- 您現在的位置：買賣IC網 > PDF目錄10292 > LTC1852CFW#TRPBF (Linear Technology)IC A/D CONV 8CH 10BIT 48-TSSOP PDF資料下載
參數資料
| 型號： | LTC1852CFW#TRPBF |
| 廠商： | Linear Technology |
| 文件頁數： | 4/24頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC A/D CONV 8CH 10BIT 48-TSSOP |
| 標準包裝： | 1,800 |
| 位數： | 10 |
| 采樣率（每秒）： | 400k |
| 數據接口： | 并聯 |
| 轉換器數目： | 1 |
| 功率耗散（最大）： | 15mW |
| 電壓電源： | 單電源 |
| 工作溫度： | 0°C ~ 70°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 48-TFSOP（0.240"，6.10mm 寬） |
| 供應商設備封裝： | 48-TSSOP |
| 包裝： | 帶卷 (TR) |
| 輸入數目和類型： | 8 個單端，單極；8 個單端，雙極；4 個差分，單極；4 個差分，雙極 |
第1頁第2頁第3頁當前第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁
LTC1852/LTC1853
12
18523fa
The LTC1852/LTC1853 have a unique differential sample-
and-hold circuit that allows rail-to-rail inputs. The ADC will
always convert the difference of the “+” and “–” inputs
independent of the common mode voltage. The common
mode rejection holds up to high frequencies. The only
requirement is that both inputs can not exceed the AVDD
power supply voltage or ground. When a bipolar input
span is selected the “+” input can swing ± full scale rela-
tive to the “–” input but neither input can exceed AVDD or
go below ground.
Integral nonlinearity errors (INL) and differential nonlin-
earity errors (DNL) are independent of the common mode
voltage, however, the bipolar offset will vary. The change
in bipolar offset is typically less than 0.1% of the common
mode voltage.
Some AC applications may have their performance limited
by distortion. Most circuits exhibit higher distortion when
signals approach the supply or ground. THD will degrade
as the inputs approach either power supply rail. Distor-
tion can be reduced by reducing the signal amplitude
and keeping the common mode voltage at approximately
midsupply.
Driving the Analog Inputs
The inputs of the LTC1852/LTC1853 are easy to drive. Each
of the analog inputs can be used as a single-ended input
relative to the input common pin (CH0-COM, CH1-COM,
etc.) or in pairs (CH0 and CH1, CH2 and CH3, CH4 and
CH5, CH6 and CH7) for differential inputs. Regardless
of the MUX conguration, the “+” and “–” inputs are
sampled at the same instant. Any unwanted signal that is
common mode to both inputs will be reduced by the com-
mon mode rejection of the sample-and-hold circuit. The
inputs draw only one small current spike while charging
the sample-and-hold capacitors at the end of conversion.
During conversion, the analog inputs draw only a small
leakage current. If the source impedance of the driving
circuit is low, then the LTC1852/LTC1853 inputs can be
driven directly. As source impedance increases, so will
acquisition time. For minimum acquisition time with high
source impedance, a buffer amplier should be used. The
only requirement is that the amplier driving the analog
input(s) must settle after the small current spike before
the next conversion starts (settling time must be less than
150ns for full throughput rate).
Choosing an Input Amplier
Choosing an input amplier is easy if a few requirements
are taken into consideration. First, to limit the magnitude
of the voltage spike seen by the amplier from charging
the sampling capacitor, choose an amplier that has a low
output impedance (<100Ω) at the closed-loop bandwidth
frequency. For example, if an amplier is used in a gain
of +1 and has a unity-gain bandwidth of 50MHz, then the
output impedance at 50MHz should be less than 100Ω.
The second requirement is that the closed-loop bandwidth
must be greater than 10MHz to ensure adequate small-
signal settling for full throughput rate. The following list
is a summary of the op amps that are suitable for driving
the LTC1852/LTC1853, more detailed information is avail-
able in the Linear Technology Databooks, the LinearView
CD-ROM and on our web site at www.linear-tech.com.
LT1360:
50MHz Voltage Feedback Amplier. ± 2.5V to
±15V supplies. 5mA supply current. Low distortion.
LT1363: 70MHz Voltage Feedback Amplier. ± 2.5V to ±15V
supplies. 7.5mA supply current. Low distortion.
LT1364/LT1365: Dual and Quad 70MHz Voltage Feedback
Ampliers. ±2.5V to ±15V supplies. 7.5mA supply current
per amplier. Low distortion.
LT1468/LT1469: Single and Dual 90MHz Voltage Feedback
Amplier. ± 5V to ±15V supplies. 7mA supply current per
amplier. Lowest noise and low distortion.
LT1630/LT1631: Dual and Quad 30MHz Rail-to-Rail Volt-
age Feedback Ampliers. Single 3V to ±15V supplies.
3.5mA supply current per amplier. Low noise and low
distortion.
LT1632/LT1633: Dual and Quad 45MHz Rail-to-Rail Voltage
Feedback Ampliers. Single 3V to ±15V supplies. 4.3mA
supply current per amplier. Low distortion.
LT1806/LT1807: Single and Dual 325MHz Rail-to-Rail
Voltage Feedback Amplier. Single 3V to ± 5V supplies.
13mA supply current. Lowest distortion.
LinearView is a trademark of Linear Technology Corporation.
APPLICATIONS INFORMATION
相關PDF資料 |
PDF描述 |
|---|---|
| VE-20J-MX-S | CONVERTER MOD DC/DC 36V 75W |
| LTC1850CFW#TR | IC ADC 10BIT 1.25MSPS 48-TSSOP |
| MS3100C32-7P | CONN RCPT 35POS WALL MNT W/PINS |
| VE-20H-MX-S | CONVERTER MOD DC/DC 52V 75W |
| LTC1852CFW#TR | IC A/D CONV 8CH 10BIT 48-TSSOP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC1852IFW | 功能描述:IC A/D CONV 8CH 10BIT 48-TSSOP RoHS:否 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:16 采樣率（每秒）:45k 數據接口:串行 轉換器數目:2 功率耗散（最大）:315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端，單極 |
| LTC1852IFW#PBF | 功能描述:IC A/D CONV 8CH 10BIT 48-TSSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:16 采樣率（每秒）:45k 數據接口:串行 轉換器數目:2 功率耗散（最大）:315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端，單極 |
| LTC1852IFW#TR | 功能描述:IC A/D CONV 8CH 10BIT 48-TSSOP RoHS:否 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:16 采樣率（每秒）:45k 數據接口:串行 轉換器數目:2 功率耗散（最大）:315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端，單極 |
| LTC1852IFW#TRPBF | 功能描述:IC A/D CONV 8CH 10BIT 48-TSSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:16 采樣率（每秒）:45k 數據接口:串行 轉換器數目:2 功率耗散（最大）:315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端，單極 |
| LTC1853CFW | 功能描述:IC A/D CONV 8CH 12BIT 48-TSSOP RoHS:否 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:16 采樣率（每秒）:45k 數據接口:串行 轉換器數目:2 功率耗散（最大）:315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端，單極 |
發布緊急采購，3分鐘左右您將得到回復。