參數資料
型號： LTC2140CUP-14#PBF
廠商： Linear Technology
文件頁數： 17/38頁
文件大?。?/td> 0K
描述： IC ADC DUAL 14BIT 25 MSPS 64-QFN
標準包裝： 40
位數： 14
采樣率（每秒）： 25M
數據接口： 并聯，串行，SPI
轉換器數目： 2
功率耗散（最大）： 202mW
電壓電源： 模擬和數字
工作溫度： 0°C ~ 70°C
安裝類型： 表面貼裝
封裝/外殼： 64-WFQFN 裸露焊盤
供應商設備封裝： 64-QFN（9x9）
包裝： 管件
輸入數目和類型： 2 個差分
配用： DC890B-ND - BOARD USB DATA COLLECTION
LTC2142-14/
LTC2141-14/LTC2140-14
24
21421014fa
APPLICATIONS INFORMATION
Full Rate CMOS Mode
In full rate CMOS mode the data outputs (D1_0 to D1_13
and D2_0 to D2_13), overflow (OF2, OF1), and the data
output clocks (CLKOUT+, CLKOUT–) have CMOS output
levels. The outputs are powered by OVDD and OGND which
are isolated from the A/D core power and ground. OVDD
can range from 1.1V to 1.9V, allowing 1.2V through 1.8V
CMOS logic outputs.
For good performance, the digital outputs should drive
minimal capacitive loads. If the load capacitance is larger
than 10pF a digital buffer should be used.
Double Data Rate CMOS Mode
In double data rate CMOS mode, two data bits are
multiplexed and output on each data pin. This reduces
the number of digital lines by fifteen, simplifying board
routing and reducing the number of input pins needed
to receive the data. The data outputs (D1_0_1, D1_2_3,
D1_4_5,D1_6_7,D1_8_9,D1_10_11,D1_12_13,D2_0_1,
D2_2_3, D2_4_5, D2_6_7, D2_8_9, D2_10_11,
D2_12_13), overflow (OF2_1), and the data output clocks
(CLKOUT+, CLKOUT–) have CMOS output levels. The out-
puts are powered by OVDD and OGND which are isolated
from the A/D core power and ground. OVDD can range
from 1.1V to 1.9V, allowing 1.2V through 1.8V CMOS logic
outputs. Note that the overflow for both ADC channels is
multiplexed onto the OF2_1 pin.
For good performance, the digital outputs should drive
minimal capacitive loads. If the load capacitance is larger
than 10pF a digital buffer should be used.
Double Data Rate LVDS Mode
In double data rate LVDS mode, two data bits are multi-
plexed and output on each differential output pair. There
are seven LVDS output pairs per ADC channel (D1_0_1+/
D1_0_1– through D1_12_13+/D1_12_13– and D2_0_1+/
D2_0_1– through D2_12_13+/D2_12_13–) for the digital
output data. Overflow (OF2_1+/OF2_1–) and the data
output clock (CLKOUT+/CLKOUT–) each have an LVDS
output pair. Note that the overflow for both ADC channels
is multiplexed onto the OF2_1+/OF2_1– output pair.
By default the outputs are standard LVDS levels: 3.5mA
output current and a 1.25V output common mode volt-
age. An external 100Ω differential termination resistor
is required for each LVDS output pair. The termination
resistors should be located as close as possible to the
LVDS receiver.
The outputs are powered by OVDD and OGND which are
isolated from the A/D core power and ground. In LVDS
mode, OVDD must be 1.8V.
Programmable LVDS Output Current
In LVDS mode, the default output driver current is 3.5mA.
This current can be adjusted by serially programming mode
control register A3. Available current levels are 1.75mA,
2.1mA, 2.5mA, 3mA, 3.5mA, 4mA and 4.5mA.
Optional LVDS Driver Internal Termination
In most cases, using just an external 100Ω termination
resistor will give excellent LVDS signal integrity. In addi-
tion, an optional internal 100Ω termination resistor can
be enabled by serially programming mode control register
A3. The internal termination helps absorb any reflections
caused by imperfect termination at the receiver. When the
internal termination is enabled, the output driver current
is doubled to maintain the same output voltage swing.
Overflow Bit
The overflow output bit outputs a logic high when the analog
input is either overranged or underranged. The overflow
bit has the same pipeline latency as the data bits. In full
rate CMOS mode each ADC channel has its own overflow
pin (OF1 for channel 1, OF2 for channel 2). In DDR CMOS
or DDR LVDS mode the overflow for both ADC channels
is multiplexed onto the OF2_1 output.
相關PDF資料
PDF描述
MS3102E28-9S CONN RCPT 12POS BOX MNT W/SCKT
UTS6JC124S CONN PLUG CABLE 4X1.6 FEMALE
AD7572AJNZ03 IC ADC 12BIT HS LC2MOS 24DIP
MS3101F12S-3SW CONN RCPT 2POS FREE HNG W/SCKT
LTC2376IDE-18#PBF IC ADC 18BIT 250KSPS 16-DFN
相關代理商/技術參數
參數描述
LTC2140IUP-12#PBF 功能描述:IC ADC DUAL 12BIT 25MSPS 64-QFN RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:12 采樣率（每秒）:300k 數據接口:并聯 轉換器數目:1 功率耗散（最大）:75mW 電壓電源:單電源 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:24-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:24-SOIC 包裝:帶卷 (TR) 輸入數目和類型:1 個單端，單極；1 個單端，雙極
LTC2140IUP-12#TRPBF 功能描述:IC ADC DUAL 12BIT 25MSPS 64-QFN RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:12 采樣率（每秒）:300k 數據接口:并聯 轉換器數目:1 功率耗散（最大）:75mW 電壓電源:單電源 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:24-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:24-SOIC 包裝:帶卷 (TR) 輸入數目和類型:1 個單端，單極；1 個單端，雙極
LTC2140IUP-14#PBF 功能描述:IC ADC DUAL 14BIT 25 MSPS 64-QFN RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1 系列:- 位數:14 采樣率（每秒）:83k 數據接口:串行，并聯 轉換器數目:1 功率耗散（最大）:95mW 電壓電源:雙 ± 工作溫度:0°C ~ 70°C 安裝類型:通孔 封裝/外殼:28-DIP（0.600"，15.24mm） 供應商設備封裝:28-PDIP 包裝:管件 輸入數目和類型:1 個單端，雙極
LTC2140IUP-14#TRPBF 功能描述:IC ADC DUAL 14BIT 25 MSPS 64-QFN RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1 系列:- 位數:14 采樣率（每秒）:83k 數據接口:串行，并聯 轉換器數目:1 功率耗散（最大）:95mW 電壓電源:雙 ± 工作溫度:0°C ~ 70°C 安裝類型:通孔 封裝/外殼:28-DIP（0.600"，15.24mm） 供應商設備封裝:28-PDIP 包裝:管件 輸入數目和類型:1 個單端，雙極
LTC2141-14 制造商:LINER 制造商全稱:Linear Technology 功能描述:12-Bit, 65Msps/ 40Msps/25Msps Low Power Dual ADCs
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*