2378CDE-16#PBF 功能描述:IC ADC 16BIT LP SAR 1MSPS 16-DFN RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1 系列:- 位數:14 采樣率（每秒）:83k 數據接口:串行，并聯 轉換器數目:1 功率耗散（最大）:95mW 電壓電源:雙 ± 工作溫度:0°C ~ 70°C 安裝類型:通孔 封裝/外殼:28-DIP（0.600"，15.24mm） 供應商設備封裝:28-PDIP 包裝:管件 輸入數目和類型:1 個單端，雙極
LTC2378CDE-16#TRPBF 功能描述:IC ADC 16BIT LP SAR 1MSPS 16-DFN RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1 系列:- 位數:14 采樣率（每秒）:83k 數據接口:串行，并聯 轉換器數目:1 功率耗散（最大）:95mW 電壓電源:雙 ± 工作溫度:0°C ~ 70°C 安裝類型:通孔 封裝/外殼:28-DIP（0.600"，15.24mm） 供應商設備封裝:28-PDIP 包裝:管件 輸入數目和類型:1 個單端，雙極
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*