- 您現在的位置：買賣IC網 > PDF目錄39412 > LTC2164CUK#PBF (LINEAR TECHNOLOGY CORP) 1-CH 16-BIT PROPRIETARY METHOD ADC, PARALLEL ACCESS, PQCC48 PDF資料下載
參數資料
| 型號： | LTC2164CUK#PBF |
| 廠商： | LINEAR TECHNOLOGY CORP |
| 元件分類： | ADC |
| 英文描述： | 1-CH 16-BIT PROPRIETARY METHOD ADC, PARALLEL ACCESS, PQCC48 |
| 封裝： | 7 X 7 MM, LEAD FREE, PLASTIC, MO-220WKKD-2, QFN-48 |
| 文件頁數： | 20/36頁 |
| 文件大?。?/td> | 663K |
| 代理商： | LTC2164CUK#PBF |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁當前第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁
LTC2165/LTC2164/LTC2163
27
216543f
Serial Programming Mode
To use the serial programming mode, PAR/SER should be
tied to ground. The CS, SCK, SDI and SDO pins become a
serialinterfacethatprogramtheA/Dmodecontrolregisters.
Data is written to a register with a 16-bit serial word. Data
can also be read back from a register to verify its contents.
Serial data transfer starts when CS is taken low. The data
on the SDI pin is latched at the first 16 rising edges of
SCK. Any SCK rising edges after the first 16 are ignored.
The data transfer ends when CS is taken high again.
The first bit of the 16-bit input word is the R/W bit. The
next seven bits are the address of the register (A6:A0).
The final eight bits are the register data (D7:D0).
If the R/W bit is low, the serial data (D7:D0) will be writ-
ten to the register set by the address bits (A6:A0). If the
R/W bit is high, data in the register set by the address bits
(A6:A0) will be read back on the SDO pin (see the Timing
Diagrams). During a read back command the register is
not updated and data on SDI is ignored.
The SDO pin is an open drain output that pulls to ground
with a 200 impedance. If register data is read back
through SDO, an external 2k pull-up resistor is required. If
serial data is only written and read back is not needed, then
SDO can be left floating and no pull-up resistor is needed.
Table 3 shows a map of the mode control registers.
Software Reset
If serial programming is used, the mode control registers
shouldbeprogrammedassoonaspossibleafterthepower
supplies turn on and are stable. The first serial command
must be a software reset which will reset all register data
bits to logic 0. To perform a software reset, bit D7 in the
reset register is written with a logic 1. After the reset SPI
write command is complete, bit D7 is automatically set
back to zero.
applicaTions inForMaTion
Table 3. Serial Programming Mode Register Map (PAR/SER = GND)
REGISTER A0: RESET REGISTER (ADDRESS 00h)
D7
D6
D5
D4
D3
D2
D1
D0
RESET
X
Bits 7
RESET
Software Reset Bit
0 = Not Used
1 = Software Reset. All Mode Control Registers are reset to 00h. The ADC is momentarily placed in sleep mode.
This bit is automatically set back to zero at the end of the SPI write command.
The reset register is write only. Data read back from the reset register will be random.
Bits 6-0
Unused, Don’t Care Bits
REGISTER A1: POWER DOWN REGISTER (ADDRESS 01h)
D7
D6
D5
D4
D3
D2
D1
D0
X
PWROFF1
PWROFF0
Bits 7-2
Unused, Don’t Care Bits
Bits 1-0
PWROFF1: PWROFF0
Power Down Control Bits
00 = Normal Operation
01 = Not Used
10 = Nap Mode
11 = Sleep Mode
相關PDF資料 |
PDF描述 |
|---|---|
| LTC2165IUK#PBF | 1-CH 16-BIT PROPRIETARY METHOD ADC, PARALLEL ACCESS, PQCC48 |
| LTC2164IUK#TRPBF | 1-CH 16-BIT PROPRIETARY METHOD ADC, PARALLEL ACCESS, PQCC48 |
| LTC2165CUK#PBF | 1-CH 16-BIT PROPRIETARY METHOD ADC, PARALLEL ACCESS, PQCC48 |
| LTC2165IUK#TRPBF | 1-CH 16-BIT PROPRIETARY METHOD ADC, PARALLEL ACCESS, PQCC48 |
| LTC2163CUK#PBF | 1-CH 16-BIT PROPRIETARY METHOD ADC, PARALLEL ACCESS, PQCC48 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC2164IUK#PBF | 制造商:Linear Technology 功能描述:IC ADC 16BIT PAR/SRL 105M 48QFN |
| LTC2164IUK#TRPBF | 制造商:Linear Technology 功能描述:IC ADC 16BIT PAR/SRL 105M 48QFN 制造商:Linear Technology 功能描述:MS-ADC/High Speed, 16-bit, 105Msps, 1.8V Low-Power ADC, Parallel Outputs |
| LTC2165CUK#PBF | 制造商:Linear Technology 功能描述:ADC Single 125Msps 16-bit Parallel/Serial (SPI)/LVDS 48-Pin QFN EP 制造商:Linear Technology 功能描述:IC ADC 16BIT PAR/SRL 125M 48QFN 制造商:Linear Technology 功能描述:ADC 16BIT 125MSPS 48QFN 制造商:Linear Technology 功能描述:ADC, 16BIT, 125MSPS, 48QFN |
| LTC2165CUK#TRPBF | 制造商:Linear Technology 功能描述:ADC Single 125Msps 16-bit Parallel/Serial (SPI)/LVDS 48-Pin QFN EP T/R 制造商:Linear Technology 功能描述:IC ADC 16BIT PAR/SRL 125M 48QFN |
| LTC2165IUK#PBF | 制造商:Linear Technology 功能描述:IC ADC 16BIT PAR/SRL 125M 48QFN |
發布緊急采購，3分鐘左右您將得到回復。