VCM FERRITE BEAD DIFFERENTIAL CLOCK INPUT 2280 F13 LTC2280" />
參數資料
型號: LTC2280IUP#TRPBF
廠商: Linear Technology
文件頁數: 8/24頁
文件大?。?/td> 0K
描述: IC ADC DUAL 10BIT 105MSPS 64-QFN
標準包裝: 2,000
位數: 10
采樣率(每秒): 105M
數據接口: 并聯
轉換器數目: 2
功率耗散(最大): 630mW
電壓電源: 單電源
工作溫度: -40°C ~ 85°C
安裝類型: 表面貼裝
封裝/外殼: 64-WFQFN 裸露焊盤
供應商設備封裝: 64-QFN(9x9)
包裝: 帶卷 (TR)
輸入數目和類型: 2 個單端,雙極; 2 個差分, 雙極
LTC2280
16
2280fa
CLK
5pF-30pF
ETC1-1T
0.1
F
VCM
FERRITE
BEAD
DIFFERENTIAL
CLOCK
INPUT
2280 F13
LTC2280
CLK
100
0.1
F
4.7
F
FERRITE
BEAD
CLEAN
SUPPLY
IF LVDS USE FIN1002 OR FIN1018.
FOR PECL, USE AZ1000ELT21 OR SIMILAR
2280 F12
LTC2280
CLK
50
0.1
F
0.1
F
4.7
F
1k
FERRITE
BEAD
CLEAN
SUPPLY
SINUSOIDAL
CLOCK
INPUT
2280 F11
NC7SVU04
LTC2280
APPLICATIO S I FOR ATIO
WU
UU
The noise performance of the LTC2280 can depend on the
clock signal quality as much as on the analog input. Any
noise present on the clock signal will result in additional
aperture jitter that will be RMS summed with the inherent
ADC aperture jitter.
In applications where jitter is critical, such as when digitiz-
ing high input frequencies, use as large an amplitude as
possible. Also, if the ADC is clocked with a sinusoidal
signal, filter the CLK signal to reduce wideband noise and
distortion products generated by the source.
It is recommended that CLKA and CLKB are shorted
together and driven by the same clock source. If a small
time delay is desired between when the two channels
sample the analog inputs, CLKA and CLKB can be driven
by two different signals. If this delay exceeds 1ns, the
performance of the part may degrade. CLKA and CLKB
should not be driven by asynchronous signals.
Figures 12 and 13 show alternatives for converting a
differential clock to the single-ended CLK input. The use of
a transformer provides no incremental contribution to
phase noise. The LVDS or PECL to CMOS translators
provide little degradation below 70MHz, but at 140MHz
will degrade the SNR compared to the transformer solu-
tion. The nature of the received signals also has a large
bearing on how much SNR degradation will be experi-
enced. For high crest factor signals such as WCDMA or
OFDM, where the nominal power level must be at least 6dB
to 8dB below full scale, the use of these translators will
have a lesser impact.
The transformer shown in the example may be terminated
with the appropriate termination for the signaling in use.
The use of a transformer with a 1:4 impedance ratio may
be desirable in cases where lower voltage differential
signals are considered. The center tap may be bypassed to
ground through a capacitor close to the ADC if the differ-
ential signals originate on a different plane. The use of a
capacitor at the input may result in peaking, and depend-
ing on transmission line length may require a 10
to 20
ohm series resistor to act as both a low pass filter for high
frequency noise that may be induced into the clock line by
neighboring digital signals, as well as a damping mecha-
nism for reflections.
Maximum and Minimum Conversion Rates
The maximum conversion rate for the LTC2280 is 105Msps.
The lower limit of the LTC2280 sample rate is determined
by droop of the sample-and-hold circuits. The pipelined
Figure 11. Sinusoidal Single-Ended CLK Drive
Figure 12. CLK Drive Using an LVDS or PECL to CMOS Converter
Figure 13. LVDS or PECL CLK Drive Using a Transformer
相關PDF資料
PDF描述
VE-BND-IV-S CONVERTER MOD DC/DC 85V 150W
SA572D IC COMPANDOR 2CHAN GAIN 16-SOIC
LTC1609CSW#TRPBF IC ADC SRL 16BIT 200KSPS 20-SOIC
VE-BNB-IV-S CONVERTER MOD DC/DC 95V 150W
LTC1609CG#TRPBF IC CONV A/D 16BIT 200KSPS 28SSOP
相關代理商/技術參數
參數描述
LTC2280UP 制造商:LINER 制造商全稱:Linear Technology 功能描述:Dual 10-Bit, 105Msps Low Noise 3V ADC
LTC2281 制造商:LINER 制造商全稱:Linear Technology 功能描述:Dual 10-Bit, 125Msps Low Power 3V ADC
LTC2281CUP 制造商:LINER 制造商全稱:Linear Technology 功能描述:Dual 10-Bit, 125Msps Low Power 3V ADC
LTC2281CUP#PBF 功能描述:IC ADC DUAL 10BIT 125MSPS 64QFN RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1 系列:- 位數:14 采樣率(每秒):83k 數據接口:串行,并聯 轉換器數目:1 功率耗散(最大):95mW 電壓電源:雙 ± 工作溫度:0°C ~ 70°C 安裝類型:通孔 封裝/外殼:28-DIP(0.600",15.24mm) 供應商設備封裝:28-PDIP 包裝:管件 輸入數目和類型:1 個單端,雙極
LTC2281CUP#TRPBF 功能描述:IC ADC DUAL 10BIT 125MSPS 64QFN RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1 系列:- 位數:14 采樣率(每秒):83k 數據接口:串行,并聯 轉換器數目:1 功率耗散(最大):95mW 電壓電源:雙 ± 工作溫度:0°C ~ 70°C 安裝類型:通孔 封裝/外殼:28-DIP(0.600",15.24mm) 供應商設備封裝:28-PDIP 包裝:管件 輸入數目和類型:1 個單端,雙極