- 您現在的位置：買賣IC網 > PDF目錄377764 > LTC1844ES5-1.8 (LINEAR TECHNOLOGY CORP) 150mA, Micropower, Low Noise, VLDO Linear Regulator PDF資料下載
參數資料
| 型號： | LTC1844ES5-1.8 |
| 廠商： | LINEAR TECHNOLOGY CORP |
| 元件分類： | 基準電壓源/電流源 |
| 英文描述： | 150mA, Micropower, Low Noise, VLDO Linear Regulator |
| 中文描述： | 1.8 V FIXED POSITIVE LDO REGULATOR, 0.3 V DROPOUT, PDSO5 |
| 封裝： | PLASTIC, MO-193, THIN, SOT-23, 5 PIN |
| 文件頁數： | 5/12頁 |
| 文件大?。?/td> | 209K |
| 代理商： | LTC1844ES5-1.8 |
5
LTC1844 Series
1844ia
IN
(Pin 1):
Power for LTC1844 and Load. Power is supplied
to the device through the IN pin. The IN pin should be
locally bypassed to ground if the LTC1844 is more than a
few inches away from another source of bulk capacitance.
In general, the output impedance of a battery rises with
frequency, so it is usually adviseable to include an input
bypass capacitor in battery-powered circuits. A capacitor
in the range of 0.1
μ
F to 1
μ
F is usually sufficient. The
LTC1844 is designed to withstand reverse voltages on the
IN pin with respect to both ground and the output pin. In
the case of a reversed input, which can happen if a battery
is plugged in backwards, the LTC1844 will act as if there
is a large resistor in series with its input with only a small
amount of current flow.
GND (Pin 2):
Ground and Heat Sink. Solder to a ground
plane or large pad to maximize heat dissipation.
SHDN (Pin 3, Fixed and SD Devices):
Shutdown, Active
Low. This pin is used to put the LTC1844 into shutdown.
The SHDN pin current is typically less than 10nA. The
SHDN pin cannot be left floating and must be tied to the
input pin if not used. If reverse-battery protection is
desired, the SHDN pin must be tied to the input pin through
a large value resistor (10k
to
1M).
PIU
ADJ (Pin 4, Adjustable Devices):
Output Adjust. For the
adjustable versions of the LTC1844, this is the input to the
error amplifier. It has a typical bias current of 30nA flowing
into the pin. The ADJ pin reference voltage is 1.25V
referenced to ground. The output voltage range is 1.25V to
6V and is typically set by connecting ADJ to a resistor
divider from OUT to GND. See Figure 2.
BYP (Pin 4, Fixed/Pin 3, BYP Devices):
Noise Bypass.
The BYP pin is used to augment the internal noise filter to
improve low noise performance. A small low leakage
bypass capacitor from this pin to ground will filter the input
of the error amplifier to lower the output voltage noise.
Any value may be used; larger values will result in lower
output noise, but will increase initial power-up time.
Shutdown exit delay time after a brief shutdown (<10ms)
will not be affected. If not used, this pin must be left
unconnected.
OUT (Pin 5):
Voltage Regulated Output. The OUT pin
supplies power to the load. A minimum output capacitor of
1
μ
F is required to ensure stability. Larger output capacitors
may be required for applications with large transient loads
to limit peak voltage transients. See the Applications
Information section for more information on output
capacitance.
相關PDF資料 |
PDF描述 |
|---|---|
| LTC1844ES5-2.5 | 150mA, Micropower, Low Noise, VLDO Linear Regulator |
| LTC1844ES5-2.8 | 150mA, Micropower, Low Noise, VLDO Linear Regulator |
| LTC1844ES5-3.3 | 150mA, Micropower, Low Noise, VLDO Linear Regulator |
| LTC1844ES5-BYP | 150mA, Micropower, Low Noise, VLDO Linear Regulator |
| LTC1844ES5-SD | 150mA, Micropower, Low Noise, VLDO Linear Regulator |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC1844ES5-2.5 | 制造商:Linear Technology 功能描述:LDO Regulator Pos 2.5V 0.15A 5-Pin TSOT-23 |
| LTC1844ES5-2.5#PBF | 制造商:Linear Technology 功能描述:LDO Regulator Pos 2.5V 0.15A 5-Pin TSOT-23 制造商:Linear Technology 功能描述:LDO FIXED 2.5V 150mA TSOT-23-5 制造商:Linear Technology 功能描述:LDO, FIXED, 2.5V, 150mA, TSOT-23-5 制造商:Linear Technology 功能描述:LDO, FIXED, 2.5V, 150mA, TSOT-23-5, Input Voltage Min:1.6V, Input Voltage Max:6. 制造商:Linear Technology 功能描述:LDO, FIXED, 2.5V, 150mA, TSOT-23-5, Input Voltage Min:1.6V, Input Voltage Max:6.5V, Output Current:150mA, Dropout Voltage Vdo:135mV, No. of Pins:5, Operating Temperature Min:-40C, Operating Temperature Max:125C , RoHS Compliant: Yes |
| LTC1844ES5-2.5#TR | 功能描述:IC REG LDO 2.5V .15A TSOT23-5 RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - 線性 系列:- 標準包裝:1 系列:- 穩壓器拓撲結構:正，固定式 輸出電壓:3.3V 輸入電壓:2.5 V ~ 5.5 V 電壓 - 壓降（標準）:0.1V @ 200mA 穩壓器數量:2 電流 - 輸出:300mA 電流 - 限制（最?。?350mA 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-UFQFN 供應商設備封裝:8-MLPQ-UT（1.5x1.5） 包裝:剪切帶 (CT) 產品目錄頁面:1358 (CN2011-ZH PDF) 其它名稱:SC560HULCT |
| LTC1844ES5-2.5#TRM | 功能描述:IC REG LDO 2.5V .15A TSOT23-5 RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - 線性 系列:- 標準包裝:1 系列:- 穩壓器拓撲結構:正，固定式 輸出電壓:3.3V 輸入電壓:2.5 V ~ 5.5 V 電壓 - 壓降（標準）:0.1V @ 200mA 穩壓器數量:2 電流 - 輸出:300mA 電流 - 限制（最?。?350mA 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-UFQFN 供應商設備封裝:8-MLPQ-UT（1.5x1.5） 包裝:剪切帶 (CT) 產品目錄頁面:1358 (CN2011-ZH PDF) 其它名稱:SC560HULCT |
| LTC1844ES5-2.5#TRMPBF | 功能描述:IC REG LDO 2.5V .15A TSOT23-5 RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - 線性 系列:- 產品培訓模塊:MIC5365/66 Ultra-small LDO Regulators 標準包裝:1 系列:- 穩壓器拓撲結構:正，固定式 輸出電壓:3V 輸入電壓:最高 5.5V 電壓 - 壓降（標準）:0.155V @ 150mA 穩壓器數量:1 電流 - 輸出:150mA 電流 - 限制（最?。?200mA 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:4-UDFN 裸露焊盤，4-TMLF? 供應商設備封裝:4-TMLF?（1x1） 包裝:Digi-Reel® 其它名稱:576-3192-6 |
發布緊急采購，3分鐘左右您將得到回復。