- 您現在的位置：買賣IC網 > PDF目錄2005 > LTC2290IUP#TRPBF (Linear Technology)IC ADC DUAL 12BIT 10MSPS 64QFN PDF資料下載
參數資料
| 型號： | LTC2290IUP#TRPBF |
| 廠商： | Linear Technology |
| 文件頁數： | 8/24頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC ADC DUAL 12BIT 10MSPS 64QFN |
| 標準包裝： | 2,000 |
| 位數： | 12 |
| 采樣率（每秒）： | 10M |
| 數據接口： | 并聯 |
| 轉換器數目： | 2 |
| 功率耗散（最大）： | 138mW |
| 電壓電源： | 單電源 |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 64-WFQFN 裸露焊盤 |
| 供應商設備封裝： | 64-QFN（9x9） |
| 包裝： | 帶卷 (TR) |
| 輸入數目和類型： | 2 個單端，雙極; 2 個差分, 雙極 |
LTC2290
16
2290fa
APPLICATIO S I FOR ATIO
WU
UU
Maximum and Minimum Conversion Rates
The maximum conversion rate for the LTC2290 is 10Msps.
For the ADC to operate properly, the CLK signal should
have a 50% (
±10%) duty cycle. Each half cycle must have
at least 40ns for the ADC internal circuitry to have enough
settling time for proper operation.
An optional clock duty cycle stabilizer circuit can be used
if the input clock has a non 50% duty cycle. This circuit
uses the rising edge of the CLK pin to sample the analog
input. The falling edge of CLK is ignored and the internal
falling edge is generated by a phase-locked loop. The
input clock duty cycle can vary and the clock duty cycle
stabilizer will maintain a constant 50% internal duty cycle.
If the clock is turned off for a long period of time, the duty
cycle stabilizer circuit will require a hundred clock cycles
for the PLL to lock onto the input clock. To use the clock
duty cycle stabilizer, the MODE pin should be connected
to 1/3VDD or 2/3VDD using external resistors. The MODE
pin controls both Channel A and Channel B—the duty
cycle stabilizer is either on or off for both channels.
The lower limit of the LTC2290 sample rate is determined
by droop of the sample-and-hold circuits. The pipelined
architecture of this ADC relies on storing analog signals on
small valued capacitors. Junction leakage will discharge
the capacitors. The specified minimum operating fre-
quency for the LTC2290 is 1Msps.
DIGITAL OUTPUTS
Figure 9. Digital Output Buffer
2290 F09
OVDD
VDD
0.1
F
43
TYPICAL
DATA
OUTPUT
OGND
OVDD
0.5V
TO 3.6V
PREDRIVER
LOGIC
DATA
FROM
LATCH
OE
LTC2290
Digital Output Buffers
Figure 9 shows an equivalent circuit for a single output
buffer. Each buffer is powered by OVDD and OGND, iso-
lated from the ADC power and ground. The additional
N-channel transistor in the output driver allows operation
down to low voltages. The internal resistor in series with
the output makes the output appear as 50
to external
circuitry and may eliminate the need for external damping
resistors.
Table 1. Output Codes vs Input Voltage
AIN+ – AIN–
D11 – D0
(2V Range)
OF
(Offset Binary)
(2’s Complement)
>+1.000000V
1
1111 1111 1111
0111 1111 1111
+0.999512V
0
1111 1111 1111
0111 1111 1111
+0.999024V
0
1111 1111 1110
0111 1111 1110
+0.000488V
0
1000 0000 0001
0000 0000 0001
0.000000V
0
1000 0000 0000
0000 0000 0000
–0.000488V
0
0111 1111 1111
1111 1111 1111
–0.000976V
0
0111 1111 1110
1111 1111 1110
–0.999512V
0
0000 0000 0001
1000 0000 0001
–1.000000V
0
0000 0000 0000
1000 0000 0000
<–1.000000V
1
0000 0000 0000
1000 0000 0000
As with all high speed/high resolution converters, the digi-
tal output loading can affect the performance. The digital
outputs of the LTC2290 should drive a minimal capacitive
load to avoid possible interaction between the digital out-
puts and sensitive input circuitry. The output should be
buffered with a device such as an ALVCH16373 CMOS
latch. For full speed operation the capacitive load should
be kept under 10pF.
Lower OVDD voltages will also help reduce interference
from the digital outputs.
相關PDF資料 |
PDF描述 |
|---|---|
| LTC2298IUP#PBF | IC ADC DUAL 14BIT 65MSPS 64QFN |
| LTC2305CDE#TRPBF | IC ADC 12-BIT 2CHN 12-DFN |
| LTC2306CDD#PBF | IC ADC 12BIT 2CH 500KSPS 10-DFN |
| LTC2351HUH-12#TRPBF | IC ADC 12BIT 1.5MSPS 32-QFN |
| LTC2351HUH-14#TRPBF | IC ADC 14BIT 1.5MSPS 32-QFN |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC2290UP | 制造商:LINER 制造商全稱:Linear Technology 功能描述:Dual 12-Bit, 10Msps Low Power 3V ADC |
| LTC2291 | 制造商:LINER 制造商全稱:Linear Technology 功能描述:Dual 12-Bit, 65/40/25Msps Low Power 3V ADCs |
| LTC2291CUP | 制造商:Linear Technology 功能描述:ADC Dual Pipelined 25Msps 12-bit Parallel 64-Pin QFN EP |
| LTC2291CUP#PBF | 功能描述:IC ADC DUAL 12BIT 25MSPS 64QFN RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 其它有關文件:TSA1204 View All Specifications 標準包裝:1 系列:- 位數:12 采樣率（每秒）:20M 數據接口:并聯 轉換器數目:2 功率耗散（最大）:155mW 電壓電源:模擬和數字 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:48-TQFP 供應商設備封裝:48-TQFP（7x7） 包裝:Digi-Reel® 輸入數目和類型:4 個單端，單極；2 個差分，單極 產品目錄頁面:1156 (CN2011-ZH PDF) 其它名稱:497-5435-6 |
| LTC2291CUP#TRPBF | 功能描述:IC ADC DUAL 12BIT 25MSPS 64QFN RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:12 采樣率（每秒）:300k 數據接口:并聯 轉換器數目:1 功率耗散（最大）:75mW 電壓電源:單電源 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:24-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:24-SOIC 包裝:帶卷 (TR) 輸入數目和類型:1 個單端，單極；1 個單端，雙極 |
發布緊急采購，3分鐘左右您將得到回復。