參數資料
型號： LTC2257CUJ-12#PBF
廠商： LINEAR TECHNOLOGY CORP
元件分類： ADC
英文描述： 1-CH 12-BIT PROPRIETARY METHOD ADC, PARALLEL ACCESS, PQCC40
封裝： 6 X 6 MM, LEAD FREE, PLASTIC, QFN-40
文件頁數： 17/32頁
文件大?。?/td> 1156K
代理商： LTC2257CUJ-12#PBF
LTC2258-12
LTC2257-12/LTC2256-12
24
225812fa
izer—either, both or neither function can be on at the same
time. When alternate bit polarity mode is on, the data
format is offset binary and the 2’s complement control bit
has no effect. The alternate bit polarity mode is enabled
by serially programming mode control register A4.
Digital Output Test Patterns
To allow in-circuit testing of the digital interface to the
A/D, there are several test modes that force the A/D data
outputs (OF, D11-D0) to known values:
All 1s: All outputs are 1
All 0s: All outputs are 0
Alternating: Outputs change from all 1s to all 0s on
alternating samples
Checkerboard: Outputs change from 1010101010101
to 0101010101010 on alternating samples
The digital output test patterns are enabled by serially
programming mode control register A4. When enabled,
the test patterns override all other formatting modes: 2’s
complement, randomizer, alternate-bit-polarity.
Output Disable
The digital outputs may be disabled by serially program-
ming mode control register A3. All digital outputs including
OF and CLKOUT are disabled. The high impedance disabled
state is intended for long periods of inactivity—it is too
slow to multiplex a data bus between multiple converters
at full speed.
Sleep and Nap Modes
The A/D may be placed in sleep or nap modes to conserve
power. In sleep mode the entire A/D converter is powered
down, resulting in 0.5mW power consumption. Sleep mode
is enabled by mode control register A1 (serial program-
ming mode), or by SDI (parallel programming mode).
The amount of time required to recover from sleep mode
depends on the size of the bypass capacitors on VREF,
REFH, and REFL. For the suggested values in Figure 8,
the A/D will stabilize after 2ms.
In nap mode the A/D core is powered down while the
internal reference circuits stay active, allowing faster
wake-up than from sleep mode. Recovering from nap
mode requires at least 100 clock cycles. If the application
demands very accurate DC settling then an additional
50μs should be allowed so the on-chip references can
settle from the slight temperature shift caused by the
change in supply current as the A/D leaves nap mode.
Nap mode is enabled by mode control register A1 in the
serial programming mode.
DEVICE PROGRAMMING MODES
The operating modes of the LTC2258-12/LTC2257-12/
LTC2256-12 can be programmed by either a parallel
interface or a simple serial interface. The serial interface
has more exibility and can program all available modes.
The parallel interface is more limited and can only program
some of the more commonly used modes.
Parallel Programming Mode
To use the parallel programming mode, PAR/SER should
be tied to VDD. The CS, SCK and SDI pins are binary logic
inputs that set certain operating modes. These pins can
be tied to VDD or ground, or driven by 1.8V, 2.5V or 3.3V
CMOS logic. Table 2 shows the modes set by CS, SCK
and SDI.
Table 2. Parallel Programming Mode Control Bits (PAR/SER = VDD)
PIN
DESCRIPTION
CS
Clock Duty Cycle Stabilizer Control Bit
0 = Clock Duty Cycle Stabilizer Off
1 = Clock Duty Cycle Stabilizer On
SCK
Digital Output Mode Control Bit
0 = Full-Rate CMOS Output Mode
1 = Double Data Rate LVDS Output Mode
(3.5mA LVDS Current, Internal Termination Off)
SDI
Power Down Control Bit
0 = Normal Operation
1 = Sleep Mode
APPLICATIONS INFORMATION
相關PDF資料
PDF描述
LTC2258IUJ-12#PBF 1-CH 12-BIT PROPRIETARY METHOD ADC, PARALLEL ACCESS, PQCC40
LTC2257IUJ-12#TRPBF 1-CH 12-BIT PROPRIETARY METHOD ADC, PARALLEL ACCESS, PQCC40
LTC2257CUJ-14#TRPBF 1-CH 14-BIT PROPRIETARY METHOD ADC, PARALLEL ACCESS, PQCC40
LTC2257IUJ-14#TRPBF 1-CH 14-BIT PROPRIETARY METHOD ADC, PARALLEL ACCESS, PQCC40
LTC2256CUJ-14#PBF 1-CH 14-BIT PROPRIETARY METHOD ADC, PARALLEL ACCESS, PQCC40
相關代理商/技術參數
參數描述
LTC2257CUJ-12-TRPBF 制造商:LINER 制造商全稱:Linear Technology 功能描述:12-Bit, 65/40/2 5Msps Ultralow Power 1.8V ADCs
LTC2257CUJ-14#PBF 功能描述:IC ADC 14BIT 40MSPS 1.8V 40-QFN RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1 系列:- 位數:14 采樣率（每秒）:83k 數據接口:串行，并聯 轉換器數目:1 功率耗散（最大）:95mW 電壓電源:雙 ± 工作溫度:0°C ~ 70°C 安裝類型:通孔 封裝/外殼:28-DIP（0.600"，15.24mm） 供應商設備封裝:28-PDIP 包裝:管件 輸入數目和類型:1 個單端，雙極
LTC2257CUJ-14#TRPBF 功能描述:IC ADC 14BIT 40MSPS 1.8V 40-QFN RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1 系列:- 位數:14 采樣率（每秒）:83k 數據接口:串行，并聯 轉換器數目:1 功率耗散（最大）:95mW 電壓電源:雙 ± 工作溫度:0°C ~ 70°C 安裝類型:通孔 封裝/外殼:28-DIP（0.600"，15.24mm） 供應商設備封裝:28-PDIP 包裝:管件 輸入數目和類型:1 個單端，雙極
LTC2257CUJ-14-PBF 制造商:LINER 制造商全稱:Linear Technology 功能描述:14-Bit, 65/40/25Msps Ultralow Power 1.8V ADCs
LTC2257CUJ-14-TRPBF 制造商:LINER 制造商全稱:Linear Technology 功能描述:14-Bit, 65/40/25Msps Ultralow Power 1.8V ADCs
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*