- 您現在的位置：買賣IC網 > PDF目錄377768 > LTC2298UP (Linear Technology Corporation) Dual 14-Bit, 65/40/25Msps Low Power 3V ADCs PDF資料下載
參數資料
| 型號： | LTC2298UP |
| 廠商： | Linear Technology Corporation |
| 英文描述： | Dual 14-Bit, 65/40/25Msps Low Power 3V ADCs |
| 中文描述： | 雙14位，65/40/25Msps低功耗3V的模數轉換器 |
| 文件頁數： | 15/28頁 |
| 文件大?。?/td> | 706K |
| 代理商： | LTC2298UP |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁當前第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁
LTC2298/LTC2297/LTC2296
15
229876f
DYNAMIC PERFORMANCE
Signal-to-Noise Plus Distortion Ratio
The signal-to-noise plus distortion ratio [S/(N + D)] is the
ratio between the RMS amplitude of the fundamental input
frequency and the RMS amplitude of all other frequency
components at the ADC output. The output is band limited
to frequencies above DC to below half the sampling
frequency.
Signal-to-Noise Ratio
The signal-to-noise ratio (SNR) is the ratio between the
RMS amplitude of the fundamental input frequency and
the RMS amplitude of all other frequency components
except the first five harmonics and DC.
Total Harmonic Distortion
Total harmonic distortion is the ratio of the RMS sum of all
harmonics of the input signal to the fundamental itself. The
out-of-band harmonics alias into the frequency band
between DC and half the sampling frequency. THD is
expressed as:
THD = 20Log
√
(V2
2
+ V3
2
+ V4
2
+ . . . Vn
2
)/V1
where V1 is the RMS amplitude of the fundamental fre-
quency and V2 through Vn are the amplitudes of the
second through nth harmonics. The THD calculated in this
data sheet uses all the harmonics up to the fifth.
Intermodulation Distortion
If the ADC input signal consists of more than one spectral
component, the ADC transfer function nonlinearity can
produce intermodulation distortion (IMD) in addition to
THD. IMD is the change in one sinusoidal input caused by
the presence of another sinusoidal input at a different
frequency.
If two pure sine waves of frequencies fa and fb are applied
to the ADC input, nonlinearities in the ADC transfer func-
tion can create distortion products at the sum and differ-
ence frequencies of mfa
±
nfb, where m and n = 0, 1, 2, 3,
etc. The 3rd order intermodulation products are 2fa + fb,
APPLICATIOU
W
U
U
2fb + fa, 2fa – fb and 2fb – fa. The intermodulation
distortion is defined as the ratio of the RMS value of either
input tone to the RMS value of the largest 3rd order
intermodulation product.
Spurious Free Dynamic Range (SFDR)
Spurious free dynamic range is the peak harmonic or
spurious noise that is the largest spectral component
excluding the input signal and DC. This value is expressed
in decibels relative to the RMS value of a full scale input
signal.
Input Bandwidth
The input bandwidth is that input frequency at which the
amplitude of the reconstructed fundamental is reduced by
3dB for a full scale input signal.
Aperture Delay Time
The time from when CLK reaches midsupply to the instant
that the input signal is held by the sample and hold circuit.
Aperture Delay Jitter
The variation in the aperture delay time from conversion to
conversion. This random variation will result in noise
when sampling an AC input. The signal to noise ratio due
to the jitter alone will be:
SNR
JITTER
= –20log (2
π
) f
IN
t
JITTER
Crosstalk
Crosstalk is the coupling from one channel (being driven
by a full-scale signal) onto the other channel (being driven
by a –1dBFS signal).
CONVERTER OPERATION
As shown in Figure 1, the LTC2298/LTC2297/LTC2296 are
dual CMOS pipelined multistep converters. The convert-
ers have six pipelined ADC stages; a sampled analog input
will result in a digitized value six cycles later (see the
Timing Diagram section). For optimal AC performance the
analog inputs should be driven differentially. For cost
相關PDF資料 |
PDF描述 |
|---|---|
| LTC2355CMSE-12 | Serial 12-Bit/14-Bit, 3.5Msps Sampling ADCs with Shutdown |
| LTC2355-12 | Serial 12-Bit/14-Bit, 3.5Msps Sampling ADCs with Shutdown |
| LTC2355CMSE-14 | Serial 12-Bit/14-Bit, 3.5Msps Sampling ADCs with Shutdown |
| LTC2355IMSE-12 | Serial 12-Bit/14-Bit, 3.5Msps Sampling ADCs with Shutdown |
| LTC2355IMSE-14 | Serial 12-Bit/14-Bit, 3.5Msps Sampling ADCs with Shutdown |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC2299 | 制造商:LINER 制造商全稱:Linear Technology 功能描述:14-Bit, 125/105Msps Low Power 3V ADCs |
| LTC2299CUP | 制造商:LINER 制造商全稱:Linear Technology 功能描述:Dual 14-Bit, 80Msps Low Power 3V ADC |
| LTC2299CUP#PBF | 功能描述:IC ADC DUAL 14BIT 80MSPS 64QFN RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1 系列:microPOWER™ 位數:8 采樣率（每秒）:1M 數據接口:串行，SPI? 轉換器數目:1 功率耗散（最大）:- 電壓電源:模擬和數字 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:24-VFQFN 裸露焊盤 供應商設備封裝:24-VQFN 裸露焊盤（4x4） 包裝:Digi-Reel® 輸入數目和類型:8 個單端，單極 產品目錄頁面:892 (CN2011-ZH PDF) 其它名稱:296-25851-6 |
| LTC2299CUP#TRPBF | 功能描述:IC ADC DUAL 14BIT 80MSPS 64QFN RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1 系列:- 位數:14 采樣率（每秒）:83k 數據接口:串行，并聯 轉換器數目:1 功率耗散（最大）:95mW 電壓電源:雙 ± 工作溫度:0°C ~ 70°C 安裝類型:通孔 封裝/外殼:28-DIP（0.600"，15.24mm） 供應商設備封裝:28-PDIP 包裝:管件 輸入數目和類型:1 個單端，雙極 |
| LTC2299IUP | 制造商:Linear Technology 功能描述:ADC Dual Pipelined 80Msps 14-bit Parallel 64-Pin QFN EP |
發布緊急采購，3分鐘左右您將得到回復。